Philips Philishave HQ 642 Bedienungsanleitung

ENGLISH 4

DEUTSCH 12

FRANÇAIS 20

NEDERLANDS 28

ESPAÑOL 36

ITALIANO 45

PORTUGUÊS 53

TÜRKÇE 61

HQ642

Important

Read these instructions for use carefully before

using the appliance and save them for future

reference.

◗Only use the powerplug supplied to connect

the appliance to the mains.

◗If the powerplug is damaged,always have it

replaced by one of the original type in order

to avoid a hazard.

◗The powerplug transforms 220-240 volts to a

safe low voltage of less than 24 volts.Only the

powerplug supplied guarantees safe

transformation.

◗The powerplug contains a transformer.Do

not cut off the powerplug to replace it with

another plug,as this will cause a hazardous

situation.

C◗Make sure the powerplug does not get wet.

C◗The appliance complies with the

internationally approved IEC safety regulations

and can be safely cleaned under the tap.

Be careful with hot water.Always check if the

water is not too hot,to prevent your hands from

getting burnt.

ENGLISH4

Using the appliance

Shaving

C1Put the appliance plug in the shaver.

2Put the powerplug in the wall socket.

3Switch the shaver on by pressing the on/off

button once.

C◗The green pilot light goes on.

C4Move the shaving heads quickly over your

skin,making both straight and circular

movements.

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get

accustomed to the Philishave system.

5Switch the shaver off by pressing the on/off

button once.

C6Put the protection cap on the shaver every

time you have used it,to prevent damage.

ENGLISH 5

Trimming

For grooming sideburns and moustache.

C1Open the trimmer by pushing the slide

upwards.

The trimmer can be activated while the motor is

running.

Cleaning and maintenance

Regular cleaning guarantees better shaving

performance.

Be careful with hot water.Always check if the

water is not too hot,to prevent your hands from

getting burnt.

C◗For easy and optimal cleaning,the Philishave

Action Clean (shaving head cleaner,type

HQ100) is available.Ask your Philishave dealer

for information.

BThe PhilishaveAction Clean may not be available

in all countries.Contact the Customer Care Centre

in your country about the availability of this

accessory.

Shaving unit

When you clean the appliance,it is not necessary

to take the shaving heads (cutters and guards)

apart.If you want to take them apart, be sure not

to mix up the cutters and guards,since grinding of

ENGLISH6

the cutters in the guards only guarantees optimal

performance for each matching set.If you

accidentally mix up the sets,it could take several

weeks before optimal shaving performance is

restored.

The easiest and most hygienic way to clean the

appliance is to rinse the shaving unit and the hair

chamber with hot water every time you have

used the appliance.

1Switch the shaver off,remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

C2Press the release button to open the

shaving unit.

C3Clean the shaving unit and the hair

chamber by rinsing them under a hot tap

for some time.

4Close the shaving unit and shake off excess

water.

Never dry the shaving unit with a towel or tissue

as this may damage the shaving heads.

C5Open the shaving unit again and leave it

open to let the appliance dry completely.

◗You can also clean the hair chamber without

water by using the brush supplied.

ENGLISH 7

Trimmer

Clean the trimmer every time you have used it.

1Switch the shaver off,remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

C2Clean the trimmer with the brush

supplied.

C3Lubricate the trimmer teeth with a drop

of sewing machine oil every six months.

Storage

C◗Put the protection cap on the shaver to

prevent damage.

◗Store the shaver in the pouch.

Replacement

Replace the shaving heads every 2 years for

optimal shaving results.

Replace damaged or worn shaving heads with

HQ6 Philishave Quadra shaving heads only.

ENGLISH8

OIL

1Switch the shaver off,remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

C2Press the release button to open the

shaving unit.

C3Turn the wheel anticlockwise (1) and

remove the retaining frame (2).

C4Remove the shaving heads and place new

ones in the shaving unit in such a way that

the projections fit exactly into the

recesses in the shaving unit.

5Put the retaining frame back into the

shaving unit,press the wheel and turn it

clockwise.

6Close the shaving unit.

C◗If the shaving heads have been properly

inserted,the shiny parts are pointing inwards

and towards each other.

Accessories

The following accessories are available:

- HQ8000 powerplug.

- HQ6 Philishave Quadra shaving heads.

ENGLISH 9

- HQ100 Philishave Action Clean

(shaving head cleaner).

- HQ101 Philishave Action Clean refill

(shaving head cleaning liquid).

- HQ110 Philishave shaving head cleaner

(shaving head cleaning spray).

Guarantee & service

If you need information or if you have a problem,

please visit the PhilipsWeb site at

www.philips.com or contact the Philips Customer

Care Centre in your country (you will find its

phone number in the worldwide guarantee

leaflet).If there is no Customer Care Centre in

your country,turn to your local Philips dealer or

contact the Service Department of Philips

Domestic Appliances and Personal Care BV.

Troubleshooting

1Reduced shaving performance

BCause 1:the shaving heads are dirty.The shaver

has not been rinsed long enough or the water

used was not hot enough.

◗Clean the shaver thoroughly before you

continue shaving (See chapter 'Cleaning and

maintenance').

BCause 2:long hairs are obstructing the shaving

heads.

ENGLISH10

C◗Remove the retaining frame from the shaving

unit by turning the wheel anticlockwise.

◗Remove the shaving heads from the shaving

unit.

C◗Remove the hairs from the cutters and the

guards with the brush supplied.

Do not clean more than one cutter and guard at

a time,since they are all matching sets.If you

accidentally mix up the cutters and guards,it

could take several weeks before optimal shaving

performance is restored.

◗Put the shaving heads back into the shaving

unit.Put the retaining frame back into the

shaving unit,press the wheel and turn it

clockwise.

BCause 3:the shaving heads are damaged or worn.

◗Remove the retaining frame.

◗Remove the old shaving heads from the

shaving unit and replace them with new ones.

Damaged or worn shaving heads (cutters and

guards) may only be replaced with original HQ6

Philishave Quadra shaving heads.

◗Put the retaining frame back into the shaving

unit,press the wheel and turn it clockwise.

ENGLISH 11

Wichtig

Lesen Sie diese Bedienungsanleitung vor der

ersten Benutzung des Geräts sorgfältig durch und

bewahren Sie sie zur späteren Einsichtnahme auf.

◗Schließen Sie das Gerät nur mit dem

mitgelieferten Netzteil an das Stromnetz an.

◗Ist das Netzteil defekt,muss es aus

Sicherheitsgründen durch ein Original-

Ersatznetzteil ausgetauscht werden.

◗Das Netzteil wandelt Netzspannungen von

220 bis 240Volt in eine sichere

Betriebsspannung von weniger als 24Volt um.

Nur mit dem mitgelieferten Netzteil ist eine

sichere Spannungsumwandlung gewährleistet.

◗Das Netzteil enthält einenTransformator.

Ersetzen Sie das Netzteil keinesfalls durch

einen anderen Stecker,da dies den Benutzer

gefährdet.

C◗Achten Sie darauf,dass das Netzteil nicht nass

wird.

C◗Das Gerät erfüllt die internationalen IEC

Sicherheitsvorschriften und kann ohne

Bedenken unter fließendemWasser gereinigt

werden.

Gehen Sie vorsichtig mit heißemWasser um.

Achten Sie darauf, dass dasWasser nicht zu heiß

ist und Sie sich nicht die Hände verbrühen.

DEUTSCH12

Andere Handbücher für Philishave HQ 642

Inhaltsverzeichnis

Sprachen:

Andere Philips Elektrorasierer Handbücher

Philips

Philips QG3340 Bedienungsanleitung

Philips

Philips HQ9190 Bedienungsanleitung

Philips

Philips BG1025 Bedienungsanleitung

Philips

Philips OneBlade Pro Face QP6520/25 Bedienungsanleitung

Philips

Philips Norelco 6617X/43 Bedienungsanleitung

Philips

Philips Norelco SmartTouch-XL 9170XLCC Bedienungsanleitung

Philips

Philips BG2024 Bedienungsanleitung

Philips

Philips S9531 Bedienungsanleitung

Philips

Philips Philishave QT4020 Bedienungsanleitung

Philips

Philips HQ9160 Bedienungsanleitung

Philips

Philips RQ1100 Series Bedienungsanleitung

Philips

Philips HQ8170 Bedienungsanleitung

Philips

Philips Norelco QT4019 Bedienungsanleitung

Philips

Philips RQ1095 Bedienungsanleitung

Philips

Philips HQ-T 788 Bedienungsanleitung

Philips

Philips 3000 series Bedienungsanleitung

Philips

Philips BT1216 Bedienungsanleitung

Philips

Philips RQ1085 Bedienungsanleitung

Philips

Philips Norelco MG3750 Bedienungsanleitung

Philips

Philips Cool Skin HQ6707 Bedienungsanleitung

Philips

Philips S1223 Bedienungsanleitung

Philips

Philips HQ6830/A Bedienungsanleitung

Philips

Philips HQ7390/16 Bedienungsanleitung

Philips

Philips HP6391 Handbuch

Beliebte Elektrorasierer Handbücher anderer Marken

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung

Remington

Remington XR7000 Bedienungsanleitung

Braun

Braun silk-epil 5 Bedienungsanleitung

SEVERIN

SEVERIN SÉRIE E700 0533 Benutzerhandbuch

Remington

Remington PR1355 Bedienungsanleitung

Aurora

Aurora AU 3543 Bedienungsanleitung

Braun

Braun InterFace 3614 Bedienungsanleitung

Wahl

Wahl 8061 5-STAR Bedienungsanleitung

Norelco

Norelco 4404LC Bedienungsanleitung

Panasonic

Panasonic ER-GN30 Bedienungsanleitung

Remington

Remington AQ7 WETECH Bedienungsanleitung