Olympia electronics GR-939/15L/MAR Bedienungsanleitung

Thank you for purchasing this product of

O l y m p i a E l e c t r o n i c s . A E u r o p e a n

manufacturer.

GENERAL

These luminaires, according to Lloyd’s

s u i ta b l e f or m a r i ne a n d o ff sh o r e

applications for use in environmental

categories ENV1, ENV2, ENV3 and ENV4,

where ENV1 are controlled environments,

ENV2 are enclosed spaces subject to

temperature, humidity and vibration, ENV3

are enclosed spaces subject to generated

heat from other equipment and ENV4 are

mounted on reciprocating machinery. Each

luminaire must be permanently connected

to m ain s p owe r su pp ly. I n no rm a l

operation the led strip lights and the

battery is charging. In case of a mains

power supply failure the luminaire will

light the led strip automatically in

emergency mode. When the mains

power supply is restored the device

turns to normal operation.

INSTALLATION

To install the luminaire follow the

installation instructions on page 3.

OPERATION

Battery charging

The battery charging is completely

controlled. In this case, is achieved the

perfect battery maintenance , as well as the

elongation of its duration. When the battery

has completely charged, it charges with a

maintenance current.

Battery Cut-off

The luminaire enters in this operation when

the mains power supply fails and battery

has lost its energy. During this operation

the luminaire enters the idle state and

battery consumption is negligible, in order

to be protected from deep discharge.

Manual Test

The manual test can be conducted only if

the main power supply and the battery is

connected. By pressing the TEST/RESET

button briefly (page 3) an operation test is

initiated. During this test period all

indication LEDs are OFF.

Automatic Test

This test includes all the operations that

provide the manual test and is conducted

automatically every 15 days. In order to be

performed, the main power supply and the

battery should be connected.

Automatic Autonomous Test

The Automatic Autonomous Test is

conducted and measures the luminaire`s

back up operation. This test is conducted

automatically every six months. In order to

be performed, the main power supply and

WATERPROOF SELF TESTING EMERGENCY LUMINAIRES

Page 1 from 2

220-240V AC/50-60Hz

Bayblend FR3010, transparent polycarbonate

TECHNICAL CHARACTERISTICS

OPERATION TEMPERATURE RANGE

RELATIVE HUMIDITY

EXTERNAL DIMENSIONS

CONSTRUCTION MATERIALS

TYPICAL WEIGHT

GUARANTEE

OPERATION VOLTAGE

MAXIMUM POWER CONSUMPTION

BATTERIES (Ni-Cd)

CHARGING TIME

INDICATIONS

BATTERY PROTECTION

MINIMUM AUTONOMOUS DURATION

DEGREES OF COVER PROTECTION

PRODUCED IN ACCORDANCE WITH

ILLUMINATION (MAINS / EMERGENCY)

ILLUMINATION SOURCE

24h

Charge, lamp fault, battery fault indication LED

From overcharge and full discharge

IP 65

3.6V/3Ah

210lm / 210lm

5 to 40 C

Up to 95%

3 years (1 year for the battery)

940gr.

363 x 145 x 73 mm

105lm / 105lm

180min

5W /8.5VA

3.5W / 7.5VA

3.6V/1.5Ah

30 white LED’s

15 white LED’s

GR-939/15L/MAR GR-939/30L/MAR

870gr.

923939017_09_003

High Quality European based Manufacturers

EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3, IEC 60092-306, IEC 60533

Page 2 from 3

the battery should be connected (the

battery should be charged). If the battery

is not charged, the test is postponed until

the battery is completely charged. If during

the Automatic Autonomous Test the

luminaire’s duration is lower than the

named, then the battery must be replaced.

Back Up Operation

The autonomous duration of battery during

emergency mode is at least the one that is

stated in the technical characteristics.

During emergency mode, a LED strip test

is also performed.

Resetting Errors

Push the TEST/RESET button for 5

seconds, to extinguish all the indicated

LED errors (page 3). Then the luminaire

enters regular operation mode.

Indication LED status

(with connected mains power supply).

Charge

On: Good charge current.

Οff: No battery (No charging current or

disconnected battery).

Lamp Fault

Οn: Faulty LED strip.

Off: Good LED strip.

Battery Fault

Οff: Battery OK.

Blink (With Charge LED ON): Autonomy

or low battery problem

(the battery must be replaced).

Blink (With Charge LED Off):

No charging current or disconnected

battery.

ΑΤΤΕΝΤΙΟΝ!!!

1. Operations for installation, maintainance

or testing must be done by authorized

personel only.

2. The device must be connected to the

mains power supply through a fuse

dependent by the total amount of the line’s

power load.

