Philips HQ5601/16 Bedienungsanleitung

ENGLISH 4

HQ560

Warning

Please read these instructions before using the

appliance.

◗Only use the HQ800 powerplug supplied to

charge the appliance.

◗The HQ800 powerplug transforms 100-240

volts to a safe voltage lower than 24 volts.

C◗Make sure the HQ800 powerplug and the

cord do not get wet.

C◗The shaver runs at a safe low voltage of less

than 24 volts. It is watertight and can be

cleaned under the tap. Do not rinse with

water hotter than 80cC.

Charge indications

C◗As soon as you start charging the empty

shaver, the green pilot light will go on.

A fully charged shaver has a cordless shaving time

of up to 30 minutes.

Charging

Recharge, store and use the appliance at a

temperature between 5cC and 35cC.

The powerplug is suitable for mains voltages

ranging from 100 to 240V.

You cannot use the shaver when it is charging,

because the appliance does not work while the

battery is being charged.

ENGLISH4

To extend the lifetime of the battery, remove the

powerplug from the wall socket and pull the

appliance plug out of the shaver when the battery

has been fully charged.

C1Put the appliance plug in the shaver.

2Put the powerplug in the wall socket.

Do not recharge the shaver in a closed pouch.

3When charging for the first time or after a

long period of disuse: leave the shaver to

charge continuously for 12 hours.

Charging normally takes approx. 8 hours.

4Remove the powerplug from the socket

and pull the appliance plug out of the

shaver when the battery has been fully

charged.

A fully charged shaver has a cordless shaving time

of up to 30 minutes.

Shaving

1Switch the shaver on by pressing the on/off

button once.

C2Move the shaving heads quickly over your

skin, making both straight and circular

movements.

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get

accustomed to the Philishave system.

ENGLISH 5

3Switch the shaver off by pressing the on/off

button once.

C4Put the protection cap on the shaver every

time you have used it, to prevent damage.

Replace the shaving heads (type HQ53) every

2 years for optimal shaving results.

Trimming

For grooming sideburns and moustache.

C1Open the trimmer by pushing the slide

upwards.

The trimmer can be activated while the motor is

running.

Cleaning

The easiest and most hygienic way to clean the

appliance is to rinse the shaving unit and the hair

chamber every day with hot water (60cC-80cC).

Regular cleaning guarantees better shaving

performance.

When you clean the appliance, it is not necessary

to take the shaving heads (cutters and guards)

apart. If you want to take them apart, be sure not

to mix up the cutters and guards, since grinding of

the cutters in the guards only guarantees optimal

performance for each matching set. If you

accidentally mix up the sets, it could take several

weeks before optimal shaving performance is

restored.

ENGLISH6

C◗For easy and optimal cleaning, the Philishave

Action Clean (shaving head cleaner, type

HQ100) is available.Ask your Philishave dealer

for information.

Every day: Shaving unit

1Switch the shaver off, remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

C2Press the release button and open the

shaving unit.

C3Rinse the shaving unit and the hair

chamber with hot water (60cC - 80cC).

Do not clean under the tap while charging the

shaver.

C4Rinse the outside of the appliance.

Never dry the shaving unit with a towel or tissue

as this may damage the shaving heads.

◗You can also clean the hair chamber without

water by using the brush supplied.

Every six months:Trimmer

1Switch the shaver off, remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

ENGLISH 7

C2Brush the trimmer.

C3Lubricate the trimmer teeth with a drop

of sewing machine oil every six months.

Replacing the shaving heads

Replace the shaving heads every two years for

optimal shaving results.

1Switch the shaver off, remove the

powerplug from the socket and pull the

appliance plug out of the shaver.

C2Press the release button to open the

shaving unit.

C3Turn the wheel counter-clockwise and

remove the retaining frame.

C4Remove the shaving heads and place the

new ones in the shaving unit.

ENGLISH8

OIL

C5Reassemble the shaving unit by replacing

the retaining frame. Press the wheel and

turn it clockwise.

Replace damaged or worn shaving heads with

Philishave HQ53 shaving heads only.

Storing

C◗Put the protection cap on the shaver to

prevent damage.

◗Store the powerplug and the shaver in the

pouch.

Disposal of the battery

The built-in rechargeable battery contains

substances that may pollute the environment.

Remove the battery when you discard the

appliance. Do not throw the battery away with

the normal household waste, but hand it in at an

official collection point.You can also take the

battery to a Philips Service Centre, which will

dispose of it in an environmentally safe way.

Only remove the battery if it is completely empty.

1Remove the powerplug from the socket

and pull the appliance plug out of the

shaver.

C2Let the shaver run until it stops, undo the

screws and open the shaver.

ENGLISH 9

3Remove the battery.

Do not connect the shaver to the mains again

after the battery has been removed.

Troubleshooting

1Reduced shaving performance.

BCause 1: the shaving heads are dirty.

◗The shaver has not been rinsed long enough

or the water used was not hot enough.

◗Clean the shaver thoroughly before you

continue shaving (see 'Cleaning').

BCause 2: long hairs are obstructing the shaving

heads.

C◗Remove the retaining plate.

C◗Clean the cutters and guards.

Do not clean more than one cutter and guard at

a time, since they are all matching sets. If you

accidentally mix up the cutters and guards, it may

take several weeks before optimal shaving

performance is restored.

◗Remove the hairs with the brush supplied.

◗Put the retaining plate back onto the shaving

unit.

BCause 3: shaving heads are damaged or worn.

ENGLISH10

◗Remove the retaining plate.

◗Remove the old shaving heads from the

shaving unit and replace them with new ones.

Damaged or worn shaving heads (cutters and

guards) must only be replaced with the original

Philishave HQ53 shaving heads.

◗Put the retaining plate back onto the shaving

unit.

2The shaver does not work when the

ON/OFF button is pressed.

BCause: the battery is empty.

BCause: the shaver is connected to the mains.This

shaver does not work while the battery is being

charged.

3In case of other problems:

◗See 'Information & service'.

Accessories

The following accessories are available:

- Philishave HQ53 shaving heads.

- HQ8000 powerplug.

- HQ100 Philishave Action Clean (shaving head

cleaner).

- HQ101 Philishave Action Clean refill (shaving

head cleaning liquid).

- HQ110 Philishave shaving head cleaner (shaving

head cleaning spray).

ENGLISH 11

Information & service

If you need information or if you have a

problem, please visit the Philips Web site at

www.philips.com or contact the Philips Customer

Care Centre in your country (you will find its

phone number in the worldwide guarantee

leaflet). If there is no Customer Care Centre in

your country, turn to your local Philips dealer or

contact the Service Department of Philips

Domestic Appliances and Personal Care BV.

◗Keep these instructions for use for future

reference.

ENGLISH12

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Philips Elektrorasierer Handbücher

Philips

Philips HQ 8870 Bedienungsanleitung

Philips

Philips PT866 Bedienungsanleitung

Philips

Philips S131 Series Bedienungsanleitung

Philips

Philips 8240XL Bedienungsanleitung

Philips

Philips Norelco AccuVac T770 Bedienungsanleitung

Philips

Philips S5330/12 Bedienungsanleitung

Philips

Philips S1223 Bedienungsanleitung

Philips

Philips SensoTouch RQ 1175/32 Bedienungsanleitung

Philips

Philips HQ5812 Bedienungsanleitung

Philips

Philips HQ 8870 Bedienungsanleitung

Philips

Philips AT941 Bedienungsanleitung

Philips

Philips S8870 Bedienungsanleitung

Philips

Philips HQ 8894 Bedienungsanleitung

Philips

Philips PT920/18 Bedienungsanleitung

Philips

Philips S93 series Bedienungsanleitung

Philips

Philips Norelco QT4019 Montageanleitung

Philips

Philips Norelco S9721 Bedienungsanleitung

Philips

Philips HQ489/24 Bedienungsanleitung

Philips

Philips Norelco S8950 Bedienungsanleitung

Philips

Philips qc5360 Bedienungsanleitung

Philips

Philips HP6393 Bedienungsanleitung

Philips

Philips NORELCO S5000 Bedienungsanleitung

Philips

Philips RQ1260 Bedienungsanleitung

Philips

Philips HQT788 Bedienungsanleitung

Beliebte Elektrorasierer Handbücher anderer Marken

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung

CTC Union

CTC Union Clatronic HSM 3441 NE Bedienungsanleitung

Remington

Remington XR7000 Bedienungsanleitung

Eldom

Eldom G47 Bedienungsanleitung

Braun

Braun silk-epil 5 Bedienungsanleitung

SEVERIN

SEVERIN SÉRIE E700 0533 Benutzerhandbuch

Remington

Remington PR1355 Bedienungsanleitung

Aurora

Aurora AU 3543 Bedienungsanleitung

Braun

Braun InterFace 3614 Bedienungsanleitung

Wahl

Wahl 8061 5-STAR Bedienungsanleitung

Norelco

Norelco 4404LC Bedienungsanleitung