Nilfisk-Advance SC800 Betriebsanleitung

User and

Maintenance

SC800

www.crescentindustrial.co.uk

Guide

All manuals and user guides at all-guides.com

all-guides.com

SC800

www.crescentindustrial.co.uk

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this

procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

2. Fill the tank with a clean water. The

clean water temperature must not

exceed 40 °C.

1b. Disconnect the battery charger

cable from the electrical main.

3. Fill the EcoFlex tank with a deter -

gent suitable for the work to be

performed (highly concentrated

detergent).

4. Install the squeegee and fasten it

with the handwheels, then connect

the vacuum hose to the squeegee.

1a. Switch off charger by pressing the

STOP button. Unplug charger cable

from red battery plug. Reconnect

the red battery plug to the machine.

17. Clean the machine using a damp

cloth and where needed use a neutral

cleaning product.

15. Press the switch and wait for the

brushes to fall on the ﬂoor.Remove

the brushes and clean them.

16. Take the squeegee off and remove

debris. Check and clean the squeegee

blades.

18. Charge the batteries: Connect the

battery charger cable from the elec-

trical main.

19. Park the machine with the recovery

tank cover open.

12. At the end of the work. Empty the

recovery tank with the hose. Then

empty the solution tank with the

trasparent hose

10. Lower the squeegee with the lever. 11. Push the drive paddle for starting

ﬂoor cleaning. If solution applied

ﬂows outside the brush housing dur-

ing use, reduce the ﬂow of solution.

Switch off the machine using the key.

13. Wash with clean water the recovery

tank and the vacuum grid. Remove

and clean the debris tray.

14. Clean the ﬁlter: 1) Close the solu -

tion tap under the machine. 2)

Remove the transparent cover and

the gasket, then remove the ﬁlter

strainer.

7. Press the solution ﬂow control

switches as necessary, depending

on the type of cleaning to be per -

formed.

5. Place the brushes or the pad-holders

under the deck. Use the appropriate

brushes to clean the ﬂoor.

6. Turn the ignition key to “I”, then

lower the deck by pressing the Green

switch. To engage the brushes,

slightly press the drive paddle and

then release it.

8. Press the detergent ﬂow control

switch. The number of display shows

the detergent concentration level in the

solution (see the table on the label).

See the User Manual for setting change.

9. Press the EcoFlex™ switch whenever

you temporarily need a greater clean -

ing power.

External battery charger Machine with battery charger

All manuals and user guides at all-guides.com

Andere Handbücher für SC800

Andere Nilfisk-Advance Schrubber Handbücher

Nilfisk-Advance

Nilfisk-Advance ATTIX 751-0H EU Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance HSC 585 Betriebsanleitung

Nilfisk-Advance

Nilfisk-Advance SC530 53 BD GO Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Pacesetter 170 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BRX 700 Series Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advolution UHR 70-1700 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance FLOORTEC R 670 B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC450 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Retriever 4000B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Hydro-Retriever 2052 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 908 7144 020 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Captor 4300 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance ROS1300 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CA 340 ET Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance MX 521 H Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Kent 56302300 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC901 ST-28D Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Terra 4300B 908 4309 010 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance AX 651 Combi EDS Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 450 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 56315036(28D) Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC351 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC350 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1000S B Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

FIORENTINI

FIORENTINI ET 65-75 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung