If the vehicle has no CAN bus or there is no CAN file available, you must tap turn signal (left and right), brake and speed
signal manually (various locations). Speed sense can be accessed with an optional GPS antenna instead of the SS wire,
this would also be beneficial for location of the vehicle along with recorded video and fleet management
information.
1. With a digital multimeter or test light, locate the brake signal wire that activates when the brake is
pressed (vehicle may need to be ON). Connect and insulate the black/white wire to this vehicle’s
wire. This may be a (+) or (-) signal.
2. With a digital multimeter or test light, locate the left turn signal wire that activates with the left
turn signal. Connect and insulate the blue/white wire to this vehicle’s wire. This may be a (+) or (-)
signal.
3. With a digital multimeter or test light, locate the right turn signal wire that activates with the
right turn signal. Connect and insulate the blue wire to this vehicle’s wire. This may be a (+) or
(-) signal.
4. Locate the VSS wire. Connect and insulate the brown/white wire to this vehicle’s wire.
5. NO other wires are required for typical installation –ground the remaining wires.
MDAS-9 Calibration requires:
-a laptop with an internet connection and a browser (Chrome is best)
-micro-USB cable
-tape measure
-parking the car with a clear, open stretch of about a 50-yard unobstructed view (try to park close to your facility
to keep the internet connection accessible –at least during the calibration driver installation)
-a partner to drive the vehicle while speed correction is performed
•Before beginning, insert the provided micro-SD card into the main
unit in the location shown here (right) until it clicks and turn the
Ignition ON. Wait for the prompt, then press and release the
center button one time. After the successful prompt and the unit
reboots, continue to step 1.
1. Park the vehicle in a spot with a clear stretch of unobstructed line-of-sight (about 50 yards). Leave the vehicle
running.
2. Connect the USB cable to the Mirco-USB port on the side of the main unit
(windshield) and the other end to the laptop. If on a windows 10 machine, it
should automatically install the required driver. If not or on an older
machine, go to movon.co.kr, go to the ‘ADAS’ tab at the top then to
‘Downloads’ under Support. Download the appropriate zip file (contains
driver) and extract it fully for your version of Windows OS (if using the
7/8 driver, install the .exe file). If WIN10, once downloaded,
disconnect/reconnect the USB and it should automatically install, or find the unit
in Device Manager and right-click, Update Driver and browse for driver locally*.
