Nauticam 36072 Bedienungsanleitung

INSTRUCTION MANUAL

for O90-F Focus Gear for OM M.Zuiko

Digital ED 90mm f/3.5 Macro IS PRO

PN# 36072

Thank you for your purchase of a NAUTICAM

product.

At NAUTICAM, we pride ourselves in the ability to

recognize the requirements of professional as well

as amateur underwater photographers and fulfill

them through the innovative designs of our

products. We strive to achieve a high level of user-

friendliness by allowing stress-free installation and

easy operation of all important functions of the

camera.

Each product is individually inspected and water

pressure tested to ensure optimum quality.

Please read this manual carefully before using the

product, this will maximize its performance as well

as its lifetime.

FORWORD

Current as of 3/23/2023

All NAUTICAM Products are warranted against

any material and manufacturing defects for two

years from the date of purchase for consumer

use. This warranty only applies to products

purchased from authorized NAUTICAM dealers

and does not extend beyond the original retail

purchaser.

To return your product for service, please contact

your regional authorized service center(s). Please

note that this warranty only applies when the

product is purchased in the territory where the

service center is located.

NAUTICAM does not hold responsibility for

damage, of any nature, to any equipment used

with and/or placed within our products.

NAUTICAM accepts no liability for any loss of

captured images or the inability to capture images

even if it is due to the malfunctioning of our

products.

Unauthorized modifications and/or repairs of our

products will automatically invalidate the

warranty.

WARRANTY

•After installation of the port combo, please

make sure the O-ring (s) are free from debris

and uneven surface issues.

•A water-tight/vacuum test without the camera

inside the housing is highly recommended after

the changing of port and O-ring(s).

•Do not use lubricants from other brands with

the silicone rubber O-ring on this housing, only

use the lubricant provided by NAUTICAM.

•Discontinue use immediately should you notice

any leakage.

•Do not open the product in a wet or sandy

environment. Protect the interior from moisture

and debris in order to prevent malfunction or

leakage.

•Defective products should be shipped to our

distributors for service, unauthorized

disassembling and/or modifications could

result in malfunction or leakage.

•When travelling by air, do not travel with any

port installed as this may lead to a pressure

difference between the atmosphere and inside

the housing.

PRECAUTIONS

PACKAGE CONTENTS

•Make sure that you have all the included items listed below before using this product.

•If some items are missing or damaged, contact your local Nauticam dealer.

Plastic C-ring O90-F Focus Gear

Screw covers Focus Knob

Manual Instruction Card Spare Rubber grips x 6

IDENTIFICATION OF PARTS

Plastic C-ring

O90-F Focus Gear

Focus Knob

Spare Rubber grips x 6

Preparation of the Product

1. After verifying that the sealing O-ring is in good condition, lightly coat it with the lubricant provided and

wipe away the excess.

2. Make sure the O-ring groove is free from any foreign material; the groove can be cleaned with the aid

of a microfiber cloth.

3. Carefully place the port O-ring into the groove, ensuring that it lays flat and inside the entire groove.

4. Inspect the O-ring again, make sure there is no foreign materials.

5. After installing the port, lift up the entire system and inspect where the housing back and port meet the

housing. There should be a thin, uniform gap with no extruded O-ring.

MOUNT THE GEAR ON A LENS

1. Insert the plastic C-ring as shown

and place it over the lens.

2. Insert the O90-F Focus Gear on the plastic C-ring

until it reaches the flange of the plastic C-ring.

3. To remove the O90-F Focus Gear, reverse the

above steps.

The tightness between the O90-F Focus Gear and

the lens can be adjusted by removing or adding

rubber grips on either sides of the plastic C-ring,

spare rubber grips are included in the package.

MOUNT KNOB TO PORT

1. Remove the screw covers and the

screws, then take out the focus knob

plug from the port.

2. Separate the pre-installed knob by

removing the three screws as shown

following step 1 & 2. Then take out the

shaft from the knob sleeve.

3. Insert a focus knob assembly through the hole

of the Macro port

Gently push the focus knob assembly into the

hole until it cannot go in any further

Then Tighten the focus knob on the port by

screwing 2x screws and installing the screw covers.

1 2

MOUNT KNOB TO PORT

1. Mount a shaft on a knob sleeve of the

focus knob as shown

2. Screwing the knob to the knob sleeve

and plug the screw cover.

2. Locking the knob clockwise.

INSTALL THE LENS

1. Make sure the Focus knob and the

Focus Limiter Switch Selector are at

the most outwards position before

installing the lens.