3. In case of battery or lamp replacement,

these must be replaced by parts of the

same type, by the manufacturer or by a

competent person.

4. In case of inactive use for a period

greater than 2 months, disconnect the

battery by pulling out the battery’s

connector.

5. I s not allowed to discard batteries in t i

to common trash bins, they must be

discarded only in battery recycling

points. Do not incinerate.

NOTE: LED= Light Emitting Diode

LABELING EXPLANATION:

X: Self contained

1: Maintained (*)

A: Including test device

180: 3 hour duration

(*) Maintained operation: The luminaire

lights its illumination source, when it is

Non Maintained operation: The luminaire

lights its illumination source, only in power

supply’s failure.

NOTE!! After finishing the installation

you must power the luminaire at least

for 24 hours for battery charging to

perform the nominal autonomy.

Battery replacement

1. Unfasten the 4 retaining screws (step 10

of the installation instructions) and remove

the diffusor.

2. Unfasten the 2 retaining screws step 9 of

the installation instructions and remove the

reflector.

3. Remove the old battery and place a new

on of the same type and characteristics.

4. Replace the removed parts (previous

steps 1,2).

923939017_09_003

Page 3 from 3

Manual TEST or Resetting Errors

In order to test or reset the device you

must carefully remove the diffusor by

unfastening the 4 mounting screws.

Then push the button as described in

the according paragraphs on page 1.

L1 L N N

L1 L N

External

switch

Controlled operation of the lamp

Link

Permanent maintained operation

1 Remove the diffusor. Place simultaneously 2 flat blade screwdrivers and pull up gently the

reflector.

2 Install the included plastic cover in to the unused hole and install the base plastic (with the

included mounting screws and plugs).

3 Always use in any case round mains cable, with external diameter of 6-9mm (H05RN-F

type 2x1mm² or any other type, at least equal to it’s mechanical and electrical properties).

ATTENTION!! The cable must not be deformed in any way (This requirement is important

to ensure the tightness isolation IP 65). Install the cable gland, pass the round cable through

and tighten it all the way.

4 Place the battery’s connector to the corresponding connector on the P.C.B.

5 Connect the mains cables to the respective terminal block (connect the ground wire if required).

6 Ν for neutral, L for live wire and L1 for the maintained operation. The L1 wire can be connected

to an external switch to control the maintained or non maintained operation of the luminaire.

7 For permanent maintained operation use two wires to power the luminaire, Ν for neutral and L for

live wire, and link the L and L1.

8 Install the included tie (if needed) to fasten securely the power cables.

9 Refit the reflector and fasten the two small screws (included).

10 Finaly place the diffusor by using the 4 included screws (tightening torque 1.2 Nm).

INSTALLATION INSTRUCTIONS

234

923939017_09_003

Dieses Handbuch passt für folgende Modelle

Andere olympia electronics Beleuchtungsausrüstung Handbücher

olympia electronics

olympia electronics GR-423/12L/MAR Bedienungsanleitung

olympia electronics

olympia electronics GR-577/L/15/ST/WP Bedienungsanleitung

olympia electronics

olympia electronics GR-292/M/HL/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-2100 Bedienerhandbuch

olympia electronics

olympia electronics GR-940/15L Bedienungsanleitung

olympia electronics

olympia electronics PLD-25/NiMH Bedienungsanleitung

olympia electronics

olympia electronics GR-315/15L Bedienungsanleitung

olympia electronics

olympia electronics GR-938/4P/ADR Bedienungsanleitung

olympia electronics

olympia electronics SLD-28/SP Bedienungsanleitung

olympia electronics

olympia electronics GRL-37/90/WP/WL Bedienungsanleitung

olympia electronics

olympia electronics MLD-28D/w/MAR Bedienungsanleitung

olympia electronics

olympia electronics GR-900/30L/SC Bedienungsanleitung

olympia electronics

olympia electronics OLY-1004/LT/WP Bedienungsanleitung

olympia electronics

olympia electronics TUV COMFORT LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics GRL-37/90 Bedienungsanleitung

olympia electronics

olympia electronics KLD-22/ST Bedienungsanleitung

olympia electronics

olympia electronics WEATHER LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics KLD-30/ST/ADR Bedienungsanleitung

olympia electronics

olympia electronics GRL-29/WL Bedienungsanleitung

olympia electronics

olympia electronics RT-15 Bedienungsanleitung

olympia electronics

olympia electronics GR-60 Bedienungsanleitung

olympia electronics

olympia electronics ZLD-28/EM/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-415/4P Bedienungsanleitung

olympia electronics

olympia electronics POWER LIGHT Series Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

olympia electronics GR-939/15L/MAR Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken