Monoprice 36377 Bedienungsanleitung

Commercial Audio

Metro Wall Mount 6.5-inch 2-way 70V/100V Speaker

P/N 36377

User's Manual

SAFETY WARNINGS AND GUIDELINES

Please read this entire manual before using this device, paying extra attention to these

safety warnings and guidelines. Please keep this manual in a safe place for future

reference.

This speaker is intended for indoor use only. Do not expose this speaker to water

or moisture of any kind.

Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or

detergents. For stubborn deposits, moisten the cloth with warm water.

This speaker has no user serviceable parts. Do not attempt to open, service, or

modify this device.

INTRODUCTION

Thank you for purchasing this Metro Wall Mount Speaker! We understand that a

commercial sound system needs to be articulate and able to run 24/7. We also know

that speakers should look good or blend into their environment. These Metro wall

speakers do it all. They sound great for the spoken word or light background music

(BGM) and have a minimal aesthetic that will not distract from the décor.

The unique up-firing tweeter to a down-firing baffle and down-firing woofer allows

installers to keep sound where it needs to go, off the walls and ceilings, minimizing

reflections that cause phase and modulation that require more EQ and DSP. The 90°

horizontal coverage gives these Metro wall speakers flexibility for mounting in several

configurations. Simply mount a single unit to the wall for basic coverage or mount two

side-by-side for full 180° coverage. Use the optional Quad Hanging Bracket (P/N 36378)

to hang four in a center cluster for 360° of sound.

FEATURES

70V/100V constant voltage speaker rated for 13 and 25 watts

Up to 104dB ±2dB sound pressure level

60 Hz ~ 20 kHz frequency response

CUSTOMER SERVICE

The Monoprice Customer Service department is dedicated to ensuring that your

ordering, purchasing, and delivery experience is second to none. If you have any

problem with your order, please give us an opportunity to make it right. You can

contact a Monoprice Customer Service representative through the Live Chat link on our

website www.monoprice.com or via email at su[email protected]. Check the

website for support times and links.

PACKAGE CONTENTS

Please take an inventory of the package contents to ensure you have all the items listed

below. If anything is missing or damaged, please contact Monoprice Customer Service

for a replacement.

1x Metro wall mount speaker with attached mounting bracket

1x User's manual

CONSTANT VOLTAGE VS 8-OHM SPEAKER SYSTEMS

A constant voltage speaker system differs from a traditional 8-ohm speaker system in

that it uses a step-up transformer at the audio source to raise the voltage and lower the

current on the transmission line. At the speaker end, a step-down transformer converts

the signal back to a normal speaker level voltage. This reduces power loss during

transmission, which allows for the use of longer speaker wire runs using smaller gauge

wire.

Additionally, a constant voltage speaker system allows for the use of multiple speakers

on each channel, without the need for complicated impedance calculations and

configurations. In a constant voltage system, all speakers on a given channel are

connected in parallel and the complicated impedance calculations are replaced by

simple wattage calculations.

For example, if you want to connect two speakers per channel in a traditional 8-ohm

speaker system, you must either connect them in series, which results in an overall 16-

ohm impedance, or in parallel, which results in an overall 4-ohm impedance. In the first

case, the 16-ohms impedance effectively halves the output power of your amplifier,

resulting in lower overall volume levels. In the latter case, the 4-ohms impedance means

that your amplifier will have to work harder and must be rated as stable at 4 ohms.

Adding a third speaker to the mix would complicate it further, producing either a 24-

ohm or 2.67-ohm overall impedance. Note that very few amplifiers are stable under 2-

ohm loads, so that is usually not an option.

On the other hand, with a constant voltage system, you consider first the RMS output

wattage of the amplifier. This should be reduced by 20% to compensate for insertion

loss. For example, if using a 100-watt amplifier, the total load from speakers should not

exceed 80 watts.

Each individual speaker on a given channel is set to a value such that the total does not

exceed the rated power, less 20%. You do not need to worry about making the total as

close as possible to the limit; just ensure that the total does not exceed the limit.

If all speakers are set to the same wattage value, they will all have the same volume

level. If one speaker is set to a higher wattage value, it will be louder than the others,

while a speaker set to a smaller value will be quieter than the others. This allows you to

compensate for the environment in which the speaker is placed. For example, a speaker

placed outside would need to be louder than a speaker placed in a small room.

SPEAKER WIRING

Most constant voltage speaker installations will consist of

multiple speakers per channel, with all speakers connected

in parallel, as shown in the diagram to the right.

To wire speakers in parallel, connect the first speaker to the

amplifier as normal. Connect the positive terminal on the

first speaker to the positive terminal of the second speaker,

and the negative terminal on the first speaker to the

negative terminal on the second. Repeat for each additional

speaker in the array.

INSTALLATION

Perform the following steps to mount the speaker to a wall.

1. Unscrew the two caps at the bottom of the speaker.

2. Remove the back panel bracket from the speaker box.

3. Use the image below as a guide for which mounting holes to use for the

installation. Use a pencil to mark the hole locations on the wall.

4. Using an appropriately sized and type of drill bit for the type of wall, drill pilot

holes into the wall.

5. If mounting to a drywall surface, insert wall anchors (not included) into the pilot

holes.

6. Using appropriately sized and type of screws (not included), mount the bracket

to the wall.

7. Attach the speaker to the bracket, then tighten the screw caps removed in step

1 to secure the speaker to the bracket.

8. Using 2-conductor speaker wire (not included) to connect the speaker to other

speakers in the system and to the amplifier. Refer to the following table to

determine which leads to connect for the two voltage and wattage ratings.

Refer to the

CONSTANT VOLTAGE VS 8-OHM SPEAKER SYSTEMS

and

SPEAKER

WIRING

sections above for help in determining which values to use.

Power Terminals

Constant Voltage Level

70V

100V

Red and Blue

13 watts

25 watts

Red and White

25 watts

N/A

TECHNICAL SUPPORT

Monoprice is pleased to provide free, live, online technical support to assist you with

any questions you may have about installation, setup, troubleshooting, or product

recommendations. If you ever need assistance with your new product, please come

online to talk to one of our friendly and knowledgeable Tech Support Associates.

Technical support is available through the online chat button on our website

www.monoprice.com or through email by sending a message to [email protected]om.

Check the website for support times and links.

SPECIFICATIONS

Model

36377

Tweeter Driver Size

Woofer Driver Size

6.5"

Frequency Response

60 Hz ~ 20 kHz

Maximum Sound Pressure Level

104dB ±2dB

Sensitivity

90dB ±2dB

Coverage

90° x 60° down-firing

Dimensions

13.2" x 6.3" x 5.4" (335 x 160 x 136 mm)

Weight

7.1 lbs. (3.2 kg)

REGULATORY COMPLIANCE

Notice for FCC

This device complies with Part 15 of the FCC rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Modifying the equipment without Monoprice's authorization may result in the

equipment no longer complying with FCC requirements for Class A digital devices. In

that event, your right to use the equipment may be limited by FCC regulations, and you

may be required to correct any interference to radio or television communications at

your own expense.

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a commercial installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause

harmful interference, in which case the user will be required to correct the interference

at his own expense.

Notice for Industry Canada

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Inhaltsverzeichnis

Andere Monoprice Sprecher Handbücher

Monoprice

Monoprice 41841 Bedienungsanleitung

Monoprice

Monoprice 33828 Bedienungsanleitung

Monoprice

Monoprice Harmony Capsule 100 Bedienungsanleitung

Monoprice

Monoprice 14887 Bedienungsanleitung

Monoprice

Monoprice 34197 Bedienungsanleitung

Monoprice

Monoprice MM-5 Bedienungsanleitung

Monoprice

Monoprice Harmony Capsule 300 Bedienungsanleitung

Monoprice

Monoprice PID 11427 Bedienungsanleitung

Monoprice

Monoprice PID 13271 Bedienungsanleitung

Monoprice

Monoprice 7495 Bedienungsanleitung

Monoprice

Monoprice 14889 Bedienungsanleitung

Monoprice

Monoprice 35521 Bedienungsanleitung

Monoprice

Monoprice DT-5BT Bedienungsanleitung

Monoprice

Monoprice 24760 Bedienungsanleitung

Monoprice

Monoprice 10951 Bedienungsanleitung

Monoprice

Monoprice 13264 Bedienungsanleitung

Monoprice

Monoprice 43249 Bedienungsanleitung

Monoprice

Monoprice HarmonyMini Bedienungsanleitung

Monoprice

Monoprice 16220 Bedienungsanleitung

Monoprice

Monoprice Pro Audio Series Bedienungsanleitung

Monoprice

Monoprice 43247 Bedienungsanleitung

Monoprice

Monoprice Harmony XL Bedienungsanleitung

Monoprice

Monoprice Soundstage 3 Bedienungsanleitung

Monoprice

Monoprice 11948 Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung