7
Outstation Deployment
Once t e batteries ave been installed and c arged in t e Basestation and t e Outsta-
tions, connect t e antennas, sensor cables and sensors to eac Outstation.
Switc on eac Outstation by pressing t e On/Off button. T e LED will flas Orange
t en Green (or Yellow/Red depending on battery status) to indicate t e unit is ready
for use.
To turn t e Outstations off, press and old t e On/Off button momentarily. T e LED
will lig t Red t en go off. W en t e LED as gone off, t e button can be released.
To c eck t e sensors are working correctly, connect t e eadp ones to t e Outstation
and listen w ile running your finger over t e sensor magnet. A clear crisp noise s ould
be eard.
Deploy eac sensor on a water pipe fitting eit er side of t e suspected leak position.
T e sensor as a strong magnet t at will enable it to remain in position on steel/iron
fittings.
Always ensure t e contact point is free from dirt so t at t e magnet makes a good
contact. We recommend t e use of a wire brus to clean t e pipe/valve/ ydrant fitting
prior to attac ing t e sensor.
Outstation LED Functions:
T e Outstation incorporates an LED, w ic provides t e following information:
During charge:
T e LED flas es red at t e start of c arging. W en t e c arging current starts to
fall, t e LED indication c anges to a yellow flas . W en c arging is complete, t e
LED will flas green.
During deployment:
W en t e unit is on and performing normally, t e LED flas es Green briefly once
a second. To indicate battery status t e LED will c ange from Green to Yellow
and Red. Wit t e LED flas ing Yellow, t e battery is OK. A Red flas ing LED in-
dicates t e battery requires immediate c arging.
If t e Outstation is off and t e system is not on c arge, t e LED is off.
Flexibility, Efficiency, Simplicity
