NEC NR-9300 Bedienungsanleitung

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Internal CD-R/RW Drive

NR-9300

User's Manual

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Laser Safety Information

This drive employs a laser. Do not remove the cover or attempt to service this device when

connected due to the possibility of eye damage.

CAUTION

Use of control of adjustments or performance of procedures other than those specified

herein may result in hazardous radiation exposure.

This label is located on top enclosure of this drive.

Laser Specification

(for CD)

Type : Semiconductor laser GaAlAs

Wave length : 779 - 789 nm (at 25°C)

Output : Max. 80 mW (Pulse)

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

— Consult the dealer or an experienced radio/TV technician for help.

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital

apparatus as set out in the Radio Interference Regulations of the Canadian Department of

Communications.

LE PRÉSENT APPAREIL NUMÉRIQUE N’ÉMET PAS DE BRUITS RADIOÉLECTRIQUES

DÉPASSANT LES LIMITES APPLICABLES AUX APPAREILS NUMÉRIQUES DE CLASSE

B PRESCRITES DANS LE RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUE

ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU CANADA.

CAUTION

The user who makes changes or modifications to the unit without the express approval by the

manufacturer will void user authority to operate the equipment.

ACHTUNG

Der arbeitsplatzbezogene Geräuschemissionswert dieses Gerätes beträgt ≤70dB (A) nach

EN 27779/1991.

Notice

Only CD discs and DVD discs carrying the label below can be used with this CD-R/RW drive.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

HEED THE FOLLOWING

Read the operating instructions carefully before using the unit and be

sure to use it properly. After reading the instructions, store them in an

easily accessible place so they can be consulted whenever necessary.

WARNING

• Continued use should there be an irregularity (smoke, abnormal

smell or sound, etc.) will lead to fires or electric shocks. If there

should be an irregularity, immediately turn off the power of the

computer on which the unit is installed and request servicing.

• Do not disassemble or modify the unit in any way. Doing so will

lead to fires or electric shocks.

• Make sure that no foreign objects get in the unit, as this will lead

to fires or electric shocks. If a foreign object should get in the

unit, immediately turn off the power of the computer on which

the unit is installed and request servicing.

• Do not let fluids get in the unit or let the unit get wet, as this will

lead to fires or electric shocks. If fluid should get in the unit,

immediately turn off the power of the computer on which the unit

is installed and request servicing.

• Do not use with any power voltage other than the indicated

voltage. Doing so will lead to fires or electric shocks.

• Do not store or use the unit in places where it may be subject to

shocks or strong vibrations. Doing so will lead to fires or electric

shocks.

• Do not store or use the unit in places where it may be exposed to chemicals

or chemical vapors. Doing so will lead to fires or electric shocks.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

CAUTION

• When connecting computer equipment, audio equipment, speakers, etc.,

be sure to read the respective manuals carefully, turn of the power and

follow the connection instructions. Using cords other than the specified

cords or extending cords could generate heat and result in burns, etc.

• Set the volume to the minimum before turning on the power.

Sudden bursts of loud sound could result in hearing impairment.

• Do not store or use the unit in extremely hot places or places where

the humidity fluctuates greatly. Doing so could lead to fires or electric shocks.

• Do not store or use the unit in places exposed to direct sunlight or

near equipment that generates heat. Doing so could lead to fires.

• Do not place the unit on unsteady tables, slanted surfaces or other

unstable surfaces. The unit could fall or tip over, resulting in injury.

• Do not store or use the unit in humid or dusty places. Doing so

could lead to fires or electric shocks.

• Do not store or use the unit with heavy objects or objects that

stick out passed the frame on top of it. The object or unit may

lose its balance and tip over or fall, resulting in injury.

• Do not let stick your hands into the disc insertion slot, as this could

cause injury.

• Do not use cracked or misshapen discs or discs that have been repaired

with adhesives, etc. Discs rotate at high speeds inside the unit. If such discs

are used, they may break and fly out, resulting in injury.

• Do not look directly at the laser source. Exposing the eyes to the

laser beam could result in vision impairment.

• When used near a radio or TV, the unit may generate noise in

the radio or TV. Also, if there is equipment generating strong

magnetic forces nearby, this may generate noise in the unit.

• Keep the disc tray closed except when inserting or removing

discs in order to prevent injury from bumping into the disc tray.

• When disconnecting from computer equipment, wait to remove a couple

of minutes until it gets cold. The enclosure may have some points over 60℃.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Cautions

Cleaning

To clean the CD-R/RW drive, wipe it with a soft, damp cloth, using mild detergent if necessary.

Please avoid using solvents such as benzine or paint thinner.

This can cause color changes or deformation of CD-R/RW drive.

Handling the Disc

• Do not touch the data side of the disc (the side of the disc with no label or printing).

• Do not apply paper labels or write on any part of the disc, data side or label side.

Do not use the disc leaved a mark strip paper labels.

• If dust or fingerprints get on the disc, wipe it with a soft cloth from the

center to the edge.

• Do not use benzine, paint thinner, record cleaner, or static repellent.

This can damage the disc.

• Do not place the disc in any place where it will be subjected to direct

sunlight or high temperatures.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Table of Contents

Heed the following

Warning .......................................................................................................................... 3

Caution ........................................................................................................................ 3

Cautions

Cleaning........................................................................................................................ 5

Handling the Disc .............................................................................................................. 5

Part Names and Functions

Front View....................................................................................................................... 7

Rear View ....................................................................................................................... 8

Preparation

Jumper Setting............................................................................................................ 9

Installing the CD-R/RW drive in a host PC ....................................................................... 10

Inserting/Removing a Disc

Using the CD-R/RW Drive Installed Vertically ................................................................... 13

Inserting a Disc ................................................................................................................... 14

Removing a Disc.................................................................................................................... 14

Emergency Eject............................................................................................................... 14

Specifications

CD-R/RW & CD-ROM Section................................................................................................... 15

CD-R/RW Section...................................................................................................................... 15

CD-ROM Section ...................................................................................................................... 15

Audio Section ............................................................................................................................ 15

Environment.............................................................................................................................. 15

General ..................................................................................................................................... 15

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Part Names and Functions

Front View

1 Phones Jack

This jack is used to connect a set of headphones. Please use

headphones with a stereo mini-jack plug.

2 Volume Control

This control is used to adjust the headphone volume.

NOTE: This control has no effect on the audio output from the LINE

OUT connector on the back of the CD-R/RW drive.

3 BUSY Indicator

This indicator lights green while data is being read and written.

4 Tray Panel

This panel prevents dust from entering the CD-R/RW drive.

The disc tray will be ejected when the Load/Eject button is pushed.

5 Emergency Eject Hole

Use to remove the disc from the CD-R/RW drive if the electrical eject

is disabled by software or if power failure occurs. (See page 14

“Emergency Eject” for details.)

6 Load/Eject

This button is pressed to eject or retract the disc tray when the power is on.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Rear View

7 Jumper Blocks

These blocks of jumper locations set the configuration for the CD R/RW drive.

(See page 10, “Jumper Setting” for details.)

8 DIGITAL OUT Connector

This connector is used to connect CD Digital Audio to an audio board.

9 Line Out Connector

This connector is used to connect CD-Audio to an audio board.

10 I/O BUS Connector

This BUS connector is used to control the CD-R/RW drive and sent data.

Use a flat ribbon cable to connect your computer to the CD-R/RW drive.

Connect the colored side of the ribbon cable to the side marked with the arrow (▽).

11 Power Connector

Use this to provide operating power from the host computer.

━━━━━━━━━━━━━━━━━━━━━━━━━━━━━━

Preparation

Jumper Setting

A jumper consists of a pair of pins and a connector which fits over the

pins. When the connector is in place it establishes an electronic link

between the pins, which enables the function being controlled by the

jumper. If the connector is removed, the electronic link is broken and the

function is disabled.

JUMPERBLOCK

Jumpers are used to set the CD-R/RW drive mode on the IDE interface.

1 2 3

CSEL SLAVE MASTER

Inhaltsverzeichnis

Andere NEC Lagerung Handbücher

NEC

NEC S4900 Installationsanleitung

NEC

NEC N8102-686 Bedienungsanleitung

NEC

NEC Storage Manager Bedienungsanleitung

NEC

NEC N8118-301 Bedienungsanleitung

NEC

NEC T30A Bedienungsanleitung

NEC

NEC LL030F Bedienungsanleitung

NEC

NEC D2246 Betriebsanleitung

NEC

NEC N8151-34B Bedienungsanleitung

NEC

NEC VERSA S1300 Series Bedienungsanleitung

NEC

NEC N8102-509F Bedienungsanleitung

NEC

NEC N8151-143 Benutzerhandbuch

NEC

NEC D3 Bedienungsanleitung

NEC

NEC N8151-54 Bedienungsanleitung

NEC

NEC Versa LX Bedienungsanleitung

NEC

NEC Built-In AIT Bedienungsanleitung

NEC

NEC VERSA S1300 Series Bedienungsanleitung

NEC

NEC S2900 Bedienungsanleitung

NEC

NEC NVM-2000 Leitfaden

NEC

NEC M100 Bedienungsanleitung

NEC

NEC NS170 Bedienungsanleitung

NEC

NEC N8102-589F Bedienungsanleitung

NEC

NEC S2500 Bedienungsanleitung

NEC

NEC FZ110A - Zip 100MB - 100 MB ZIP Drive Bedienungsanleitung

NEC

NEC Storage HS8 Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung