6. Dry run lasting more than 2 minutes will lead to damage to the high pressure pump.
If the appliance does not build up pressure within 2 minutes, switch it off and proceed as instructed in
the Chapter Troubleshooting.
The trigger gun is subjected to recoil force when the water is jetted. Make sure you have a firm footing
and are also holding the trigger gun and spray wand firmly.
5 different spray nozzles (0°,15°,25°,40°and Black soap spray nozzle) can tackle various cleaning tasks
(pic H).
7. The detergent can also be used when cleaning. The detergent tank with cap makes cleaning moreeffective.
Pull out the tank and remove the cap then fill with the detergent (pic P). Then cap the tank closed and
put it back into the appliance.(pic E)
5. For the connection valve, use the fibre-reinforced water hose(not included)with a standard coupling.
Connect the water hose to the appliance and water supply. Or put the water hose into a large container
filled with water for self-priming.(pic N). The self-priming process should be less than 2 meters away
from the water supply, so the length of the water inlet hose is about 2 meters. When starting the
appliance, you need to exhaust air. That is, you should remove the spray wand first and press the trigger
on the handle of the trigger gun for about 10 seconds, until the water starts to come out, and then you
can use it by re-installing the spray wand.
a.Turn on the tap
b.Unlock the trigger gun (pic I)
c.Press the lever of the trigger gun
d.Turn the switch to the ON position to start the appliance (pic G ON: open, OFF: close)
1. Water inlet coupling
2. High pressure hose
3. Water outlet
4. Water inlet
5. ON/OFF switch
6. Handle
7. Detergent tank
8. Power cord
9. Wheels
10. Trigger gun
11. Spray wand
12. 5 spray nozzles
13. Trigger lock
14. Hose lock
15. Trigger gun holder
16. Gun holder lock
17. Telescopic handle
18. Detergent siphoning tube
19. Filter
20. Water tank lock
21. Spray wand holder
English
Please check if the accessories are complete first. If something missing, please contact us.
Install accessories before start-up.
1. Install coupling for water connection (pic A)
Screw the provided coupling to the water inlet on the appliance.
2. Install high pressure hose (pic B, pic K)
Install the high pressure hose tightly into the coupling on water outlet.
Connect the high pressure hose to the trigger gun, then lock the hose (pic K 1).
Meanwhile, install the hose protector.
Note: Make sure the connection nipple is aligned correctly. Check if the connection is secure by pulling
on the high pressure hose.
3. Install trigger gun holde (pic C)
Insert the trigger gun holder and push down all the way, then lock it in place.
4. Install spray wand (pic F)
Fit the spray wand into the trigger gun and fasten it by rotating it through 90 degree. Then slide the brass part
down on the top of the nozzle to load the nozzle (5 kinds of water splash), then insert the nozzle and let go.
Installation Steps
2
