MultiTable Mod-E Pro Bedienungsanleitung

ASSEMBLY INSTRUCTIONS

MultiTable Mod-E Pro Electric Standing Desk

The Height of Healthy Design®

#10 x 5/8"

Wood Screws (16)

MultiTable Mod-E Pro Electric Standing Desk Frame PARTS AND TOOLS

frame, small or standard

Small Standard

#10 x 5/8"

Wood Screws (12)

Small Frame Screws & Brackets

Standard Frame Screws

#10 x 5/8"

Wood Screws (2) (8)

ASSEMBLY MultiTable Mod-E Pro Electric Standing Desk Frame

With the table top facing down on a soft, clean surface, arrange the frame as shown below, with the short ends of the top supports toward the rear.

• Position the frame side to side.

— Loosen all eight set screws (if necessary) using the 5mm Allen key. Expand or compress he frame so that the top supports are aligned with the

pre-drilled holes. Center the middle portion of the cross channels, the tighten the eight set screws.

• Position the frame font to back.

— With tables that are 24.0" deep, position the rear cross channel 6.5" from the rear edge of the table. With 29" tables, position the rear cross channel 9.5"

from the rear edge of the table. These positions of the frame will align the rear of the feet to the rear of the table when the feet are installed in step 4.

• Use the #10 x 5/8" wood screws. The small frame requires 16 screws (eight for the frame abd eight for U-brackets) and the standard frame requires 12 screws.

• Withthe small frame, position the U-brackets between the set screws. The U-brackets take the place of the cross supports on the standard frame.

9.5" with 29" table foot for

29" table

#10 x 5/8"

Wood Screws

Standard frame

cross support

(Standard frame only)

U-bracket

(Small frame only)