NTI ENVIROMUX E-5D Bedienungsanleitung
1
E-xD: RESTORE DEFAULTS VIA RS232
This procedure is provided to enable the administrator to restore defaults to the E-5D\16D using the “RS232” port.
Note: This procedure has been tested to work properly using Microsoft®HyperTerminal. We cannot confirm whether
other terminal programs will give satisfactory results.
1.Connect one end of a CAT5 patch cable (supplied) to the port labeled “RS232” on the rear of the E-16D (or front of the E-5D).
Plug the other end of the CAT5 cable into an RJ45-to-DB9F adapter (supplied), and connect the adapter to the RS232 port on the
control terminal.
Connect a terminal for direct RS232 serial communication
2
2. Using the terminal connected to the ENVIROMUX, start the terminal program (e.g. Windows HyperTerminal) and configure it
as follows:
direct connection (using the appropriate CPU local serial Com port)
115200 bps
8 bits
no parity
1 stop bit
no flow control
VT100 terminal mode.
3. Power ON the ENVIROMUX and as the ENVIROMUX begins to boot, press and hold the <Tab> key. (If you fail to press this
key in time the system will continue booting and you will have to power OFF the ENVIROMUX and start over.)
Erase the configuration of the ENVIROMUX
4. At the “SEMS-16>” prompt, type;
SEMS-16> nand erase config
5. Press <Enter> key.
The ENVIROMUX will erase all configuration settings and restore the ENVIROMUX to factory default settings. ALL USER
CONFIGURATION AND SENSOR CONFIGURATION SETTINGS WILL BE LOST.
When finished, the “SEMS-16>” prompt will return.
6. At the prompt, type reset and press <Enter>. The ENVIROMUX will restart.
T
yp
e
n
and erase confi
g
T
yp
e
r
eset
3
Restoring the default configuration of the ENVIROMUX
7. As the ENVIROMUX restarts, it will restore defaults (as shown in image above) and then present the ENVIROMUX login screen
(below).
Text Menu Login Screen
4
At this point you can either access the ENVIROMUX using the Device Discovery Tool (found on the manual CD and our website
at http://www.networktechinc.com/download/d-environment-monitor-16.html ) to change the network settings back to what they
were, or you can login to the text menu (below) using the default administrative user “root” and password “nti”.
From the text menu, to change the network settings, enter <4>, then <1> to get to the network configuration menu.
Enter your settings.
Be sure to <Tab> to the Save and press <Enter> before exiting the menu.
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere NTI Messgerät Handbücher
NTI
NTI ENVIROMUX-16D Bedienungsanleitung
NTI
NTI ENVIROMUX Series Bedienungsanleitung
NTI
NTI ENVIROMUX-16D Bedienungsanleitung
NTI
NTI ENVIROMUX Series Bedienungsanleitung
NTI
NTI ENVIROMUX Series Bedienungsanleitung
NTI
NTI ENVIROMUX Series Bedienungsanleitung
NTI
NTI ENVIROMUX-MINI-LXO Bedienungsanleitung
NTI
NTI USB-A+A-5M Bedienungsanleitung
NTI
NTI E-BEEP2-x Bedienungsanleitung
NTI
NTI ENVIROMUX Series Bedienungsanleitung
