Power Master ASW Montageanleitung

INSTALLATION AND OWNER’S MANUAL

MODEL ASW

Actuator Swing Gate Operator

READ THIS MANUAL CAREFULLY

BEFORE INSTALLATION OR USE.

SAVE THESE INSTRUCTIONS.

Serial #:

Date Installed:

Your Dealer:

PM CONTROL BOARD INSTRUCTIONS INCLUDED

IMPORTANT NOTICE FOR GATE OPERATORS

MANUFACTURED AFTER JANUARY 11, 2016

All gate operators manufactured after January 11th, 2016 must have a

monitored input for each direction. In order to satisfy this requirement all

Powermaster Swing & Slide Gate Operators will have one monitored input

for each direction: The close obstruction (C-OBS) terminal for the close

direction and the open obstruction (O-OBS) terminal for the open direction.

These terminals will look for, or “monitor” the presence of a 10k in-line

resistor. If either terminal does not detect the presence of the monitored

device the unit will function in constant contact for this direction.

E.G. The operator detects there is a monitored device on the C-OBS

terminal but not the O-OBS terminal. The operator will function in

momentary contact to close and constant pressure to open.

The UL 2016 devices for these units are as follows:

Device

Manufacturer

Description

Prime-Guard

Miller Edge

Monitored Photoeye

Reflecti-Guard

Miller Edge

Retroreflective Monitored

Photoeye

IRB-MON

EMX

Monitored Photoeye

IRB-RET

EMX

Retroreflective Monitored

Photoeye

The Solution

Miller Edge

Multiple Safety Devices

Any actions taken to circumvent this monitoring are in

violation of the UL325, building code, and local laws.

Introduction

•Beforeinstallingthesystem,readtheinstructions

completely.

•DonotusethePowerMasterASWforany

applicationnotlistedinthismanual.

• Supplytheenduserwithinstructionsforusing

thissystem.

General Information

Toensureagoodoperationoftheseautomatic

devices,thegateshouldmeetthefollowing

requirements:

•Goodstrengthandstiness.

• Hingesshouldhaveaminimumbacklashand

allowforsmoothandregularmanualoperations.

• Whenclosed,thegateleavesshouldcorrectly

overlapfortheirentireheight.

How to Install the Automatic System

Calculatetheheightofthesystemfromtheground

(Itisadvisabletodeneapositionascentered

aspossiblewithrespecttothemaingateandin

correspondencewithastrongcrossgirder).Weldthe

platePfollowingmeasuresinFigure 1.

Withthegateclosed,weldbracketStoacross

beamofthemaingateorotherelementwithequal

strength,accordingtomeasuresshowninFigure 1.

Keepinmindthatwhencarryingoutthisoperation,

theactuatorshouldnotbetotallyinastrokeend

position.

RemovecoverCbylooseningscrewF.Thenxthe

actuatortoplatePbymeansofscrewTandnutD

(Figure 2).LocktheactuatortoplateSbymeansof

screwVandwasherR.

Theholesintheactuator(Figures 1a&1b)helpto

keeptotheoptimuminstallationmeasures.

How to Adjust the Mechanical Stoppers

Theactuatorisprovidedwithadjustablemechanical

stopsintheopeningandclosingpositions.The

systemisadjustedbysuitablypositioningtheOpen

andClosemechanicallocks,asshowninFigure 3:

1. Unlocktheautomaticsystembyusingthe

specialreleaselever,asshownintheinstructions

fortheuser.

2. Closethegateleaf.

3. LoosenscrewsV1andmovetheCloselockuntil

itreachespivotP,thentightenscrewsV2.

4. Resettheautomaticoperatingmode.The

PowerMasterASWhastwolimitmicro-switches

xedtothemechanicalstops.

5. Themicro-switchestriggerslightlyinadvance

withrespecttothemechanicalstop.

Connections

1. ThespecialplateP(Figure 4)allowsforusinga

linkforsheathorcablegland.Oncethetypeof

cableglandisappliedtotheplate,xthelatter

totheadaptorcoverbymeansofscrewsV.

2. Carryoutthewiringbyreferringtothewire

diagramshowninFigure 5.

3. Itismandatorytoprovideforgroundbyusing

theGNDTerminal.

TECHNICAL DATA FOR POWERMASTER ASW

PowerSupply 24VDC

AbsorbedRating 120W

AbsorbedCurrent 6.7A

Thrust 494.5LBF

Jogging Intensive

ProtectionDegree IP44

OperatingTemperature -4°F/122°F

DoorLeafMax.Weight 1000lbs

UsefulStroke 17-7/8”

TranslationSpeed 31-1/2”/MIN

NoiseLevel <70dB

Lubrication PermanentGrease

Weight 26lbs

Inhaltsverzeichnis

Andere Power Master Toröffner Handbücher

Power Master

Power Master SG 2004 Montageanleitung

Power Master

Power Master RSG Bedienungsanleitung

Power Master

Power Master MBG Bedienungsanleitung

Power Master

Power Master rsw Bedienungsanleitung

Power Master

Power Master CSWC Bedienungsanleitung

Power Master

Power Master CSG 2004 Bedienungsanleitung

Power Master

Power Master SG Betriebsanleitung

Power Master

Power Master RSG 2000 Bedienungsanleitung

Power Master

Power Master rsw Montageanleitung

Power Master

Power Master RSG Montageanleitung

Power Master

Power Master SG 2004 Bedienungsanleitung

Power Master

Power Master CSWI Montageanleitung

Power Master

Power Master DSWI Montageanleitung

Beliebte Toröffner Handbücher anderer Marken

Elite

Elite CSW200UL Bedienungsanleitung

CAME

CAME FROG-PM4 Bedienungsanleitung

SOMFY

SOMFY FX230 Bedienungsanleitung

Aprimatic

Aprimatic ONDA 500 Bedienungsanleitung

Turnstiles

Turnstiles FSW 900 Bedienungsanleitung

Erreka

Erreka BUL BL33 Betriebsanleitung

Erreka

Erreka VULCAN S Bedienungsanleitung

Beninca

Beninca R1-2 WBV Bedienungsanleitung

Erreka

Erreka VULCAN D Bedienungsanleitung

Motorline professional

Motorline professional FORT Bedienungsanleitung

Beninca

Beninca BOB5024 Bedienungsanleitung

AGA

AGA GATEMASTER 900 HD Bedienungsanleitung

Chamberlain

Chamberlain MotorLift HC280ML Bedienungsanleitung

SOMFY

SOMFY Dexxo RTS Pro Bedienungsanleitung

Cardin

Cardin BL Series Bedienungsanleitung

Westfalia

Westfalia 85 27 06 Bedienungsanleitung

CAME

CAME F500 Bedienungsanleitung

Extel

Extel VERA Bedienungsanleitung