Panasonic WJHDE300 - DIGITAL DISK RECORDER Bedienungsanleitung

Digital Disk Recorder Extension Unit

WJ-HDE300 S-ATA conversion guide

1. Sept. 2008

Panasonic System Solutions

WJ-HDE

300

Extension Unit

WJ-HDE300 S-ATA conversion guide Maintenance guide

Panasonic System Solutions HDE300_SATAConversionGuide_B

1. Outline

This guide describes how to convert the hard disk drive installed in the WJ-HDE300 from the P-ATA type to the S-ATA type.

2. Preparation

(1) Screwdriver

(2) Wrench for hexagonal nut (5.5m/m)

(3) S-ATA conversion kit (0E0A0028AA)

Part name Part number Quantity

S-ATA Board Ass’y JHE30JKY3A 2

S-ATA cables

K1V313Y10002 (S-ATA: Gray, Power cable: Red/Yellow)

1 each

K1V313Y10003 (S-ATA: Gray, Power cable: White/Orange)

K1V313Y10004 (S-ATA: Red, Power cable: Red/Blue)

K1V313Y10005 (S-ATA: Red, Power cable: White/Purple)

S-ATA board mounting hardware 3CA005880AAA 1

Insulating plate 3CZ001284AAA 1

Hexagonal spacer 22 mm 1CJ001328AAA 1

Hexagonal spacer 7 mm 1CJ001311AAA 6

Cord clamp FCA16 9

S-ATA label, small (for front) 3PD003840AAA 1

S-ATA label, large (for top) 3PD003841AAA 1

SW label 3PD003124CAA 1

S-ATA leaet 3TU001944AAA 1

Hexagonal spacer 6mm (for HDE350) 1CJ001309AAA 1

Additional screws - 5

(4) 2 Cable ties

(5) Ruler

(6) S-ATA HDD (***GB) x quantity (part number: ********)

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

3. Replacement Procedure

Important +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

• Before touching the HDD, eliminate static electricity accumulating in your body.

• Ensure that the HDD is protected against static charge by placing disks on a antistatic mat or a conductive bag during the conversion work.

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

(1) Remove two screws xing the front panel.

(2) Slide the front panel to the left.

(3) Pull the both sides of the front panel toward you.

(4) Disconnect the connector of the cable coming out of the front panel.

Front Panel

(2)

(3)

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

Important ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

The HDDs should be installed in the correct positions in the

order as shown right. Do not skip a drive position or reverse

the order of the HDD positions. Incorrectly placed drives will

result in the recorder not recognizing the extension unit or the

drives.

HDD #1 slot : HDD1 HDD #2 slot : HDD2

HDD #3 slot : HDD3 HDD #4 slot : HDD4

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

(5) Remove six screws xing the metal plate and then remove

the metal plate.

(6) Disconnect four ATA cables and four HDD power cables

of all HDDs.

Note: When disconnecting the ATA cables, pull the pull-ring

slowly and straightforward.

(7) Remove four screws xing the HDD mounting bracket,

pull out the bracket.

HDD #2

HDD #1

HDD #4

HDD #3

Inside the front cover

Metal plate

Pull-ring

HDD mount bracket

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(8) Remove the screws (four pieces each) xing the HDDs,

the sleeves and dampers and then remove the HDDs.

(9) Remove 11 screws that x the top cover to the main unit,

and then remove the top cover.

(10) Disconnect two HDD fan connectors from the main board.

(11) Remove one screw each xing the HDD Fan Ass’y and

then remove the HDD Fan Ass’ys.

Damper

Sleeve

E31

FAN2FAN1

E30

FAN1FAN2

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(12) Remove three screws xing the power distribution board, and remove the power distribution board.

Disconnect ve connectors from the power distribution board.

(13) Remove one hexagonal spacer (30 mm) from the main board.

(14) Remove four screws each xing the HDD mounting chas-

sis, and remove two HDD mounting chassis.

(15) Disconnect the ATA cables from the main board.

(16) Remove two angle xing screws from the removed power

distribution board, and insert the insulating plate, and x it

with the two screws.

モード

RAID5

復帰

切入

HDD

電源

Power distribution board

CN100

CN103

CN102

CN104

CN105

Hexagonal spacer

モード

RAID5

復帰

切入

HDD

電源

HDD mounting chassis

ATA cables

Power distribution board

Angle ﬁxing screws

Insulating plate

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(17) Remove ve screws xing the main board, and then x

the main board with six hexagonal spacers (7 mm).

(18) Fix the S-ATA board mounting angle to the hexagonal

spacers with ve additional screws.

(19) Fix one hexagonal spacer (22 mm) to the S-ATA board

mounting angle

(20) Insert two S-ATA boards into the ATA connectors on the

main board, and x them with two screws each.

Note: Circled tapped holes on the S-ATA connector side are not

necessarily screwed.

(21) Attach eight cord clamps to the bottom of the main chassis

as shown right.

モード

RAID5

復帰

切入

HDD

電源

Two screws that ﬁxed the main board

Hexagonal spacers

(22mm)

Hexagonal spacer

six screws (7mm)

SATA board

mounting angle

SATA

board

Additional

ﬁve screws

Without

screw

210mm

100mm

70mm

Main

board

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(22) Connect four power cables to the power distribution

board.

(23) Connect the S-ATA cables and power cables to the S-ATA board as shown below.

(24) Fix the power distribution board to the main unit with three screws (one at the top, and two at the rear), and connect the connector

CN100. Pass the red power cables for HDD1 and HDD2 through a clamp, pass the S-ATA cables for HDD1(red) through two clamps,

and fasten the red power cables with a cable tie as shown below. Fasten the white power cables and the S-ATA cables for HDD2(gray)

with a cable tie as shown below.

CN105

for Power Cable

(White : Orange)

CN104

for Power Cable

(White : Purple)

CN103

for Power Cable

(Red : Yellow)

CN102

for Power Cable

(Red : Blue)

SATA HDD3

(Red )

Power cable

(Purple)

SATA HDD4

(Gray )

Power cable

(Orange)

SATA HDD1

(Red )

SATA HDD2

(Gray )

Power cable

(Yellow)

Power cable

(Blue)

CN100

Cable tie

Pass S-ATA cables (red for HDD1)

through two clamps

SATA HDD2

(Gray )

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(25) Secure the S-ATA cables to the cord clamps as shown below.

Leave the red circled areas empty to install the HDD mounting chassis.

(26) Adjust the length of S-ATA cables and secure them as shown below.

(27) Fix two HDD mounting chassis to the main unit with four

screws each from the top and two screws at front. There

are four holes on the front but use top right and bottom

left. Other two holes are used in step (34).

Take care not to pinch the S-ATA cables.

Approx. 80mm

Approx. 50mm

for HDD3

Common to left and right

for HDD4

for HDD1

for HDD2

HDD mounting chassis

S-ATA board

top right and

bottom left.

Panasonic System Solutions HDE300_SATAConversionGuide_B

WJ-HDE300 S-ATA conversion guide Maintenance guide

(28) Fix two HDD fan assemblies with one screw each, and

connect each HDD fan connector to the main board.

(29) Attach the cord clamp to the HDD3, 4 fan assembly and

secure the HDD3, 4 S-ATA cables, as shown right.

(30) Install new HDDs on the HDD mounting brackets with four screws each. Refer to the "Operating Instructions" for detail.

Notes:

When disconnecting the ATA cables, pull the pull-ring slowly and straightforward.

S-ATA HDD's do not require jumper conguration.

Install the HDD, board side facing down and the connectors pointing toward the front.

Take care not to deform the dampers when installing the HDD.

(31) Install the HDD unit in the reverse order of the removal.

モード

RAID5

復帰

切入

HDD

電源

HDD Fan Ass'y

HDD Fan Connector

Main board

Clamp

Andere Handbücher für WJHDE300 - DIGITAL DISK RECORDER

Inhaltsverzeichnis

Andere Panasonic Diktiergerät Handbücher

Panasonic

Panasonic RR-US380 Bedienungsanleitung

Panasonic

Panasonic RR-US395S Bedienungsanleitung

Panasonic

Panasonic RRQR270 Bedienungsanleitung

Panasonic

Panasonic RRXR320 - IC RECORDER Bedienungsanleitung

Panasonic

Panasonic RRQR240 - IC RECORDER Bedienungsanleitung

Panasonic

Panasonic RR-QR180 Bedienungsanleitung

Panasonic

Panasonic RR-US006 Bedienungsanleitung

Panasonic

Panasonic RR-XS400PP Bedienungsanleitung

Panasonic

Panasonic RRQR400 - IC RECORDER Bedienungsanleitung

Panasonic

Panasonic RR-DR60 Bedienungsanleitung

Panasonic

Panasonic RRQR240 - IC RECORDER Bedienungsanleitung

Panasonic

Panasonic RR-US570PP Bedienungsanleitung

Panasonic

Panasonic RR-US395PC Bedienungsanleitung

Panasonic

Panasonic WJ-ND300 Administrator Console Betriebsanleitung

Panasonic

Panasonic AG-HPD24PJ Bedienungsanleitung

Panasonic

Panasonic RR-US310 Bedienungsanleitung

Panasonic

Panasonic CJ-HDR104 Bedienungsanleitung

Panasonic

Panasonic RR-US490 Bedienungsanleitung

Panasonic

Panasonic KX-TVP150E Installationsanleitung

Panasonic

Panasonic RR-US050 Bedienungsanleitung

Panasonic

Panasonic RR-US750 Bedienungsanleitung

Panasonic

Panasonic RR-XS410 Bedienungsanleitung

Panasonic

Panasonic RR-XS450 Bedienungsanleitung

Panasonic

Panasonic PQT8531-P Bedienungsanleitung

Beliebte Diktiergerät Handbücher anderer Marken

Sony

Sony ICD-UX533F Bedienungsanleitung

RCA

RCA VR5230 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics BULLSHOOTER ENDLESS LOOP BS2C Benutzerhandbuch

Sony

Sony TCM-400DV Bedienungsanleitung

LogTag

LogTag TREL30-16 Bedienungsanleitung

SVAT

SVAT CVP800 Bedienungsanleitung

Marantz

Marantz PMD620 Bedienungsanleitung

Zoom

Zoom H4next Bedienungsanleitung

Roland

Roland BR-900CD Bedienungsanleitung

JVC

JVC ProHD GY-HMZ1U Bedienungs- und Wartungshandbuch

Sanyo

Sanyo TRC-6400 Bedienungsanleitung

Tascam

Tascam DR-07 Bedienungsanleitung

Olympus

Olympus DW-90 Bedienungsanleitung

Sanyo

Sanyo ICR-B150 Bedienungsanleitung

Korg

Korg D4 Bedienungsanleitung

Sony

Sony ICD-SX46 - Ic Recorder Bedienungsanleitung

Olympus

Olympus DIGITAL VOICE RECORDER WS-200S Montageanleitung

DVS

DVS Pronto2K Montageanleitung