Panasonic KX-TGP550 Bedienungsanleitung

Above is the image if a Panasonic KX-TGP500,

these Do NOT have an attached Corded Base

Handset. Note the KX-TGP500 will be missing

the option to configure a Base Handset.

Above is the image if a Panasonic KX-TGP550,

these DO have a Base Corded Handset

attached, and will allow for the Base

Handset to have a separate Line configured

to it.

Panasonic KX-TGP500 and KX-TGP550:

(Even though the Base supports up to 6 Handsets, these are ONLY able to support 3 Simultaneous calls)

How to Configure Panasonic KX-TGP500 and KX-TGP550:

ConnectyouPanasonicKX-TGP5XXtothepowerandnetworkusingtheLANportontheBase.Youwillthen needto

locatethe“ALL”buttonontheBase.OnceLocatedyouwillwanttoregisteryourHandsetstothebase following the

belowinstructions:

Press the “ALL”button on Base and hold for 4 Seconds

Afterhearthebeepyouwillpressthe“OK”softkeyonhandset(Somefirmwareormodelsmayrequirea PIN this

will be 0000)

After the handset completes its registration to the base it will beep

The Base status light should turn Green andthe handset should show the Date/Time (May not be

correct)

To De-Register Handsets use the following steps:

Press Menu

Select InitialSettings

Select Registration

SelectDeregistrationand enter the3 digitcodethat appears onthe screen, thenPress OK

Now you will be able to Select the Handset to Deregister

When prompted to Erase, Select Yes

Ifsuccessfully deregistered you willsee,“PressALLonbase4sec. ThenpressOK”

Repeat these steps as needed for each handset.

To begin configuring your Panasonic KX-TGP5XX for use on Voice Services network, you will need to enable the graphical user

interface.

For this, do the following:

Press the Menu on Base

Select IP Service

Select Network Setting

Select Embedded Web

Toggle to“ON”

Select the “Save”Softkey

To locate the IP and access the Web Interface the following:

Press the Menu on Base

Select IP Service

Select NetworkSetting

Select IP address

Write down and enter the IP address listed into a web browser

You will then be presented with a screen that looks like this:

**** First thing we will want to do is Reset the Base and make sure to Deregister any extra handsets. Make sure you

only have as many handset Registered as physically have on site.

To Reset the Base this is done under the Maintenance Tab > Reset to Defaults

*** NOTE: If the Phone came from another provider, that provider may have to factory default the phone.

Instead of logging in with admin/adminpass you will need to reboot the phone and turn on the web in the

handset again and login using super user login customerserviceid/cspass.

You will get a “403 Forbidden error” if you just log out and try to log back with these credentials. It is important to

reboot and enable the web UI again.

Click maintenance

Reset toDefaults

Reset to FactoryDefaults

Now update and configure the Time Adjust Settings, the Time Zone setting will be dependent on your region. You

will enter the NTP Server Address =

pool.ntp.org

(Match all other settings with that of the picture below based on

your time zone

)

After you login,you will needto navigatetotheVoIPTabPage.There will be differentLinesto choosefromon the

left side of the page. Start with the “SipSettings-Line1”,and will need to enter in the SIP configuration information

for your AnyPhone (Unsupported) device on this page.

These setting can be found within Hostpilot @ https://exchange.intermedia.net/aspx/Login.aspx

Click HERE to open the article that shows how to obtain SIP configuration information for a line key.

*** Note: All ports

will be 5060 accept the Source Port which will be 5xxx (xxx is equal to the ext #)

*** Make sure all the fields in orange are completed (Each Line should have its own configuration):

*** Note: The SIP Source Port will be 5xxx, the xxx will be the Ext number in this case Ext 102.

*** If you MISS or DO NOT complete all fields in Orange it will cause one way audio or inbound and/or outbound call

failure issues.

This is a Critical step and needs to be followed closely.

After you haveit looking like this, click the Save button. The device will then attempt to register. If registration was

successful, you should see a red “Complete”across the top:

Now your device is registered! However, there is a little more configuration that needs to be completed. Still under the

VoIP Tab, click the “VoIP Settings” and update the Min and Max RTP ports:

Still under the VoIP Tab, click the “Line 1” and update the CODEC and DTMF Settings (Repeat as needed for

each Line):

Almost there! Next, go to the “Telephone” Tab. Depending on which lines you want to ring which Handset and/or Base

Handset you will make the following changes.

*** NOTE: Only KX-TGP550 will have a Base Handset option meaning unlike the Panasonic 500 the Panasonic

550 has a CORDED handset attached to it which will need its own DID and line configuration.

*** Note: Even though you will be able to select multiple lines per handset or Base Handset this is not a supported

service or feature with Intermedia at this time. You want to have the handset and “Line No” match in both the top and

bottom. Also, note the default dial out drop down is set to the correct “Line No” for the handset associated to that line.

*** If you do not see Base in your above image this just means your model does not have a Base Corded handset and

can ignore changing Lines or Defaults for the Base (Handset) field. The only model that will have Base Handset as an

option is Panasonic KX-TGP550 which has a Corded Handset built in to the Base.

The final step is to configure your voicemail number, which is the phone’s direct number. Go to the Telephone Tab,

and make the changes in the boxes below.

It will look like this but with the number that is currently assigned to your phone:

You MUST now restart the Base, using the Web Interface.

Andere Handbücher für KX-TGP550

Dieses Handbuch passt für folgende Modelle

Andere Panasonic IP-Telefon Handbücher

Panasonic

Panasonic KX-NT321 Bedienungsanleitung

Panasonic

Panasonic KX-NT265X Bedienungsanleitung

Panasonic

Panasonic KX-TDA Gebrauchsanweisung

Panasonic

Panasonic KX-T7667 Bedienungsanleitung

Panasonic

Panasonic KX-DT521 Referenzhandbuch

Panasonic

Panasonic KX-HDV100 Service-Handbuch

Panasonic

Panasonic KX-T7420 Bedienungsanleitung

Panasonic

Panasonic NT346-B - KX - VoIP Phone Bedienungsanleitung

Panasonic

Panasonic KX-NT321 Bedienungsanleitung

Panasonic

Panasonic KX-TVM50 Betriebsanleitung

Panasonic

Panasonic KX-DT 333 Series Bedienungsanleitung

Panasonic

Panasonic KX-HDV100 Service-Handbuch

Panasonic

Panasonic KX-UT136-B Bedienungsanleitung

Panasonic

Panasonic KX-DT 333 Series Bedienungsanleitung

Panasonic

Panasonic KX-UT123 Service-Handbuch

Panasonic

Panasonic KX-NT543 Bedienungsanleitung

Panasonic

Panasonic KX-UT133-B Bedienungsanleitung

Panasonic

Panasonic KX-TGP600 Service-Handbuch

Panasonic

Panasonic KX-TGP600 Service-Handbuch

Panasonic

Panasonic KX-UT113 Bedienungsanleitung

Panasonic

Panasonic KX-HDV430 Bedienungsanleitung

Panasonic

Panasonic KX-HDV100 Bedienungsanleitung

Panasonic

Panasonic KX-NT400 Bedienungsanleitung

Panasonic

Panasonic KX-DT321C Bedienungsanleitung

Beliebte IP-Telefon Handbücher anderer Marken

Alcatel

Alcatel 4028 Bedienungsanleitung

Polycom

Polycom Polycom VVX 600 Bedienungsanleitung

Polycom

Polycom SoundPoint IP 450 Bedienungsanleitung

Cisco

Cisco SPA-500 Series Bedienungsanleitung

Polycom

Polycom SoundPoint IP 650 Bedienungsanleitung

Proximus

Proximus Maestro 3016 IP Bedienungsanleitung

Fanvil

Fanvil X4 Bedienungsanleitung

Cisco

Cisco 7962 Bedienungsanleitung

Snom

Snom 320 Bedienungsanleitung

Yealink

Yealink Yealink SIP-T46G Bedienungsanleitung

Avaya

Avaya 4625SW Bedienungsanleitung

Yealink

Yealink SIP-T52S Bedienungsanleitung

Nortel

Nortel 1140E Bedienungsanleitung

Nexotek

Nexotek NT-P500 Bedienungsanleitung

Avaya

Avaya Integral 5 R3.0 Bedienungsanleitung

GE 28320EE2 - Dect 6.0 InfoLink 2 Bedienungsanleitung

Avaya

Avaya 4600 Series Service-Handbuch

Mitel

Mitel MIVOICE OFFICE 400 6940 SIP Bedienungsanleitung