STEP 6:
SI-198 (09-20)
STRAINER‡
SHOWER FLOOR
SUB-FLOOR
DRAIN SEAL-PN 32.401†
(SUPPLIED)
2" PVC, ABS, OR IRON WASTE PIPE
Installing Drain Seal - Apply liquid soap to the inside and outside of Drain Seal. Place Drain Seal over waste
pipe and push into drain cup. Using a hammer and 1/4" dia. dowel rod, tamp Drain Seal into place.
Top of Drain Seal should be even with the top of the waste pipe when fully installed.
Press Strainer into place.
† Optional DRAIN SEALS are available:
PN 32.403 - 2" SOIL PIPE/CAST IRON
SERVICE WT. (NO HUB)
PN 32.404 - 2" COPPER PIPE, TYPE K, L, or M
PN 32.405 - 1½" PVC, ABS, or IRON PIPE
‡ Optional STRAINERS are available:
PN 34.301 - POLISHED STAINLESS STEEL
PN 42.326 - CHROME PLATED
PN 42.327 - GOLD PLATED
CARE & CLEANING
The surface of your MUSTEE SHOWER FLOOR may be cleaned with a mild soap solution in warm water using a soft cloth. When using s cleaner product,
carefully read the label to ensure that the cleaner is safe for use on the material. Stubborn stains can be cleaned using “Soft Scrub ” by Clorox or a
powdered detergent such as “Spic-n-Span ”. Do not allow cleaners to sit or soak on the surface. Wipe surface clean and rinse completely with water
immediately after cleaner application. Rinse and dry any overspray on nearby surfaces. Never use abrasive scouring powder or steel wool pads, as they
will scratch the surface.
®
®®
INSTALLATION QUESTIONS
Qu
est
io
ns
on
th
e
in
st
al
la
ti
on
or
mi
ssi
ng
parts,
call
216-267-3100
or
email
[email protected] for
assistance.
Please have the installation manual available when calling.
DO NOT RETURN PRODUCT TO THE PLACE OF PURCHASE.
TYPICAL WALL INSTALLATION
SHOWER FLOOR
SUB-FLOOR
BEDDING
1/8" GAP
CAULK
GREENBOARD/DRYWALL
CEMENT BOARD/BACKER BOARD
(½" Thick Min.)
FINISHED WALL
1/8" GAP
TILE / SOLID SURFACE OR GLUED-ON
WALL PANEL INSTALLATION DETAIL
