Panasonic KX-FP101AL Bedienungsanleitung
©1999 Kyushu Matsushita Electric Co., Ltd. All
rights reserved. Unauthorized copying and
distribution is a violation of law.
KX-FP101AL
(for Australia)
Compact Plain Paper FAX
ORDER NO. KM79909316C3
1 INTRODUCTION
1.1. SAFETY PRECAUTIONS
1.Before servicing, unplug the AC power cord to prevent an electric shock.
2.When replacing parts, use only the manufacturer’s recommended components.
3.Check the condition of the power cord. Replace if wear or damage is evident.
4.After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
5.Before returning the serviced equipment to the customer, be sure to perform the following insulation resistance test to prevent
the customer from being exposed to shock hazards.
1.2. INSULATION RESISTANCE TEST
1.Unplug the power cord and short the two prongs of the plug with a jumper wire.
2.Turn on the power switch.
3.Measure the resistance value with an ohmmeter between the jumpered AC plug and each exposed metal cabinet part
(screwheads, control shafts, bottom frame, etc.).
Note: Some exposed parts may be isolated from the chassis by design. These will read infinity.
4.If the measurement is outside the specified limits, there is a possibility of a shock hazard.
1.3. FOR SERVICE TECHNICIANS
ICs and LSIs are vulnerable to static electricity.
When repairing, the following precautions will help prevent recurring malfunctions.
1.Cover the plastic part’s boxes with aluminum foil.
2.Ground the soldering irons.
3.Use a conductive mat on the worktable.
4.Do not touch the IC or LSI pins with bare fingers.
1.4. BATTERY CAUTION
CAUTION
Danger of explosion if the battery is replaced incorrectly. Replace only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to following caution:
Disposal of lithium batteries should be performed by permitted, professional disposal firms knowledgeable in state government
federal and local hazardous materials and hazardous waste transportation and disposal requirements.
A battery continues to have no transportation limitations as long as it is separated to prevent short circuits and packed in strong
packaging.
Commercial firms that dispose of any quantity of lithium cells should have a mechanism in place to account for their ultimate
disposition. This is a good practice for all types of commercial or industrial waste.
Recommend Type Number:
CR2032 (BATT) Manufactured by MATSUSHITA
CR2032 (BATT) Manufactured by SONY
2
KX-FP101AL
1.5. AC CAUTION
For safety, before closing the lower cabinet, please make sure of the following precautions.
1.The earth lead is fixed with the screw.
2.The AC connector is connected properly.
3.Wrap the earth lead around the core 3 times.
(Bottom View)
1.6. PERSONAL SAFETY PRECAUTIONS
1.6.1. MOVING SECTIONS OF THE UNIT
Be careful not to let your hair, clothes, fingers, accessories, etc., become caught in any moving sections of the unit.
The moving sections of the unit are the rollers and a gear. There is a separation roller and a document feed roller which are rotated
by the document feed motor. A gear rotates the two rollers. Be careful not to touch them with your hands, especially when the unit
is operating.
1.6.2. LIVE ELECTRICAL SECTIONS
All the electrical sections of the unit supplied with AC power by the AC power cord are live.
Never disassemble the unit for service with the AC power supply plugged in.
CAUTION:
AC voltage is supplied to the primary side of the power supply unit. Therefore, always unplug the AC power cord before
disassembling for service.
(Bottom View)
3
KX-FP101AL
1.7. SERVICE PRECAUTIONS
1.7.1. PRECAUTIONS TO PREVENT DAMAGE FROM STATIC ELECTRICITY
Electrical charges accumulate on a person. For instance, clothes rubbing together can damage electric elements or change their
electrical characteristics. In order to prevent static electricity, touch a metallic part that is grounded to release the static electricity.
Never touch the electrical sections such as the power supply unit, etc.
4
KX-FP101AL
General
· Help function
Display:
1.HOW TO SET UP
2.JOG/AUTO DIAL
3.FAX SENDING
4.FAX RECEIVING
5.COPIER
6.Q and A
7.ERRORS
8.REPORTS
9.CALLER ID
· LCD (Liquid Crystal Display) readout
· TAM (Telephone answering machine) interface
Plain Paper Facsimile Machine
· 12 second transmission speed *
· Letter/Legal, G3 compatible
· Automatic document feeder (15 sheets)
· 6 stations one-touch dialer
· Broadcast (up to 20 station) × 3
· Resolution : Standard/Fine/Super fine/Half tone (64 level)
· LCD Contrast : Normal/Darker
· Delayed transmission
· Overseas transmission function
· Remote FAX receiving using an extension phone
· 150-sheet paper capacity
· Automatic fax/phone switching
· Distinctive ring detection **
· Caller ID
* The 12 second speed is based upon the ITU-T Test Chart on
the condition that memory transmission is performed.
** Subscription to distinctive ring services required.
Large Memory (28 pages) ... Performed by DRAM
Approx. 28 pages of memory reception
Approx. 25 pages of memory transmission
Integrated Telephone System
· On-hook dialing
· Monitor
· Voice muting
· Redialing function
· 50-Station telephone directory with Jog Dial
Copier function
· Multi-copy function (up to 99 copies)
· Enlargement and reduction
· Collate
· 64-Level halftone
· Electronic film indicator
1.8. FEATURES
5
KX-FP101AL
1.9. SPECIFICATIONS
Applicable Lines: Public Switched Telephone Network
Document Size: Max. 216 mm (8 1/2") in width
Max. 600 mm (23 5/8") in length
Effective Scanning Width: 208 mm (8 3/16")
Recording Paper Size: A4: 210×297 mm (8 1/4"×11 11/16")
Effective Printing Width: 202 mm (8")
Transmission Time*: Approx. 12 sec./page (Original mode)**
Scanning Density: Horizontal:
8 pels/mm (203 pels/inch)
Vertical:
3.85 lines/mm (98 lines/inch)—STANDARD mode
7.7 lines/mm (196 lines/inch)—FINE/HALF TONE mode
15.4 lines/mm (392 lines/inch)—SUPER FINE Mode
Halftone Level: 64-level
Scanner Type: Contact Image Sensor (CIS)
Printer Type: Thermal Printing
Data Compression System: Modified Huffman (MH), Modified READ (MR)
Modem Speed: 9,600/7,200/4,800/2,400 bps; Automatic Fallback
Operating Environment: 5—35°C (41—95°F), 20—80 % RH(Relative Humidity)
Dimensions (H×W×D): 143×325×305 mm (5 5/8"×12 13/16"×12")
Mass (Weight): Approx. 4.0 kg (8.8 lb.)
Power Consumption: Standby: Approx. 6.5 W
Transmission: Approx. 15 W
Reception: Approx. 42 W (When receiving a 20% black document)
Copy: Approx. 45 W (When copying a 20% black document)
Maximum: Approx. 150 W (When copying a 100% black document)
Power Supply: 220—240 V AC, 50/60 Hz
Memory Capacity: Approx. 28 pages memory reception
Approx. 25 pages memory transmission
(Based on ITU-T Test Chart in standard resolution.)
* Transmission speed depends upon the contents of the pages, resolution, telephone line conditions and capability of the receiving
unit.
** The 12 second speed is based upon the ITU-T Test Chart and original mode. (Refer to "1.11. ITU-T Test Chart".) If the capability
of the other party’s machine is inferior to your unit, the transmission time may be longer.
Note:
· Any details given in these instructions are subject to change without notice.
· The pictures and illustrations in these instructions may vary slightly from the actual product.
Design and specifications are subject to change without notice.
1.10. OPTIONAL ACCESSORIES
6
KX-FP101AL
1.11. ITU-T Test Chart (Actual size)
7
KX-FP101AL
1.12. LOCATION OF CONTROLS
1.12.1. OVERVIEW
Note:
· The document and recording paper will be ejected from the front of the unit. Do not put anything in front of the unit.
8
KX-FP101AL
1.12.2. CONTROL PANEL
9
KX-FP101AL
1.13. CONNECTIONS
To the power outlet
(220–240 V, 50/60 Hz)
Telephone
line cord
Power cord
Handset cord
To the single
telephone line
Telephone plug
1
Connect the handset cord.
2
Connect the telephone line cord.
3
Connect the power cord.
When the power is turned on for the
first time, the unit will print some
basic information.
NOTE
When you operate this product, the power outlet should be near the product and easily accessible.
10
KX-FP101AL
Inhaltsverzeichnis
Andere Panasonic Faxgerät Handbücher
Panasonic
Panasonic KX-FLC418RU Bedienungsanleitung
Panasonic
Panasonic KX-F2710NZ Bedienungsanleitung
Panasonic
Panasonic KX-FLM551 Bedienungsanleitung
Panasonic
Panasonic KX-F3100 Bedienungsanleitung
Panasonic
Panasonic KX-FLB756 Bedienungsanleitung
Panasonic
Panasonic KX-FP215 Bedienungsanleitung
Panasonic
Panasonic KX-FC241AL Bedienungsanleitung
Panasonic
Panasonic KX-PW88CL Bedienungsanleitung
Panasonic
Panasonic KX-FP362CX Bedienungsanleitung
Panasonic
Panasonic DX 1000 - PanaFax B/W Laser Printer Bedienungsanleitung
Panasonic
Panasonic KX-FP105BX Bedienungsanleitung
Panasonic
Panasonic Panafax UF-270 Bedienungsanleitung
Panasonic
Panasonic KX-PW100CL Bedienungsanleitung
Panasonic
Panasonic KX-PW11CLH Bedienungsanleitung
Panasonic
Panasonic KX-FT31BX Bedienungsanleitung
Panasonic
Panasonic KX-FP80 Bedienungsanleitung
Panasonic
Panasonic KX-FPC165 Bedienungsanleitung
Panasonic
Panasonic Panafax UF-4100 Bedienungsanleitung
Panasonic
Panasonic KX-PD381DLE8 Bedienungsanleitung
Panasonic
Panasonic KX-FC228HK Bedienungsanleitung
