Philips QT4015 Bedienungsanleitung

Always here to help you

www.philips.com/welcome

User manual

QT4015

ENGLISH 4

 11

 18

EESTI 25

 32

 39

 46

 53

 60

 67

 74

 81

 88

 95

 102

 109

Introduction

Congratulations on your purchase and welcome to Philips!To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

1 Trimming comb

2 Cutting unit

3 Precision Zoom Lock™ adjustment ring

4 On/off slide with battery indicator

5 Socket for appliance plug

6 Pouch

7 Brush

8 Appliance plug

9 Adapter

Important

Read this user manual carefully before you use the appliance and save it for

future reference.

Danger

- Make sure the adapter does not get wet.

Warning

- The adapter contains a transformer. Do not cut off the adapter to

replace it with another plug, as this causes a hazardous situation.

- This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure that they do not play with the

appliance.

Caution

- Never immerse the appliance in water or rinse it under the tap.

Only the cutting unit can be rinsed under the tap.

- Use, charge and store the appliance at a temperature between 5°C

and 35°C.

- Only use the adapter supplied.

- If the adapter is damaged, always have it replaced with one of the

original type in order to avoid a hazard.

- This appliance is only intended for trimming the human beard. Do not

use it for any other purpose.

- Do not use the appliance if the cutting unit or the trimming comb is

damaged or broken, as this may cause injury.



This Philips appliance complies with all standards regarding electromagnetic

elds (EMF). If handled properly and according to the instructions in this

user manual, the appliance is safe to use based on scientic evidence

available today.

ENGLISH

General

- The appliance is equipped with an automatic voltage selector and is

suitable for mains voltages from 100 to 240 volts.

- The adapter transforms 100-240 volts to a safe low voltage of less than

24 volts.

Charging

Charge the appliance fully before you use it for the rst time.

It takes approximately 1 hour to fully charge the appliance.

When it is fully charged, the appliance has a cordless operating time of up

to 60 minutes.

Note:You can use the appliance cordless as well as connected to the mains.

1 Make sure the appliance is switched off.

2 Insert the appliance plug into the appliance.

3 Put the adapter in the wall socket.

,The charging light starts to ash green to indicate that the appliance

is charging.

,When the battery is fully charged, the charging light lights up green

continuously.After 30 minutes, the charging light goes out.

4 After charging, remove the adapter from the wall socket and pull the

appliance plug out of the appliance.

Battery low

When the battery is almost empty (when there are only 5 or fewer

trimming minutes left), the charging light ashes orange.

Optimising the lifetime of the rechargeable battery

When you have charged the appliance for the rst time, we advise you to

use it until the battery is completely empty. Continue to use the appliance

until the motor almost stops running during a session.Then recharge the

battery. Follow this procedure at least twice a year.

Using the appliance

Always comb the beard and/or moustache with a ne comb before you

start trimming.

When you trim for the rst time, be careful. Do not move the trimmer

too fast. Make smooth and gentle movements.

ENGLISH 5

Trimming with comb

1 Turn the Precision Zoom Lock™adjustment ring to the

desired setting.The selected setting is the setting in the centre of the

adjustment ring.

See the table below for an overview of the settings and the resulting hair

lengths.

Setting Resulting hair length Setting Resulting hair length

. 0.5mm . 5.5mm

1 1mm 6 6mm

. 1.5mm . 6.5mm

2 2mm 7 7mm

. 2.5mm . 7.5mm

3 3mm 8 8mm

. 3.5mm . 8.5mm

4 4mm 9 9mm

. 4.5mm . 9.5mm

5 5mm 10 10mm

Note: When you trim for the rst time, start at the highest setting (10) to

familiarise yourself with the appliance.

2 Switch on the appliance.

3 To trim most effectively, move the trimmer against the hair growth

direction. Make sure the surface of the comb always stays in contact

with the skin.

4 If a lot of hair has accumulated in the beard trimming comb,

remove the comb and blow and/or shake the hair out of it.

The selected setting does not change when you do this.

3•

4••1

ENGLISH6

Trimming at the unique ‘stubble look’ setting

1 To create a ‘stubble look’, trim with the beard trimming comb set

to setting 1.

Trimming without comb

Use the trimmer without beard trimming comb to trim full beards and

single hairs.

Be careful when you trim without comb because the cutting

element removes every hair it touches.

1 Pull the beard trimming comb off the appliance as shown in gure 8.

2 Switch on the appliance.

3 Make well-controlled movements.Touch the hair lightly with the

trimmer.

Corded trimming

If the battery is low, you can also use the appliance from the mains:

1 Switch off the appliance, insert the adapter in the wall socket and

wait a few seconds before you switch on the appliance.

Cleaning

Never use scouring pads, abrasive cleaning agents or aggressive liquids

such as alcohol, petrol or acetone to clean the appliance.

1 Make sure the appliance is switched off and disconnected from the

mains.

2 Wipe the housing of the appliance with a dry cloth.

Never immerse the appliance in water or rinse it under the tap.

3 Remove the trimming comb and clean it with the brush.

ENGLISH 7

4 Remove the cutting unit by pushing against the teeth of the cutting

unit and clean it with the brush or rinse it under the tap.

5 Shake off excess water and place the cutting unit back by inserting

the lug of the cutting unit into the guiding slot.

6 Push the cutting unit back onto the appliance (‘click’).

Replacement

Only replace a worn or damaged cutting unit with an original Philips cutting

unit, available from authorised Philips service centres.

1 Open the cutting unit.

2 Remove the old cutting unit by pushing against the teeth of the

cutting unit.

3 Insert the lug of the new cutting unit into the guiding slot.

4 Push the cutting unit back onto the appliance (‘click’).

ENGLISH8

Ordering accessories

To purchase accessories for this appliance, please visit our online shop at

www.shop.philips.com/service. If the online shop is not available in

your country, go to your Philips dealer or a Philips service centre. If you

have any difculties obtaining accessories for your appliance, please contact

the Philips Consumer Care Centre in your country. You nd its contact

details in the worldwide guarantee leaet.

Environment

- Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the environment.

- The built-in rechargeable battery contains substances that may pollute

the environment.Always remove the battery before you discard and

hand in the appliance at an ofcial collection point. Dispose of the

battery at an ofcial collection point for batteries. If you have trouble

removing the battery, you can also take the appliance to a Philips

service centre.The staff of this centre will remove the battery for you

and will dispose of it in an environmentally safe way.

Removing the rechargeable batteries

Only remove the rechargeable batteries if they are completely empty.

1 Disconnect the appliance from the mains and let the appliance run

until the motor stops.

2 Insert a screwdriver in the hair chamber to separate the housing

part.

3 Cut the wires close to the batteries with a pair of household

scissors.

ENGLISH 9

4 Remove the printed circuit board with the rechargeable batteries.

5 Cut the battery tabs with a pair of scissors and separate the

batteries from the printed circuit board.

Do not connect the appliance to the mains again after you have opened it.

Guarantee and service

If you need service or information or if you have a problem, please visit

the Philips website at www.philips.com/support or contact the Philips

Consumer Care Centre in your country. You nd its phone number in the

worldwide guarantee leaet. If there is no Consumer Care Centre in your

country, go to your local Philips dealer.

ENGLISH10

Andere Handbücher für QT4015

Inhaltsverzeichnis

Andere Philips Elektrorasierer Handbücher

Philips

Philips RQ1053/18 Bedienungsanleitung

Philips

Philips S91 series Bedienungsanleitung

Philips

Philips S5391/12 Bedienungsanleitung

Philips

Philips HQ4819/16 Bedienungsanleitung

Philips

Philips S5000 series Bedienungsanleitung

Philips

Philips HP 1131 Bedienungsanleitung

Philips

Philips 3000 series Bedienungsanleitung

Philips

Philips S100 Series Bedienungsanleitung

Philips

Philips HQ20/01 Bedienungsanleitung

Philips

Philips Norelco 7180XL Bedienungsanleitung

Philips

Philips NORELCO BT5210 Bedienungsanleitung

Philips

Philips PQ208 Bedienungsanleitung

Philips

Philips BG102 Series Abmessungen

Philips

Philips HQ 7615 Bedienungsanleitung

Philips

Philips 3000 series Bedienungsanleitung

Philips

Philips RQ1090 Bedienungsanleitung

Philips

Philips XZ5800 Bedienungsanleitung

Philips

Philips HQ8251 Bedienungsanleitung

Philips

Philips 55PUT7032/56 Bedienungsanleitung

Philips

Philips BT7206 Bedienungsanleitung

Philips

Philips Styleshaver Pro QS6140 Bedienungsanleitung

Philips

Philips 9160XL Bedienungsanleitung

Philips

Philips SENSOTEC HQ8893 Bedienungsanleitung

Philips

Philips HQ4846/16 Bedienungsanleitung

Beliebte Elektrorasierer Handbücher anderer Marken

Norelco

Norelco Quadra 7610X Bedienungsanleitung

Braun

Braun WaterFlex WF2s Bedienungsanleitung

Daga

Daga MT-400 Handbuch

Remington

Remington BHT100 Bedienungsanleitung

Kompernass

Kompernass KH 5537 Bedienungsanleitung

Remington

Remington BHT6100 Bedienungsanleitung

MIA

MIA Aqua Body Bedienungsanleitung

Matheo

Matheo MLR 15 Bedienungsanleitung

CTC Union

CTC Union Clatronic HSM 3441 NE Bedienungsanleitung

Remington

Remington XR7000 Bedienungsanleitung

Eldom

Eldom G47 Bedienungsanleitung

Braun

Braun silk-epil 5 Bedienungsanleitung

SEVERIN

SEVERIN SÉRIE E700 0533 Benutzerhandbuch

Remington

Remington PR1355 Bedienungsanleitung

Aurora

Aurora AU 3543 Bedienungsanleitung

Braun

Braun InterFace 3614 Bedienungsanleitung

Wahl

Wahl 8061 5-STAR Bedienungsanleitung

Norelco

Norelco 4404LC Bedienungsanleitung