USER MANUAL 8
3.2. RESIDUAL RISKS
Although the EvoDrive+ automatic door operator has been designed and manufactured to ensure a safe
operation, some residual risks may still persist even after adopting complementary measures of protection.
Automatic sliding doors may have some risks of crush, impact, entrapments and other potential hazzards.
Depending on the structural conditions on site, the door version and the safety equipment, these risks may not
disappear completely.
In accordance with the European norm EN16361, the travelling area where the leaf of an automatic door is
sliding should have some type or protection, to reduce the risk of impact to persons as much as possible. To
limit these risks of the EvoDrive+ door operator, the following safety measures should be considered and
implemented:
The possibility of using safety sensors to detect the movement and presence of people and/or objects
within the travelling area.
“Low energy” mode: subject to the width and mass of the door leaf, its speed is reduced and adjusted
to a predened value during the closing cycle, to ensure that the kinetic energy of the door leaf and the
impact force do not exceed those admitted in the said norm.
To ensure a high level of safety, mainly in those installation sites where the presence of groups of
risks recommends the adoption of additional safety measures, the EvoDrive+ automatic door
operator allows the simultaneous implementation of the two above mentioned safety measures.
A qualied technician should verify the correct installation, commissioning, adjustment and operation of the
safety sensors and/or the “low energy” mode, always in accordance, but not limited to the above mentioned
norm.
4. TROUBLESHOOTING
If you think or observe that the door is malfunctioning, check the following recommendations before calling the
after sales service:
The power must be connected: check if the ON/OFF switch is ON.
The operating mode in the remote control is in the correct position. Check if the door moves in
Automatic mode.
The door is not blocked by any object or dirt under the door leaf or within the doorway. In case there is
an obstruction within the door travelling area, remove that obstruction and change the operating mode
to Open and Automatic to resume normal operation.
If these points are in order and the door is still not moving when activated, being the door in Automatic mode,
please contact a service technician.
