Philips HQ9170 Bedienungsanleitung

HQ9190, HQ9171, HQ9170

ENGLISH 4

INDONESIA 20

한국어 36

BAHASA MELAYU 52

ภาษาไทย 68

 82

繁體中文 97

简体中文 112

Important

Read these instructions for use carefully before using

the appliance and save them for future reference.

Only use the powerplug supplied.

The powerplug transforms 100-240 volts to a safe

low voltage of less than 24 volts.

The powerplug contains a transformer. Do not cut

off the powerplug to replace it with another plug,

as this will cause a hazardous situation.

Do not use a damaged powerplug.

If the powerplug is damaged, always have it

replaced by one of the original type in order to

avoid a hazard.

Make sure the powerplug does not get wet.

Charge and store the appliance at a temperature

between 5 cC and 35 cC.

Never immerse the charging stand in water nor

rinse it under the tap.

Do not recharge the shaver in a closed pouch.

Always unplug the shaver before cleaning it under

the tap.

The appliance complies with the internationally

approved IEC safety regulations and can be safely

cleaned under the tap.

Be careful with hot water. Always check if the water

is not too hot, to prevent your hands from getting

burnt.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and in accordance with the instructions in

this instruction manual, the appliance is safe to use

according to scientic evidence available today.

ENGLISH

The display

This appliance offers you the unique possibility to

choose the display layout you prefer: a number

layout or a battery symbol layout.

1 Press the on/off button approx. 3 seconds to

enter the menu.

The menu has three different modes: the travel lock

mode and two display layout modes.

You will enter the menu in the travel lock mode,

indicated by a rotating key symbol.

You can scroll through the three modes (travel

lock, battery symbol layout and number layout) by

pressing the on/off button briey in quick succession.

2 To select one of the two display layouts, stop

pressing the on/off button when the layout you

prefer appears on the display.

3 Wait a few seconds without pressing the on/off

button until you hear a beep.

This beep indicates that the display has been set to

the selected layout.

Note:The rst mode you enter after pressing the on/off

button for 3 seconds is the travel lock mode (indicated

by a rotating key symbol). If you do not press the on/off

button again within a few seconds, the travel lock is

activated and the display will not switch to the rst

display layout mode. To deactivate the travel lock, press

the on/off button for 3 seconds again (see chapter

‘Storage’).

You can change the display layout at any time.

Note:When you start using the appliance for the rst

time or after a long period of disuse, it could take

several minutes before anything appears on the display.

ENGLISH 5

The display provides the following

information:

Charging

Number layout:

When the shaver is being charged, the display shows

the minutes indication and the plug symbol with a

blinking power symbol.

Battery symbol layout:

When the shaver is being charged, the display shows

the battery symbol and the plug symbol with a

blinking power symbol.

Battery fully charged

As soon as the battery has been fully charged,

the word FULL runs across the display.

After a few hours the word FULL stops

appearing.The display shows the minutes

indication and the plug symbol.

Battery running low

Number layout:

When the battery is running low, the display shows a

blinking minutes indication and blinking plug symbol

when you switch the shaver off. HQ9190 only: you

will also hear a few short beeps.

Battery symbol layout:

When the battery is running low, the display shows

a blinking battery symbol and blinking plug symbol

when you switch the shaver off. HQ9190 only: you

will also hear a few short beeps.

ENGLISH6

Battery empty

To indicate that the battery voltage is too low to

operate the appliance, LO appears on the display.

Recharge the battery. See chapter ‘Charging’.

Cleaning shaver

When the shaver is due to be cleaned, the tap

symbol with blinking water drops appears on the

display.

Replacing shaving heads

When the shaving heads need to be replaced

(every two years), the shaving unit symbol starts

blinking when you switch the shaver off. HQ9190

only: at the same time you will hear a beep.

If you do not replace the shaving heads right away,

the shaving unit symbol remains visible during the

next 7 shaves.

You can reset the appliance by pressing the

on/off button for 3 seconds while the shaving unit

symbol is blinking.The shaving unit symbol then

disappears. HQ9190 only: you will hear a short

conrming beep.

If you have not reset the system after these 7

shaves, the system will automatically reset itself.

Demonstration program

The appliance has a unique demonstration program.

Press the on/off button for 6 seconds.

After 3 seconds the lock symbol appears; keep the

on/off button pressed.

The demonstration will start automatically.

During the demonstration the appliance will be

ENGLISH 7

automatically switched on 2 times.You can interrupt

the demonstration by pressing the on/off button.

Charging

Make sure the appliance is switched off before you

start charging it.

Charging normally takes approx. 1 hour.

You can also shave without charging by connecting

the shaver to the mains.

A fully charged shaver has a cordless shaving time of

up to 30 days.

Charging the appliance

1 Put the appliance plug in the shaver.

2 Put the powerplug in the wall socket.

3 Remove the powerplug from the wall socket

and pull the appliance plug out of the shaver

when the battery has been fully charged.

Charging stand

You can also charge the appliance by placing it in

the charging stand.

1 Place the shaver properly in the plugged-in

charging stand.

2 Lift the shaver from the stand without tilting it.

ENGLISH8

Removing and inserting the clock

1 Turn the clock anticlockwise (1) (‘click’) and

pull it out (2).

2 Insert the clock (1) and turn it clockwise (2)

(‘click’).

Setting the time

1 Set the time by pressing the small button at the

back of the clock.

The time can only be set forward.

Replacing the battery

1 Remove the cap.Then remove the battery by

means of a miniature screwdriver.

2 Insert a new battery and put the cap back into

place.

ENGLISH 9

Using the appliance

Personal Comfort Control

The Personal Comfort Control system allows

you to adapt the shaver to your skin type.

You can set the shaver to ‘Normal’ for a fast and

comfortable close shave.

You can set the shaver to ‘Sensitive’ for a

comfortable close shave with optimal skin

comfort.

The ‘S’ position is best suited for sensitive skin.

The ‘N’ position is best suited for normal skin.

The in-between positions are suitable for skin

types between normal and sensitive.

HQ9190 only: the display shows the position

selected.

Shaving

1 Switch the shaver on by pressing the on/off

button once.

ENGLISH10

When you switch the shaver on or off, all lights

and symbols go on and then the remaining battery

capacity is shown for a few seconds.

2 Move the shaving heads quickly over your skin,

making both straight and circular movements.

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

3 Switch the shaver off by pressing the on/off

button once.

4 Put the protection cap on the shaver every

time you have used it, to prevent damage.

Trimming

For grooming sideburns and moustache.

1 Open the trimmer by pushing the slide

downwards.

The trimmer can be activated while the motor is

running.

2 Closethetrimmerwithyourindexnger.

Cleaning and maintenance

Clean the shaver when the tap symbol with blinking

water drops appears on the display.

Regular cleaning guarantees better shaving

performance.

ENGLISH 11

The normal way to clean the appliance is to rinse

the shaving unit and the hair chamber with hot

water every time you have used the shaver.

Be careful with hot water.Always check if the

water is not too hot, to prevent your hands from

getting burnt.

Every day: shaving unit and hair chamber

1 Switch the shaver off, remove the powerplug

from the wall socket and pull the appliance plug

out of the shaver.

2 Press the release button to open the shaving

unit.

3 Clean the shaving unit and the hair chamber by

rinsing them under a hot tap for some time.

Make sure the inside of the shaving unit and the hair

chamber have been cleaned properly.

4 Rinse the outside of the appliance.

5 Close the shaving unit and shake off excess

water.

Never dry the shaving unit with a towel or tissue,

as this may damage the shaving heads.

6 Open the shaving unit again and leave it open

to let the appliance dry completely.

You can also clean the hair chamber without water

by using the brush supplied.

ENGLISH12

Andere Handbücher für HQ9170

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Philips Elektrorasierer Handbücher

Philips

Philips S5000 series Bedienungsanleitung

Philips

Philips 7310XL Bedienungsanleitung

Philips

Philips Essence 5000 Series Betriebsanleitung

Philips

Philips PQ227 Bedienungsanleitung

Philips

Philips HP6341/00 Bedienungsanleitung

Philips

Philips Norelco S7720 Bedienungsanleitung

Philips

Philips QuadraAction 7825XL Bedienungsanleitung

Philips

Philips PQ208 Bedienungsanleitung

Philips

Philips HQ9140 Bedienungsanleitung

Philips

Philips Norelco MG7750/49 Bedienungsanleitung

Philips

Philips SW5700/07 Bedienungsanleitung

Philips

Philips HQ42/15 Bedienungsanleitung

Philips

Philips AT7 SERIES Bedienungsanleitung

Philips

Philips HQ6423 Bedienungsanleitung

Philips

Philips HQ6830/A Bedienungsanleitung

Philips

Philips HQ6645 Bedienungsanleitung

Philips

Philips Norelco Beardtrimmer 3000 Bedienungsanleitung

Philips

Philips S100 Series Bedienungsanleitung

Philips

Philips HP6335 Bedienungsanleitung

Philips

Philips HQ6 Bedienungsanleitung

Philips

Philips QUASAR HQ9100 Bedienungsanleitung

Philips

Philips Headgroom QC5570/32 Bedienungsanleitung

Philips

Philips Norelco 7180XL Bedienungsanleitung

Philips

Philips QT4015 Bedienungsanleitung

Beliebte Elektrorasierer Handbücher anderer Marken

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung

Remington

Remington XR7000 Bedienungsanleitung

Braun

Braun silk-epil 5 Bedienungsanleitung

SEVERIN

SEVERIN SÉRIE E700 0533 Benutzerhandbuch

Remington

Remington PR1355 Bedienungsanleitung

Aurora

Aurora AU 3543 Bedienungsanleitung

Braun

Braun InterFace 3614 Bedienungsanleitung

Wahl

Wahl 8061 5-STAR Bedienungsanleitung

Norelco

Norelco 4404LC Bedienungsanleitung

Panasonic

Panasonic ER-GN30 Bedienungsanleitung

Remington

Remington AQ7 WETECH Bedienungsanleitung