2. Turn the knob both ways to check if

the gear is engaged with camera lens

36072

O90-F Focus Gear

Dimension (mm):

DIA76

x28

ype:

Focus

Gear

Compatible lens:

OM M.Zuiko Digital ED

90mm f/3.5 Macro IS PRO

SPECIFICATIONS

Remark:

Nauticam supports only e-manuals. Please download

corresponding product manuals on google drive

https://bit.ly/Nauticammanual,or contact us for e-

manuals.

CARE AND MAINTENANCE

•Soak the housing system in fresh water after

each use, during which all control buttons/knobs

should be operated a few times to avoid the

accumulation of salt residue; wipe the housing

with a towel before opening.

•After removing the housing from the rinse tank,

carefully press the housing lock safety button for

a few times to avoid the accumulation of salt

residue.

•After each day of diving, it is advisable to have

both the housing main O-ring and port O-ring

removed from its groove with the O-ring remover

and inspected for damage. Also check that the

O-ring retains its original circular shape; never

stretch the O-ring excessively or remove it with a

sharp object. The O-ring groove should be

cleaned to ensure it is free from any salt deposit

or foreign material; lightly coat the O-ring with the

provided lubricant before reinstalling it in the

groove. A damaged O-ring should be discarded

immediately and replaced only with one that is

provided by NAUTICAM.

Please refer to "Nauticam Product Care and

Maintenance Guide" for more details.

Inhaltsverzeichnis

Andere Nauticam Kamerazubehör Handbücher

Nauticam

Nauticam NA-S1H Bedienungsanleitung

Nauticam

Nauticam NA-GH5SV Bedienungsanleitung

Nauticam

Nauticam N85 Bedienungsanleitung

Nauticam

Nauticam NA-a1 Bedienungsanleitung

Nauticam

Nauticam NA-EM5III Bedienungsanleitung

Nauticam

Nauticam NA-R6II Bedienungsanleitung

Nauticam

Nauticam 25107 Bedienungsanleitung

Nauticam

Nauticam NA-R7 Bedienungsanleitung

Nauticam

Nauticam C2870f3.5II-F Bedienungsanleitung

Nauticam

Nauticam O1250-Z Bedienungsanleitung

Nauticam

Nauticam NA-5dsr Bedienungsanleitung

Nauticam

Nauticam 83211 Bedienungsanleitung

Nauticam

Nauticam NA-Ultra5 Housing Bedienungsanleitung

Nauticam

Nauticam 26302 Bedienungsanleitung

Nauticam

Nauticam 21230 Bedienungsanleitung

Nauticam

Nauticam 25101 Bedienungsanleitung

Nauticam

Nauticam NA-LX100II Bedienungsanleitung

Nauticam

Nauticam NA-GX7 Bedienungsanleitung

Nauticam

Nauticam 36207 Bedienungsanleitung

Nauticam

Nauticam 36167 Bedienungsanleitung

Nauticam

Nauticam Atomos shogun Bedienungsanleitung

Nauticam

Nauticam 86221 Bedienungsanleitung

Nauticam

Nauticam 70 Bedienungsanleitung

Nauticam

Nauticam NA-A6300 Bedienungsanleitung

Beliebte Kamerazubehör Handbücher anderer Marken

Viltrox

Viltrox EF-NEX Montageanleitung

Calumet

Calumet 7100 Series CK7114 Bedienungsanleitung

Ropox

Ropox 4Single Series Bedienungsanleitung

Cambo

Cambo Wide DS Digital Series Betriebsanleitung

Samsung

Samsung SHG-120 Bedienungsanleitung

Ryobi

Ryobi BPL-1820 Bedienungsanleitung

Aegis

Aegis ABL-36020P Bedienungsanleitung

Pentax

Pentax Data Back Fc Bedienungsanleitung

Fantasea

Fantasea EyeGrabber F Series Bedienungsanleitung

Honeywell

Honeywell HDZ20HD Bedienungsanleitung

EGO

EGO BA1400T Bedienungsanleitung

Sima

Sima SRW-62 Bedienungsanleitung

Shape

Shape A7SSMKIT Bedienungsanleitung

Slide Kamera

Slide Kamera HST-2 Bedienungsanleitung

Power works

Power works 2902613 Bedienungsanleitung

SES

SES SE-2047-2 Bedienungsanleitung

Olympus

Olympus PT-EP05L Bedienungsanleitung

Starlite

Starlite OctoDome nxt Bedienungsanleitung