Pioneer DVD / CD WRITER Bedienungsanleitung

DVD / CD WRITER

LECTEUR DE DVD / CD

GRABADORA DE DISCOS DVD Y CD

DVR-A07

Operating Instructions

Mode d’emploi

Manual de instrucciones

DANGER–

VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT

EXPOSURE TO BEAM.

English

Nederlands Español Italiano Deutsch Français

FEDERAL COMMUNICATIONS COMMISSION

DECLARATION OF CONFORMITY

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause un-

desired operation.

Product Name: DVD-R/RW DVD+R/RW CD-R/RW WRITER

Model Number: DVR-A06

Responsible Party Name: PIONEER ELECTRONICS (USA) INC.

Custormer Support Division

Address: 1925 E. DOMINGUEZ ST. LONG BEACH, CA 90810 U.S.A.

Phone: (310) 952-2820

Thank you for buying this Pioneer product.

Please review these operating instructions to install and run your drive properly. After you have

finished reading the instructions, put them away in a safe place for future reference.

K015 En

The Generation of Acoustical Noise Is Less Than 70dB.

(ISO7779/DIN45635)

For pluggable equipment the socket-outlet shall be installed near

the equipment and shall be easily accessible.

Location: on top of the cover.

IMPORTANTNOTICE

Record the model and serial numbers of this drive below. The

numbers are on the top panel.

Model No. DVR-A07

Serial No.

Keep these numbers for future reference.

H059En

CLASS1LASERPRODUCT

LASERKLASSE1

WARNING:

Handling the cord on this product or cords associated with accessories sold with this drive exposes

the user to lead, a chemical known to the State of California and other governmental entities to

cause cancer and birth defects or other reproductive harm.

Wash hands after handling.

English

SAFETY INSTRUCTIONS

To ensure your personal safety and to maximize the full operating potential of your drive, read and follow these

safety notices:

ENVIRONMENT - DO NOT expose the unit to excessive dust, high temperature, or high humidity. Please

avoid subjecting the unit to vibrations or shocks.

POWER - Turn OFF your system before installating hardware devices.

READ & RETAIN INSTRUCTIONS - Read all safety and operating instructions before installing the drive.

FOLLOW INSTRUCTIONS - Follow all operating and use instructions.

HEED WARNINGS -All warnings must be adhered to.

CLEANING - DO NOT use liquid, aerosol cleaners, or alcohol on the dirve. Use only a damp cloth to clean

the exterior housing.

WATER AND MOISTURE - DO NOT use this product near water.

POWER SOURCES - Operate this product from the type of power source indicated on the label. If you are

not sure of the type of power available, consult an authorized Pioneer dealer.

OVERLOADING - DO NOT overload wall outlets and extension cords. Doing so can result in fire or electric

shock.

OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage

points may cause a short resulting in fire or electric shock. Do not spill liquid of any kind on this product.

CONDENSATION - If the drive is moved from a cool environment to a warmer location, moisture can form

inside of the mechanism causing performance issues. If you are moving the unit to a location with a warmer

temperature, let the product stand for 1 to 2 hours at the new site before turning it ON.

SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to

dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

(Refer to the enclosed Service and Support Card.)

÷ Remove dust or lint from the disc with a soft cloth by

wiping from the inside to the outside edge rather than in

a circular motion.

÷ Do not use record-cleaning or anti-static agents as the

solutions may cause damage to a disc.

Always store your discs in proper DVD-R storage cases when

not in use. Check for dirt or dust on discs especially on the

recording side before use.

÷ Avoid touching or scratching the signal surface (shiny

side) of the disc.

÷ Hold the disc by the edges or by the center hole and one

edge.

÷ Do not affix paper or other types of labels to the disc.

÷ Discard warped or cracked discs as they may cause

damage to the drive.

÷ Avoid specialty shaped discs such as hearts or polygons.

• Write Speed

1X, 2X, 4X, and 8X Zone CLV at DVD-R

1X, 2X, and 4X CLV at DVD-RW

2.4X, 4X, 6X CLV, and 8X Zone CLV at DVD+R

2.4X and 4X CLV at DVD+RW

4X, 8X, 16X and 24X Zone CLV at CD-R

4X, 10X, 16X, and 24X Zone CLV at CD-RW

• Maximum Read Speed

12X CAV at DVD-ROM

40X CAV at CD-ROM

• Buffer Memory Size :

2 MBytes (Write/Read)

* ATAPI Interface:

ATA/ATAPI-5 and SFFC INF-8090i Ver5.11

• IDE Data Transfer Mode :

PIO Mode 4/Multi Word DMA Mode 2/Ultra DMA Mode 2

• Supports Video CD

• 5.25inch Half-Height built in type

• Stereo Audio Output

• LCD Tilt Servo Mechanism

• Horizontal/Vertical orientation available

• Low vibration Mechanism by DRA system

• Headophone Output and Volume Control Knob (optional)

Disc Format (Read/Write)

• KODAK Photo CD Singles and Multi-session

• Video CD and CD text data

• CD-ROM, CD-R and CD-RW (HS & US) discs

• DVD-ROM, DVD-R (Ver 2.0 General) and DVD-RW (Ver 1.0 & 1.1) discs

• DVD single layer/dual layer /120 mm disc/80 mm disc

• Reads DVD-RAM (Ver 2.0 & 2.1)

• +R (Ver 1.0 & 1.1)

• +RW (Version 1.2)

• CD-ROM Mode 1

• CD-ROM XA Mode2 (form 1, form2)

• CD-DA

• CD-Extra (CD PLUS)

• Supports Buffer Under Run protection (CD & DVD)

* Drive will obtain Microsoft® Windows® Logo Program (WHQL) certification

Note:

To write to disc, install an applicationam that supports your chosen format.

FEATURES

English

ABOUT REGION CODES

The region code can only be changed 5 times including the first setting. The fifth

change becomes PERMANENT, therefore, avoid changing the region codes unless

absolutely necessary.

÷ Region codes are part of the DVD Standard for devices. However, Region codes

on DVD discs are optional. A disc without a specific Region code can be played

on all standard players.

INTERFACE

FRONT VIEW

1Forced Ejection Hole

If the tray fails to open when pressing the Eject button, turn off the system power and wait for

the disc to stop spinning. Once the power is OFF, it make take as long as 1 minute for the disc

to stop. Insert a stiff rod into the hole and push to eject the tray. During normal operation,

always use the Eject button to open the tray.

2BUSY Indicator

Operation status is indicated as follows.

During reading: Lights

During writing: Lights

3Ventilation Hole

Do not block the vents.

4Eject Button

To unload/load the disc, press the Eject button.

5Disc Tray

Open the tray by pressing the Eject button. Place a CD or DVD disc on to the tray with the

label facing up. Press the Eject button again or push the front panel of tray to close the tray

and load the disc.

Do not attempt to use force to pull out the disc tray.

When playing 8 cm (3.15") Discs

When the drive is installed vertically an 8cm (3.15") disc cannot be played. Attaching an adapter

has no affect on on verically mounted drives.

Note: The Volumn Control Knob and the Head Phone Jack are optional.

INTERFACE

REAR VIEW

Pin Name Function

1 L Left channel audio output

2 G Ground

3 G Ground

4 R Right channel audio output

Pin Name Function

1 MA on The drive is the master device

2 SL on The drive is the slave device

3 CS on Set the drive to Cable Select

4 Reserved

5 Reserved

6Audio Output

This connector is for output of analog audio and is compatible with Molex 70553. Choose a

suitable connection cable.

Pin Name Function

1 +12 Power supply input for DC +12 V

2 G Ground

3 G Ground

4 +5 Power supply input for DC +5 V

7Device Configuration Jumper

The Switch changes to ON when a jumper is added (Pin 1 is on lower-right).

Verify that the power is OFF before changing the jumper setting.

The factory default forPin # 1 is ON.

8Host IDE Interface

Use a 40-pin flat cable to connect the drive to the computer's Enhanced-IDE port. The maximum

length for this cable is 18 inches.

9DC Input

English

1 Turn OFF the computer and remove the power cord from the wall outlet. Remove the

cover or front panel from the PC.

2 Remove the blank panel covering an empty 5.25” slot.

3 Install the slide rails on the drive.

(slide rails may be purchased separately from the computer manufacturer)

4 Insert the drive into the slot.

5 Refer to the computer’s instruction manual if additional mounting methods are required.

÷ Mounting screws must be no longer than 3/16” or 5 mm. Using longer screws may

damage the drive.

÷ When mounting screws are loose, the vibrations from the spinning disc may cause a

ripping noise. To prevent this noise, tighten the screws.

INSTALLATION

÷ Turn OFF the power to the computer.

÷ Connect the power cable from the computer to the drive with the connector in the

correct orientation.

÷ Connect the IDE interface cable to the drive with the IDE connector’s pin 1 aligned

with the drive’s pin 1.

÷ If a sound card is being used, connect the computer’s audio output to the sound card

using an audio cable.

This drive is powered by the computer rather than having a separate power cord.

Do not use a power supply other than the computer’s internal unit.

CONNECTIONS

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Pioneer DVD-Recorder Handbücher

Pioneer

Pioneer DVR-LX60D Bedienungsanleitung

Pioneer

Pioneer PRV-9000 Bedienungsanleitung

Pioneer

Pioneer PRV-LX10 Bedienungsanleitung

Pioneer

Pioneer DVR-5100H-S Bedienungsanleitung

Pioneer

Pioneer DVR-433H-S Bedienungsanleitung

Pioneer

Pioneer PRV-LX1DW Bedienungsanleitung

Pioneer

Pioneer DVR-610 Installationsanleitung

Pioneer

Pioneer DVR-450H-S Bedienungsanleitung

Pioneer

Pioneer BDR-207MBK Bedienungsanleitung

Pioneer

Pioneer DVR-S606 Bedienungsanleitung

Pioneer

Pioneer DVR-541H-S Bedienungsanleitung

Pioneer

Pioneer DVR-65H-S Bedienungsanleitung

Pioneer

Pioneer DVR-520H-S Bedienungsanleitung

Pioneer

Pioneer PRV-LX10 Bedienungsanleitung

Pioneer

Pioneer PRA-BD11 Bedienungsanleitung

Pioneer

Pioneer DVR-X162Q Bedienungsanleitung

Pioneer

Pioneer DVR-X152 Bedienungsanleitung

Pioneer

Pioneer DVR-2810 Bedienungsanleitung

Pioneer

Pioneer DVR-540HX-S Bedienungsanleitung

Pioneer

Pioneer DVR-RT500 Bedienungsanleitung

Pioneer

Pioneer DVR-550H-S - Multi-System DVD Recorder Bedienungsanleitung

Pioneer

Pioneer DVR-3100 Bedienungsanleitung

Pioneer

Pioneer DVR-54HX-S Montageanleitung

Pioneer

Pioneer DVR-7000 Handbuch

Beliebte DVD-Recorder Handbücher anderer Marken

Sony

Sony RDR-VX525 - DVDr/ VCR Combo Bedienungsanleitung

Daewoo

Daewoo DHD-4000D Bedienungsanleitung

Medion

Medion MD 40570 Bedienungsanleitung

Philips

Philips ShowView DVDR3460H Bedienungsanleitung

Sony

Sony RDR-GX355 - Tunerless DVD Recorder Bedienungsanleitung

Sony

Sony DVDirect VRD-MC3 Bedienungsanleitung

Samsung

Samsung DVD-R130/XAA Bedienungsanleitung

FUNAI

FUNAI HD-B2735 Bedienungsanleitung

Panasonic

Panasonic DMR-EH54DEG Bedienungsanleitung

Sanyo

Sanyo DRW-1000 Bedienungsanleitung

Philips

Philips DVDR610/05 Bedienungsanleitung

JVC

JVC DR-M10 Bedienungsanleitung

Samsung

Samsung SV-DVD40 Bedienungsanleitung

Philips

Philips DVDR3355 Bedienungsanleitung

FUNAI

FUNAI FDR-90E Bedienungsanleitung

LG RC298 Bedienungsanleitung

Samsung

Samsung DVD-R130 Bedienungsanleitung

Philips

Philips DD-A110GX Bedienungsanleitung