Nilfisk-Advance SW8000 Installations- und Benutzerhandbuch

Page: 1

SW8000 How To

Prepare for Sweeping

Before operating any

machine, read the owner’s

manual carefully and take

time to learn the control

panel functions.

Check the machine for

damage, oil and coolant

leaks.

Check the hydraulic

system oil.

Check the battery

electrolyte level

(add

distilled water if needed).

Make sure the battery is

fully charged

Check the fuel level: LP

models – lift the engine

cover and replace the

Propane tank

(secure the

tank with the strap).

Gas and Diesel models -

carefully add fuel through

the fill port.

Check the engine air filter

service indicator – engine

models

(squeeze the rubber

dust cup to release built-up

dust).

Check the tire pressure

(90

- 95 psi for all tires).

Familiarize yourself with

the operator’s interface.

Adjust seat accordingly.

Insert key and turn

ignition on to continue

inspection.

Inspect controls, parking

brake, headlights, horn

and hour meter. Install

appropriate main broom.

Fill dust guard system

with clean water

(optional

for machines with this feature)

Plan cleaning route. Re-

inspect the parking brake

then prepare for sweeping.

Propane

Page: 2

SW8000 How To

Machine Operation

Adjust seat to desired

position.

Start the machine. Release

parking brake.

Engage foot pedal then

transport to designated

work area

(drive safely)

Push the Lower Hopper

Switch.

Move the main broom

level to the sweep

(middle) position.

Turn off the dust control

switch when sweeping

floor with puddles.

Push the Shaker Switch to

clean the dust control

filter.

Check your cleaning path

occasionally to make sure

machine is picking up

debris.

Put the main broom lever

in the Up/Off position.

Use shaker to remove

excess dirt. Drive to

dumping site to empty

hopper.

Hold the raise hopper

switch. Position machine

over trash receptacle

Set parking brake

Press open dump door

switch

Apply Hopper Safety

switch. Lower the hopper.

Inspect hopper door and

front edge seal. Use a

broom to remove litter if

needed. Release parking

brake. Push the hopper

safety handle forward then

lower hopper. Prepare

machine for storage and

daily maintenance.

Page: 3

SW8000 How To

After Use & Daily Maintenance

Shake the Hopper Dust

Control Filter.

Empty the hopper.

Shut down engine:

Raise brooms, change

engine speed to idle

(Gasoline/Diesel models),

turn

service valve off

(LPG),

run

engine until all LOP is

dispelled from the line.

Apply parking brake

Check engine coolant,

engine oil, hydraulic oil

level, parking brake and

clean main and side brooms.

(gas, LPG and diesel models)

Occasional Maintenance

•Rotate Main Broom

•

Clean the DustGuard

Spray Nozzles

•Inspect/adjust booms

•Clean Strainer

•Check/Clean opper

Dust Control Filter

using Method “A”

•Inspect broom

housing skirts

•Inspect hopper seals

•Clean radiator and oil

cooler

•Perform engine

maintenance

•Inspect and grease

steering spindle

•Check/Clean opper

Dust Control Filter

using Method “B”

•Check/Clean opper

Dust Control Filter

using Method “C”

•Change the hydraulic

oil filter

•Change the reservoir

hydraulic oil

•Flush the radiator

•Engine fuel filter(s)

Always refer to your

Mechanical Repair

Service Manual for

detailed maintenance

information.

After

15 Hours

Every 30 Hours

Every

150

Hours

Every 300 Hours

Every

100

0 Hours

Andere Handbücher für SW8000

Andere Nilfisk-Advance Schrubber Handbücher

Nilfisk-Advance

Nilfisk-Advance BA551 Betriebsanleitung

Nilfisk-Advance

Nilfisk-Advance Advenger BR 855 Benutzerhandbuch

Nilfisk-Advance

Nilfisk-Advance BR 601 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC400 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC351 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance FLOORTEC R 670 P Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Convertamatic 24 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BR 601 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance AX 651 Combi EDS Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Liberty SC60 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC5000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Adgressor BR 1050S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 48 LPG Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CS7000 Fuel Cell EcoFlex Administratorhandbuch

Nilfisk-Advance

Nilfisk-Advance SC530 53 BD GO Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC250 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance ecoflex BA 551D Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC8000 48 LPG Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 600S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 340 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance S2 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BR 1100S SBG SPECIAL Service-Handbuch

Nilfisk-Advance

Nilfisk-Advance SelectScrub KA-27 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Viper Fang 15B Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

FIORENTINI

FIORENTINI ET 65-75 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung