Pelonis HO-0221 Bedienungsanleitung

OWNER’S MANUAL

WHOLE ROOM RADIATOR HEATER

Model: HO-0221

PLEASE READ AND SAVE THESE INSTRUCTIONS

145x210mm 单黑君 2017.5.4

THERMOSTAT

IMPORTANT INSTRUCTIONS

WARNING!

When using electrical appliances, basic precautions should

always be followed to reduce the risk of fire, electric shock, and injury to persons,

including thefollowing.

INSTRUCTIONS FOR USE AND CARE

1. Readall instructions before using heater.

2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot

surface. If provided, always use handles when moving this heater. Keep

combustible materials such as furniture, pillows, bedding, papers, clothes and

curtains at least 3 feet (0.9m) from the front of the heater and keep them away

from the sides and rear.

3. Extreme caution is necessary when any heater is used by or near children or

invalids and whenever the heater isleft operating and unattended.

4. Always unplug the heater when not in use.

5. Do not operate the heater with a damaged cord or plug, if the heater malfunctions,

has been dropped or damaged in any manner. Discard heater or return heater to

authorized service facility for examination, electrical or mechanical adjustment,

or repair.

6. Do not use the heater outdoors.

7. This heater is not intended for use in bathroom, laundry areas and similar moist

indoor locations. Never locate heater where it may fall into a bathtub or other

water container.

8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or

similar coverings. Do not route cord under furniture or appliances. Arrange cord

away from traffic areas where it can be tripped over.

9. This appliance has a polarized plug (one blade is wider than the

other). To reduce the risk of shock, this plug is intended to fit only one way in

a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician. DO NOT attempt to

defeat this safety feature. To do so could result in an electric shock hazard.

10.This heater draws 12.5 amps during operation. To prevent overloading a circuit,

do not plug the heater into a circuitthat already hasother appliances working.

11.It is normal for the plug to feel warm to the touch; however, a

loose fit between the AC outlet (receptacle) and plug may cause overheating

and distortion of the plug. Contact a qualified electrician to replace loose or

worn outlet.

12.To disconnect the heater, first turn controls to the OFFposition, then remove

plug fromoutlet. Never pull by the cord.

13.Do not insert or allow foreign objects to enter any ventilation or exhaust opening

as this may cause an electricshock or fire, or damage the heater.

14.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do

notuse on soft surface, like a bed, where openings may become blocked.

15.A heater has hot and arcing or sparking parts inside. Do not use it in the areas

where gasoline, paint, or flammable liquids are used or stored.

16.Use this heater only as described in this manual. Any other use not recommended

by the manufacturer may cause fire, electric shock, or injurytopersons.

17.Always plug heaters directly into a wall outlet/receptacle. Never use

with an extensioncord or relocatable power tap (outlet/power strip).

18.The output of this heater may vary and its temperature may become intense

enough to burn exposed skin. Use of this heater is not recommended for persons

with reduced sensitivity to heat or an inability to react to avoid burns.

19.

20.

This heater includes a caution indicator to warn that parts of the heater are getting

excessively hot. If the caution indicator light flashes, immediately turn the heater

off and inspect for any objects on or adjacent to the heater that may cause high

temperatures. DO NOT OPERATE THE HEATER WITH THE CAUTION

INDICATOR LIGHT FLASHING.

To prevent a possible fire, do not block air intakes or exhaust in any manner.

Do not use on soft surfaces, like a bed, where openings may become blocked.

SAVE THESE IMPORTANT INSTRUCTIONS FOR

EASYREFERENCE.

ASSEMBLY

Unpack your heater, take out the foam from the bottom inside the box and find the

wheel base assemblies from this foam. Refer to Fig. below:

1. Make sure the heater is unplugged and

the power switch is in the “OFF”

position.

2. TURN THE HEATER UPSIDE

DOWN.

3. Position the wheel holding plate

between thelast two fins as shown.

4. Insert the U-shape screw into the holes

of wheel holding plate.

5. Insert the butterflynuts and tight them

securely.

6. Attached another wheel holding plate

next to metal control box.

7. TURN THE HEATER UPRIGHT.

Your heater is nowready to use.

Risk of fire – Do not operate heater without wheel assemblies attached.

Operate heater in upright position only (wheels on bottom, controls on top). Any

other position could create a hazardous situation.

ELECTRICAL RATINGS

This product is rated 12.5 am

TURES

icator Light – It will illuminate when

ol – To set the comfort

itch –

s at 600 Watts of heat output

heater operates at 900 Watts of heat output

e heater operates at 1500 Watts of heat output

ps (1500W) at 120V, 60 Hz.

FEA

A Power Ind

heater is plugged in and the Power Switch is on LOW,

MED or HIGH position.

BThermostat Contr

temperature.

CPower Sw

1) LOW: The heater operate

operation.

2) MED: The

operation.

3) HIGH: Th

operation.

THERMOSTAT

Wheel holding

plate

Metal control box

Buerﬂy nuts

OPERATION

1. Check that neither the appliance nor the power cable has been damaged in any

way during transportation when first using.

2. Place the heater on a firm, level surface free from obstructions, and at least 3 ft.

(0.9m) away from any wall or combustible material.

3. With the Power Switch knob in the OFF position, plug the heater into a grounded

120V outlet. Always operate the heater in the upright position.

4. To turn the heater on, while turning the Power Switch knob clockwise to the

desired position (LOW/MED/HIGH) and turning thermostat to your desired

setting from MIN to MAX.

5. When the room reaches a comfortable temperature, slowly turn the Thermostat

Control counter-clockwise until you hear one click sounds. This is the point at

which the thermostat setting equals the room temperature. At this setting, the

thermostat will automatically turn the heater on and off to maintain this selected

temperature.

6. Turn the Power Switch knob to OFF and unplug the heater when you finish

usin

Note: This heater include a safety tip over switch, which will shut the heater off in case

it is tipped over. If at any time, the heater does tip over, please put the heater back in

the upright position (wheels on bottom, controls on top). The heater will resume its

normal operation.

g it.

RESET INSTRUCTIONS

This heater is equipped with an internal High Limit Switch which causes the unit to

stop operating in the event the internal temperature exceeds normal operating

temperatures.

IF THE UNIT SHUTS DOWN

1) TURN THE UNIT OFF

2) UNPLUG UNIT WAIT 10 MINUTES

3) PLUG IN AND TURN ON

IF YOUR HEATER FAILS TO OPERATE:

Be sure it is plugged in and that the electrical outlet is working.

Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug

the heater and wait at least ten minutes for it to cool. Carefully remove the

obstruction. Plug the heater back in and restart it as described under OPERATION.

If you still notice the same defect above mentioned, remove the plug from the

socket and have the appliance serviced by authorized service personnel only.

Check that the thermostat is not set too low. With the power switch set to a heat

setting, turn the thermostat up (clockwise) until the heaterrestarts.

CLEANING AND STORAGE

We recommend that the heater be cleaned at least once a month and before off-season

storage.

Turn the heaterOFF and unplug it. Allow it to cool.

Use a dry cloth to clean the external surfacesof the heater.

DO NOT USE WATER, WAX, POLISH OR ANY CHEMICALSOLUTION.

Clean your heater using the above-mentioned steps, then pack the heater in its

original container and store it in a cool dryplace.

The motor is factorylubricated for life,and will require no further lubrication.

SPECIFICATION

Model No.: HO-0221

Voltage: 120V, 60Hz

Current: Maximum 12.5 Amps.

Power: 1500 Watts

Tolerances on all specifications: not exceeded than 105%

SERVICE & SUPPORT

In the event of a warranty claim or if service is required for this heater, please contact us at the

following:

Toll Free: 1-866-646-4332

Email us at: [email protected]

For questions or comments, please write to:

Midea America Corporation

Customer Care Center

11411 NW 107th Street,

Suite 12

Miami, FL 33178

For your records, staple your sales receipt to this manual and record the following:

DATE OF PURCHASE: ________________________________

PLACE OF PURCHASE: ________________________________

(STAPLE SALES RECEIPT HERE)

NOTE: PROOF OF PURCHASE IS REQUIRED FOR ALL

WARRANTY CLAIMS

PRINTED IN CHINA

ONE (1) YEAR LIMITED WARRANTY

•Please read all instructions before attempting to use this product.

•Please return the Warranty Registration card within fifteen (15) days from the date of

purchasing this product.

PELONIS warrants as limited herein to the original purchaser of retail that each new Pelonis

Product, shall be free of defects in material and workmanship for a period of one (1) year from

the date of original purchase. This one (1) year warranty is limited to the heating elements,

motor, and electric control circuit board.

In the event of malfunctions or failure of your Pelonis Product, simply deliver or send the heater,

postage prepaid along with PROOF OF PURCHASE , within the warranty period of one (1) year, to

PELONIS.PELONIS reserves the right to inspect the claimed defective part or parts to determine

if the defect or malfunction complaint is covered by this warranty.PELONIS shall, within sixty

(60) days after receipt of the product, at its option,repair and/or replace the defective part or parts

free of charge. This warranty shall only cover defects arising from normal usage.PELONIS

assumes no responsibility whatsoever if Product should fail during the warranty period by

reason of:

•Misuse, negligence, physical damage or accidents.

•Lack of maintenance (see instructions for proper maintenance).

•Repair by any unauthorized party during the warranty period.

•Damage caused by connection to an improper input voltage (see specification label on

your heater).

PELONIS makes no further warranties or representations, express or implied except those

contained herein. No representative or dealer is authorized to assume any other liability

regarding the Product. The duration of the implied warranty granted under State law, including

warranties of merchantability and fitness for particular purpose are limited in duration should

the duration of the express warranty grant it hereunder.PELONIS shall in no event be liable for

direct, indirect, special or consequential damages.

Some states do not allow limitations on how long an implied warranty lasts, and/or the above

limitations or exclusion may not apply to you. This warranty gives you specific legal rights and

you may have other rights which vary from state to state.

Inhaltsverzeichnis

Andere Pelonis Heizung Handbücher

Pelonis

Pelonis CH1001 Bedienungsanleitung

Pelonis

Pelonis HF-1003 Bedienungsanleitung

Pelonis

Pelonis HC-0125D Bedienungsanleitung

Pelonis

Pelonis HO-201 Bedienungsanleitung

Pelonis

Pelonis PSH700S Bedienungsanleitung

Pelonis

Pelonis HC-461 Bedienungsanleitung

Pelonis

Pelonis HO-0280 Bedienungsanleitung

Pelonis

Pelonis NTK15A Bedienungsanleitung

Pelonis

Pelonis PSH700 Bedienungsanleitung

Pelonis

Pelonis PTH15A2BGB Bedienungsanleitung

Pelonis

Pelonis PHTPU1501 Bedienungsanleitung

Pelonis

Pelonis PFH15A2BGB Bedienungsanleitung

Pelonis

Pelonis PSH20Q3ABB Bedienungsanleitung

Pelonis

Pelonis NTH15-18MR Bedienungsanleitung

Pelonis

Pelonis HC-1010 Bedienungsanleitung

Pelonis

Pelonis PHTA8AWB Bedienungsanleitung

Pelonis

Pelonis NT15-13L Bedienungsanleitung

Pelonis

Pelonis PSH08F1ABBC Bedienungsanleitung

Pelonis

Pelonis HF-0060 Bedienungsanleitung

Pelonis

Pelonis HC-0119A Bedienungsanleitung

Pelonis

Pelonis 1500W-II Bedienungsanleitung

Pelonis

Pelonis NTY15-16LA Bedienungsanleitung

Pelonis

Pelonis HO-158E Bedienungsanleitung

Pelonis

Pelonis HF-0021 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung