Pelonis PFH15A2BGB Bedienungsanleitung
READ AND SAVE THESE INSTRUCTIONS
Attention: Pictures in the IM are for reference only.
FAN HEATER
MODEL: PFH15A2BGB
This product is only suitable for well insulated spaces or occasional use.
OWNER’S MANUAL
When using electrical appliances,basic precautions should always be followed to
reduce the risk of fire,electric shock,and injury to persons,including the following:
1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surface. If provided, always use handles when moving this heater. Keep
combustible materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them away
from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Discard heater or
return heater to authorized service facility for examination, electrical or
mechanical adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathroom, laundry areas and similar moist
indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
9. CAUTION: This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of shock, this plug is intended to fit only one way in a
polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. DO NOT attempt to defeat this
safety feature. To do so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a
circuit, do not plug the heater into a circuit that already has other appliances
working.
11. CAUTION: It is normal for the plug to feel warm to the touch; however, a loose
fit between the AC outlet (receptacle) and plug may cause overheating and
distortion of the plug. Contact a qualified electrician to replace loose or worn
outlet.
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
PART FIGURE
12. To disconnect the heater, first turn controls to off, then remove plug from
outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surface, like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to
persons.
17. CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never
use with an extension cord or reloadable power tap (outlet/power strip).
18. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
19. “SAVE THESE INSTRUCTIONS”
Control panel
Safty grill
Stand
Do not cover
Pilot lamp
Considerate Hint: The machine is equipped with a pilot lamp that glows whenever the heater is plugged in and turned on.
When the machine is in the three air flow direction of 3、4、5, if the machine is in the Heater low“ ”
it will be forced to switch to the Heater high“ ” The Machine has the following 5 kinds of air flow direction.
Manual
Air flow direction adjustment
The Machine has the following 5 kinds of air flow direction
Dispaly area
TemperationTimer Function ON/OFF
1 2 3 4 5
Considerate Hint: When making the adjustment, do not place your hand on the saftu grill, to prevent injury.
setting
Timing function
Timing stop
When the machine is turned on, press the “ ” key to enter the timing stop state
(within 0-8 hours).The timing stop time starts from 0h. Each press of the “ ” key can
increase by 1 hour. After 8h, press the “ ” key again to start from 0h.
Timing start
When the machine is in the standby mode, press the “ ” key to enter the reservation
start mode (within 0-8 hours) .The reservation start time starts from 0h. Each press of
the “ ” key can increase by 1 hour. After 8h, press the “ ” key again to start from 0h.
Temperature sensor short circuit, open circuit protection function
No matter in what mode, the temperature sensor appears short circuit or open circuit,
digital screen displays "E1" or "E2" and constantly flicker, while any key operation is
invalid and the buzzer rings 10 times.
Safety protection
1.In the start state, when the room temperature TH is above 122
°F
, close all outputs
system, The digital screen displays "FF" and flashes 1 time per second.press any
key will not work, only the power down to exit the protection.
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Start the machine
Plug the unit into a grounded 120V outlet, the power light" "on , press the
ON/OFF key “ ”for start, the machine supplies air at Heater high“ ” after start,
the Heater high light “ ”on.The digital screen displays the current set temperature,
and the set temperature defaults to the maximum temperature 95
°F that can be set.
Press the key “ ” to set the function of the machine. Repeat the “ ” key, the machine
cycles through the functions of Heater high“ ”, Heater low “ ”, Fan high “F2”, Fan
low “F1”.
Temperature setting
If the machine is in the Heater low ” ” and the Heater high “ ” , press " " can set the
temperature value,set the range of 45-95
°F
.When the room temperature exceeds the
set temperature at 4
°F
, the machine stops working, and stay in the standby state.
When the temperature is lower than the set temperature, the machine starts to heat
up again.
2.In the start state, when machine internal temperature exceeds the threshold of the
thermal cut-off, the machine will stop working, the digital screen and lamp will go out,
press any key will not work, pull off the plug manually and then insert it into the
receptacle again when the machine is cooled.
MAIN TECHNOLOGY SPECIFICATIONS
MODEL Fan low
(F1)
Fan high
(F2) ( ) ( )
POWER REGULATION RANGE (W)
PFH15A2BGB20 30
Power supply: AC 120V ~ 60Hz
Heater low Heater high
600 1500
Troubleshooting
If the product does not operate or does not operate properly, first check according to the following
list. If the reason the product does not operate or does not operate properly is not included in the
following list, the product mayhave failed. At this time, it is recommended to send the product to
the dealer for treatment.
Problem Possible Cause Solution
After the power is
engaged,the machine does
not work.
The plug may not be
plug ged well.
Check whether the plug is
properly inserted intothe
receptacle.
The machine suddenly
stops during heating.
The temperature exceeds
the threshold of the
thermal cut- o .
and then insert it into the
receptacle again when the
machine is cooled.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in
order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH
OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-
season storage.
Turn the heater “OFF”, unplug it and wait for the heater to cool down.
Use a dry cloth to clean only external surfaces of the heater.
Do not use any cleaning agents or detergents.
Never immerse the heater in water.
Pack the heater in the original carton and store it in a cool and dry place.
Inhaltsverzeichnis
Andere Pelonis Heizung Handbücher
Pelonis
Pelonis PTH21S4BRB Bedienungsanleitung
Pelonis
Pelonis HO-158E Bedienungsanleitung
Pelonis
Pelonis HC-0113 Bedienungsanleitung
Pelonis
Pelonis HF-0060 Bedienungsanleitung
Pelonis
Pelonis NTK15A Bedienungsanleitung
Pelonis
Pelonis HF-0063 Bedienungsanleitung
Pelonis
Pelonis HO-0280 Bedienungsanleitung
Pelonis
Pelonis HC-0119A Bedienungsanleitung
Pelonis
Pelonis PSH750S Bedienungsanleitung
Pelonis
Pelonis NT15-13L Bedienungsanleitung
Pelonis
Pelonis HC-0113 Bedienungsanleitung
Pelonis
Pelonis 1500W-II Bedienungsanleitung
Pelonis
Pelonis NF15-9BMB Bedienungsanleitung
Pelonis
Pelonis PSH700S Bedienungsanleitung
Pelonis
Pelonis HO-202C Bedienungsanleitung
Pelonis
Pelonis HF-0055 Bedienungsanleitung
Pelonis
Pelonis HC-1010 Bedienungsanleitung
Pelonis
Pelonis HB-215T Bedienungsanleitung
Pelonis
Pelonis HB-211 Bedienungsanleitung
Pelonis
Pelonis HF-0019 Bedienungsanleitung
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung