Premier Mounts RTM-L Bedienungsanleitung

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

1321 S. State College Blvd., Fullerton, CA 92831 USA

Installation Guide

RTM-L

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

Page 2

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND

COMPLETELY UNDERSTOOD. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION

FOR FUTURE REFERENCE.

PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS

PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY

UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS,

DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR

IN ANY MANNER RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

Warning Statements

Weight Limit

Maximum Flat Panel Weight: 160 lbs.

THE SURFACE MUST BE CAPABLE OF SUPPORTING AT LEAST FOUR TIMES THE WEIGHT OF THE DISPLAY. IF NOT, THE

SURFACE STRUCTURE MUST BE REINFORCED. THE MAXIMUM WEIGHT THAT CAN BE USED WITH THIS PRODUCT IS 160

LBS. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION

INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY, OR EVEN

DEATH.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE PROPER

SAFETY GEAR AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

At least two qualied people should perform the assembly procedure. Injury and/or damage can result from dropping or mishandling

the display.

If mounting to studs, make sure that the mounting screws are anchored into the center of the studs. Use of an edge-to-edge stud

nder is recommended.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical

wires in wall. Cutting/drilling into an electrical line may cause serious injury.

Make sure there are no water lines inside the wall where the mount is to be located. Cutting/drilling into a water line may cause severe

water damage to the mounting surface.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact.

Installation Tools:

Pencil Protective Eyewear

Electronic Stud Finder M6 or 1/4” Drill Bit 3/8” Masonry Drill Bit

Portable Drill

Phillips Head Screwdriver Socket Wrench

13mm or 1/2” SocketLevel

RTM-L

Installation Guide

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 Page 3

Installation Guide

RTM-L

Included Components:

Mounting Block

(Qty.1)

M5 Security Allen

Key (Qty.1)

M6 x 30mm Screw

(Qty.4)

M8 x 16mm Screw

(Qty.4)

M8 x 25mm Screw

(Qty.4)

M8 x 30mm Screw

(Qty.4)

M4 x 25mm Screw

(Qty.4)

M4 x 30mm Screw

(Qty.4)

M6 x 16mm Screw

(Qty.4)

M6 x 25mm Screw

(Qty.4)

Universal Spacer

(Qty.8)

M6 x 12mm Button

Security (Qty.1)

M6 Lock Washer

(Qty.1)

M10 x 30mm Screw

(Qty.4)

M4 x 16mm Screw

(Qty.4)

Griplate™(Qty.4) Straw (Qty.1) 5/32" Allen Key

(Qty.1)

Cross Bar (Qty.1)

Mounting Bracket (Qty.2)

1 2

Remove the M6 Knurl Knob from the mounting block and place it aside. Slide the mounting block over the tubes.

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

Page 4

3Tighten the four (4) pre-installed M8 set screws using the supplied 5/32" Allen Key.

Small Straw or Toothpick

Marking the 1/8”

Allowance

Small Straw

or Toothpick

Small Straw

or Toothpick Depth Plus 1/8” Allowance

Mark

Depth Plus 1/8” Allowance

Mark

1) Insert a small straw or toothpick into the threaded inserts found on the

back of the at-panel.

2) Use a pencil to mark the depth of the threaded insert on the small straw

or toothpick.

3) Mark the straw or toothpick 1/8” above the depth of the threaded insert,

as shown in Figure 1.

4) Insert the small straw or toothpick into the remaining threaded inserts

to compare and verify their depth using the straw or toothpick’s 1/8”

allowance mark.

5) Locate the correct diameter screw for the threaded insert.

If the screw you selected is longer than the 1/8” allowance mark on

the small straw or toothpick, as shown in Figure 2 and Figure 3, do

not use this screw. The screw length must not bypass the mark.

6) Test each size of the screws provided.

The correct screws should thread easily into themounting point and

not pull out when tension is applied.

Selecting the Mounting Hardware

RTM-L

Installation Guide

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 Page 5

Installation Guide

Slide the mounting brackets into the cross bar. Bottom

Top

Align the brackets to the display mounting holes. Use the depth measuring straw to determine the appropriate hardware. Use four (4) M4, M6, or M8

screws depending on display and four (4) Griplate™ (Universal Washer). Use Universal Spacer if necessary.

M4, M6, or M8 screws

Griplate™ (Universal Washer)

Universal Spacer (Optional)

Top

Bottom

RTM-L

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

Page 6

M8 x 10mm Set Screw

Center the cross bar to the display and tighten the two (2) M8 x 10 Set Screws using the 5/32" Allen Key to secure the brackets.

Two persons are recommended for this step. Lift the display bar and place the disk it into the receiver plate.

Installation Guide

RTM-L

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 Page 7

Installation Guide

Install the M6 Knurl Knob removed from step 1 to secure

the cross bar from dislodging.

(Optional Security Screw) Install the M6 x 12mm Button

Security Screw and M6 lock washer to secure the cross bar

from dislodging.

