Nautel VS2.5 Bedienungsanleitung

VS2.5 Transmitter

Installation Manual

Document:NHB-VS2.5-INS

Issue: 11.0 2019-05-10

Status: Standard

Nautel Limited

10089 Peggy’s Cove Road

Hackett’s Cove, NS Canada B3Z 3J4

Phone: +1.902.823.3900 or

Toll Free: +1.877.6NAUTEL (6628835) (Canada & USA only)

Fax: +1.902.823.3183

Nautel Inc.

201 Target Industrial Circle

Bangor, Maine USA 04401

Phone: +1.207.947.8200

Fax: +1.207.947.3693

Customer Service (24 hour support)

+1.877.628.8353 (Canada & USA only)

+1.902.823.5100 (International)

Email: [email protected]

Web: www.nautel.com

The comparisons and other information provided in this document

have been prepared in good faith based on publicly available

information. The reader is encouraged to consult the respective

manufacturer's most recent published data for verification.

VS2.5 Installation Manual Table of contents

Page v

Contents

Release control record vii

Preparing for installation 1-1

Mounting the transmitter 2-1

Connecting to station reference ground 3-1

Installing the RF feed line 4-1

Connecting ac power 5-1

Installing the ac entrance box 5-3

Installing program inputs 6-1

Planning 6-1

Connecting cables 6-1

Installing control and monitoring wiring 7-1

Planning 7-1

Connecting cables 7-1

Commissioning 8-1

Pre-Commissioning 8-2

Commissioning 8-3

Network Setup 8-7

Changing the OS Password 8-9

VS2.5 Installation Manual Table of contents

Page vi Issue 11.0 2019-05-10

Parts and tools 9-1

Contacting Nautel 9-1

Parts supplied by Nautel 9-2

Parts not supplied by Nautel 9-2

Parts ordering 9-2

Module replacement program 9-3

Tools for installation 9-3

Pre-installation / Installation assistance 10-1

Pre-installation consulting 10-1

Installation and commissioning service 10-1

Online documentation 10-3

On-site support 10-3

Training 10-4

Standard warranty 10-5

Extended warranties 10-8

List of terms 11-1

VS2.5 Installation Manual

Issue 11.0 2019-05-10 Page vii

Release control record

Issue Date Reason

11.0 2019-05-10 Hardware Release 11 (NARF66I/04 and NARF66I/05).

Supports software version VS SW 5.2 and higher.

VS2.5 Installation Manual

Page viii Issue 11.0 2019-05-10

VS2.5 Installation Manual Preparing for installation

Issue 11.0 2019-05-10 Page 1-1

Section 1: Preparing for installation

Before installing your VS2.5 transmitter, perform the following steps:

1. Ensure that you have performed the pre-installation tasks described in the 

VS2.5 Pre-installation Manual.

2. Inspecttheshippingboxfordamage.ReportanydamageimmediatelytoyourNautelsales

representative and the carrier.

3. Unpack the box. Remove all items from packing and place them on a suitable work

area. Check your packing list to make sure that you received all the components,

including the VS2.5, VS2.5 Quick Start Guide, VS2.5 USB device (contains technical

manual set and unpacking/installation video), installation kit and ancillary kit.

4. Assemble your parts and tools. For a list of required tools, see “Parts and tools” on

page 9-1.

5. When you are ready to install the VS2.5 transmitter, follow the steps shown in

Figure 1.1 on page 1-2.

TIP When you have completed a task or step, put a check mark beside the step

number.

Note:



The VS2.5 Quick Start Guide provides a more streamlined method to unpack,

install and commission your transmitter. If you used the Quick Start Guide to

successfully commission your transmitter, Nautel recommends you use the

information in this Installation Manual to verify your installation or for more in-

depth information, as required.

CAUTION: 

FAILURE TO COMPLY WITH RECOMMENDATIONS MAY VOID YOUR MANUFACTURER’S

WARRANTY. FOR MORE INFORMATION, REVIEW YOUR WARRANTY DOCUMENTS.

VS2.5 Installation Manual Preparing for installation

Page 1-2 Issue 11.0 2019-05-10

Figure 1.1: Flowchart - Installing the transmitter

Mounting the transmitter - see page 2-1

Connecting to station reference ground - see page 3-1

Installing control and monitoring wiring - see page 7-1

Commissioning - see page 8-1

Perform operational tasks:

“Commissioning” and “Going On-Air”, beginning on page 8-3

Installing the RF feed line - see page 4-1

Installing program inputs - see page 6-1

Connecting ac power - see page 5-1

Andere Handbücher für VS2.5

Inhaltsverzeichnis

Andere Nautel Sender Handbücher

Nautel

Nautel NX100 Bedienungsanleitung

Nautel

Nautel NX5 Handbuch

Nautel

Nautel J1000 Betriebsanleitung

Nautel

Nautel FM10 Betriebsanleitung

Nautel

Nautel VS300 Bedienungsanleitung

Nautel

Nautel NX10 Bedienungsanleitung

Nautel

Nautel XR12 Bedienungsanleitung

Nautel

Nautel Vector-LP VR125 Betriebsanleitung

Nautel

Nautel NV5 Programmierhandbuch

Nautel

Nautel GV20 Bedienungsanleitung

Nautel

Nautel VS1 Bedienungsanleitung

Nautel

Nautel VS300 Bedienungsanleitung

Nautel

Nautel VS1 Bedienungsanleitung

Nautel

Nautel GV40 Programmierhandbuch

Nautel

Nautel NV10LT Bedienungsanleitung

Nautel

Nautel XR12 Bedienungsanleitung

Nautel

Nautel NV30 Bedienungsanleitung

Nautel

Nautel NV5LT Programmierhandbuch

Nautel

Nautel NX Series Installationsanleitung

Nautel

Nautel XR3 Bedienungsanleitung

Nautel

Nautel VS1 Programmierhandbuch

Nautel

Nautel NV30LT-N Handbuch

Nautel

Nautel VS2.5 Programmierhandbuch

Nautel

Nautel VS1 Bedienungsanleitung

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung