MuxLab 500390 Bedienungsanleitung

8495 Dalton Road, Mount Royal, Quebec, Canada. H4T 1V5

Tel: (514) 905-0588 Fax: (514) 905-0589

Toll Free (North America): (877) 689-5228

E-mail: [email protected] URL: www.muxlab.com

Specifications

Environment DVI 1.0 (Single Channel)

Devices Plasma, projectors, monitors, TV, PC, laptops

Transmission Transparent to the user

Bandwidth 340 MHz

Signals DVI 1.0 protocol

Audio Does not embed or de-embed audio over DVI. Transmits audio in

common mode over UTP and completely isolated from the DVI

signal

Connectors One (1) DVI-D receptacle.

One (1) RJ45S for Cat 5e/6 unshielded or shielded twisted pair.

3.5mm jacks for Analog Stereo Audio

Note: DVI and Audio cables not included.

Maximum Distance

Based on a maximum

length of 6.6 ft (2 m) of

DVI cable per end.

Cat 5e/6: 230 ft (70 m) up to 1920 X 1200

115 ft (35 m) for 4K; 3840 X 2160/24,25,30 Hz

Note: When installed in an electrically noisy environment, an STP cable

must be used. Also, cross-connection reduces the effective distance

depending on the grade of twisted cable used.

RJ45 Pin Configuration

Reverse Polarity

Sensitive. Use EIA/TIA

568A or 586B straight-

through wiring.

RJ45 Link

Pin 1 (R) Pin 2 (T)

Pin 3 (R) Pin 6 (T)

Pin 4 (R) Pin 5 (T)

Pin 7 (R) Pin 8 (T)

Cable One (1) Cat 5e/6 or better twisted pair cables required

Power Supply Two (2) 110-240V/5VDC power supplies with interchangeable blades

Power Consumption Transmitter: 1.6 Watt Receiver: 3.2 Watt

Temperature Operating: 0° to 40°C Storage: -20° to 85°C

Humidity: Up to 95% non-condensing

Enclosure Aluminum

Dimensions 4.50” x 3.00” x 1.25” (11.4 x 7.6 x 3.2 cm)

Weight 2.6 lb (1.2 kg)

Compliance Regulatory: FCC, CE, RoHS Flammability: 94V0

Warranty 2 years

Order Information 500390 DVI/Audio Extender Kit

DVI/Audio Extender Kit

500390

Quick Installation Guide

Overview

The DVI/Audio Extender Kit (500390) allows one DVI channel and one line level

stereo audio audio channel to be transmitted to 230 ft (70 m) at all resolutions up to

1920x1200 via one (1) Cat 5e/6 cable in a point-to-point configuration.

Applications

Applications include commercial and residential AV systems, classroom projector

systems, digital signage, boardroom systems, collaborative PC systems, and medical

information systems.

Installation

1. Identify the connectors on the Transmitter and Receiver as indicated on the

product labels.

2. Verify that the distance between the DVI/Audio Transmitter and Receiver is within

MuxLab specifications.

3. To install the Transmitter:

3a. Connect the Transmitter to the DVI video source with a DVI compliant cable.

3b. Connect the Transmitter to Analog Stereo Audio source with a 3.5mm stereo cable.

3c. Connect one (1) lengths of Cat 5e/6 (or higher) grade UTP cables to

RJ45 LINK connectors on the Transmitter.

4. To install the Receiver:

4a. Connect the Receiver to the DVI display equipment with a DVI compliant cable.

4b. Connect the Receiver to the Analog Stereo Audio equipment with a 3.5mm stereo

cable.

4c. Connect the one (1) Cat 5e/6 cables to RJ45 LINK connectors on the Receiver.

5. Connect the 5 VDC power supply to the Receiver first, and then plug the power

supply into an AC power outlet. Connect the 5 VDC power supply to the

Transmitter first, and then plug the power supply into an AC power outlet. If power

is present, the green power LED of the Transmitter and the Receiver will be ON.

Note: Power the DVI/Audio Extender Balun only after all connections are made.

6. Power the DVI equipment and verify the image quality.

7. The following diagram shows the final configuration.

Troubleshooting

The following table describes some of the symptoms, probable causes and possible solutions

in respect to the installation of the DVI/Audio Extender Kit:

Tx LEDs Rx LEDs

Symptom Power DVI RJ45 Power DVI RJ45

Probable

Cause

Possible

Solutions

No Image OFF OFF OFF OFF OFF OFF No power • Check power

connections

No Image ON OFF OFF ON OFF OFF UTP Cable • Check the UTP

cables.

No Image ON OFF ON ON OFF ON DVI Cable • Check the DVI

Cable.

NoImage ONONONONONONSynchronization • Check cable length.

Flickering

Image

ON ON ON ON ON ON Synchronization • Check cable length

• Check the DVI

Cable Quality.

Choppy sound ON ON ON ON ON ON Synchronization • Check cable length

Green or pink

hue

ON ON ON ON ON ON DDC

communication

• Cycle power of the

DVI/Audio

Extender.

• Check UTP cables

and replace.

Image flickers

when powering

up nearby

equipment

ON ON ON ON ON ON Interference • Use STP cables

If you still cannot diagnose the problem, please call MuxLab Customer Technical Support at

877-689-5228 (toll-free in North America) or (+1) 514-905-0588 (International).

Inhaltsverzeichnis

Andere MuxLab Extender Handbücher

MuxLab

MuxLab 500752 Bedienungsanleitung

MuxLab

MuxLab 500456 Bedienungsanleitung

MuxLab

MuxLab 500070 Bedienungsanleitung

MuxLab

MuxLab 500451-POE Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

MuxLab

MuxLab 500401 Bedienungsanleitung

MuxLab

MuxLab 500768 Bedienungsanleitung

MuxLab

MuxLab 500754 Bedienungsanleitung

MuxLab

MuxLab 500115 Bedienungsanleitung

MuxLab

MuxLab 500465 Bedienungsanleitung

MuxLab

MuxLab 500459-100 Bedienungsanleitung

MuxLab

MuxLab 500462 Bedienungsanleitung

MuxLab

MuxLab 500772 Bedienungsanleitung

MuxLab

MuxLab 500040 Bedienungsanleitung

MuxLab

MuxLab 500114 Bedienungsanleitung

MuxLab

MuxLab 500451-PoE Bedienungsanleitung

MuxLab

MuxLab 500733 Bedienungsanleitung

MuxLab

MuxLab 500402 Bedienungsanleitung

MuxLab

MuxLab 500140 Bedienungsanleitung

MuxLab

MuxLab 500752 Bedienungsanleitung

MuxLab

MuxLab 500409 Bedienungsanleitung

MuxLab

MuxLab ProDigital 500485 Bedienungsanleitung

MuxLab

MuxLab 500753 Bedienungsanleitung

MuxLab

MuxLab 500754 Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung

SECO-LARM

SECO-LARM ENFORCER EVT-PB1-V1TGQ Bedienungsanleitung