Tension

Screw

Tighten the two (2) screws (located on the side of the mounting

block) once the nal position is attained.

RTM-L

www.mounts.com | North America 800.368.9700 | International +1-714-632-7100

Page 8 9531-009-011-0X_4

Installation Guide

RTM-L

Premier Mounts intends to make this manual accurate and complete. However, Premier Mounts makes no claim that the information

contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with

the installation or use of this product. The information contained in this document is subject to change without notice or obligation of

any kind. Premier Mounts makes no representation of warranty, expressed or implied, regarding the information contained herein.

Premier Mounts assumes no responsibility for accuracy, completeness or sufciency of the information contained in this document.

PREMIER MOUNTS

LIMITED LIFETIME WARRANTY

What and Who is Covered by this Limited Lifetime Warranty

Premier Mounts warrants all mounting products to be free from defects in material and workmanship

for the lifetime of the original installation of the product.

What Premier Mounts Will Do

At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product

part that is defective. If Premier Mounts chooses to replace a defective product or part, a replacement

product or part will be shipped to you at no charge, but you must pay any related labor costs.

What is Not Covered: Limitations

Premier Mounts disclaims any liability for damage to mounts, adapters, displays, projectors, other

property, or personal injury resulting, in whole or in part, from improper installation, modication, use

or misuse of its products.

NOTWITHSTANDING ANYTHING TO THE CONTRARY IN THIS WARRANTY, THIS WARRANTY

IS LIMITED TO FIVE YEARS FROM THE DATE OF PURCHASE IN THE EVENT THAT THE WAR-

RANTED PRODUCT IS COMMERCIALLY RENTED OUT.

Electrical products and components, such as ampliers, speakers, motors, switches remote controls

and related electrical items, are backed by a 3-year warranty.

Premier Mounts disclaims all other warranties, express or implied, including warranties of merchant-

ability and tness for a particular purpose. Premier Mounts is not responsible for incidental or conse-

quential damages, including but not limited to, inability to use its products or labor costs for remov-

ing and replacing defective products or parts. Some states do not allow the exclusion or limitation of

incidental or consequential damages, so the above limitation or exclusion may not apply to you.

What Customers Must Do for Warranty Service

If you discover a problem that you think may be covered by the warranty, you must report it in writ-

ing to the address below within thirty (30) days. Proof of purchase (an original sales receipt) from the

original consumer purchaser must accompany all warranty claims. Warranty claims must also include

a description of the problem, the purchaser’s name, address, and telephone number. General inqui-

ries can be addressed to Premier Mounts Customer Service at 1-800-368-9700. Warranty claims will

not be accepted over the phone or by fax.

Premier Mounts

Attn: Warranty Claim

1321 S. State College Blvd.

Fullerton, CA 92831 USA

How State Law Applies

This warranty gives you specic legal rights, and you may also have other rights which vary from

state to state.

Andere Handbücher für RTM-L

Inhaltsverzeichnis

Andere Premier Mounts Rack & Stand Handbücher

Premier Mounts

Premier Mounts LPSA3747 Bedienungsanleitung

Premier Mounts

Premier Mounts CONVERGENT TVF Series Bedienungsanleitung

Premier Mounts

Premier Mounts Polaris MAG-EXT Bedienungsanleitung

Premier Mounts

Premier Mounts ECM-3763S Bedienungsanleitung

Premier Mounts

Premier Mounts PBL-200 Bedienungsanleitung

Premier Mounts

Premier Mounts SOAD Bedienungsanleitung

Premier Mounts

Premier Mounts ECM-D70T Bedienungsanleitung

Premier Mounts

Premier Mounts UFA Bedienungsanleitung

Premier Mounts

Premier Mounts TL84-MS2 Bedienungsanleitung

Premier Mounts

Premier Mounts PSD-TS Bedienungsanleitung

Premier Mounts

Premier Mounts ECM-3763D Bedienungsanleitung

Premier Mounts

Premier Mounts AST-2446 Bedienungsanleitung

Premier Mounts

Premier Mounts GB-INWAVP Bedienungsanleitung

Premier Mounts

Premier Mounts PP-6 Bedienungsanleitung

Premier Mounts

Premier Mounts AM95 Bedienungsanleitung

Premier Mounts

Premier Mounts SCM-103 Bedienungsanleitung

Premier Mounts

Premier Mounts Convergent UNI-UPS-A CLD Bedienungsanleitung

Premier Mounts

Premier Mounts PP-FCTA-QL Bedienungsanleitung

Premier Mounts

Premier Mounts Universal Tabletop Stand PSD-TTS Leitfaden

Premier Mounts

Premier Mounts PBC-UM Series Bedienungsanleitung

Premier Mounts

Premier Mounts CTM-MS2 Bedienungsanleitung

Premier Mounts

Premier Mounts UFA Bedienungsanleitung

Premier Mounts

Premier Mounts PSD-EB Bedienungsanleitung

Premier Mounts

Premier Mounts AST-2446-2 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung