Pro-Ject Audio Systems Speed Box MK II Bedienungsanleitung

INSTRUCTIONS FOR USE

Pro-Ject Speed Box MK II

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO Speed Box MK II. * The unit permits electronic speed change

of your Pro-Ject record player between 33 and 45 r.p.m. and also permits the replay of shellac records by

allowing ** 78 r.p.m. with an appropriate pulley and cartridge.

Only models with mains socket power supply. 16V/190mA AC max..

* The Pro-Ject Debut III/Phono SB, Pro-Ject 1.2 Comfort and Pro-Ject RPM 6.1 SB may not be used

with the Speed Box. These models are equipped with an electronic speed change as a standard.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Connecting the record player

Connect the low voltage plug (Output ~16V) from the Speed Box to the socket in the record player's motor.

Make all connections whilst the Speed Box is disconnected from the power supply.

Mains power connection

The Speed Box is supplied with a power supply suitable for your country's mains supply. Check the label

before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug

from the power supply to the socket Power ~16V before connecting the power supply to the mains.

Speed selection 33/45 r.p.m.

Speed Box MKII

33 45 Speed

The belt must be on the smaller (50Hz models) larger (60Hz models) diameter part of the motor pulley. Press

the speed change button to switch between 33 and 45 r.p.m.. The selected speed is shown respectively by the

lit LED. To play at 45 or ** 78 r.p.m. please always start the turntable at 33 r.p.m. and then switch to the higher

speed when it has attained full speed.

Replay at 78 r.p.m.

** In order to replay shellac records at 78 r.p.m. your turntable must be equipped with the 78 r.p.m. pulley

which is available as an optional accessory for most models.

After fitting the 78 r.p.m. pulley please proceed as follows: Remove the platter and using the tool from the

accessory kit fit the belt around the larger diameter step of the pulley. Replace the Platter, start the turntable

at 33 r.p.m. and switch the speed to 45 r.p.m., the platter will then revolve at 78 r.p.m..

Fitting the 78 r.p.m. pulley

Before beginning work fit the cartridge’s needle protection cover.

Remove the platter and drive belt. Please remember that sweat or sticky fingers will impair the function of the

belt. Use a piece of kitchen paper or a cloth to remove the belt.

Measure the height of the pulley above the plinth in order to ease correct refitting.

Using a small screwdriver loosen the grub screw in the neck of the pulley just enough to remove the pulley

vertically without using force. Refit the pulley in the opposite order. Tighten the grub screw carefully making

sure you do not overtighten it.

Fit the drive belt around the subplatter and the pulley. Again, use a piece of paper or cloth to avoid soiling

the belt. Replace the platter.

** 78 r.p.m. is not available with the models 1.2 Comfort, Xperience, Xperience “SuperPack” RPM 9.1

and RPM 9.1X.

The models Debut III/Phono SB, RPM 5, RPM 5 “SuperPack” and RPM 6.1 SB are equipped with an

mechanic speed change for 78 r.p.m.. Switching to 78 r.p.m. with the Perspective is done by

exchanging the motor and belt.

Switching on and off

Pressing the power switch of Your Pro-Ject Turntable alternately starts or stops the motor.

Technical specifications PRO-JECT SPEED BOX MK II

Speed change 33,33/45,11 r.p.m. ** or 78 r.p.m. (with optional 78 r.p.m. pulley only)

Power output 16V/190mA AC max. (power consumption 3W max.)

Outboard power supply 16V/500mA AC, suitable for your country's mains supply

Dimensions (H x W x D) 38 x 105 x 120mm

Weight without power supply 540g

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the

unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: ATR-Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.

Inhaltsverzeichnis

Andere Pro-Ject Audio Systems Drehscheibe Handbücher

Pro-Ject Audio Systems

Pro-Ject Audio Systems T1 Phono SB Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 9.1 Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems T2 W Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 5 SuperPack Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems 6 PerspeX Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut RecordMaster II Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon Esprit SB Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Juke Box E Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 3 Carbon Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtensions 9 S-Shape Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 9.1 SuperPack 1 Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems X1 Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtension 12 Evolution Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems ESSENTIAL III Fehlerbehebungshandbuch

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 5 Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 1.3 Genie Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems X2 Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems THE CLASSIC Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon EVO Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Perspective Final Edition Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Essential III RecordMaster Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject VC-S Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2Xperience Primary Bedienungsanleitung

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 6.1 SB SuperPack Bedienungsanleitung

Beliebte Drehscheibe Handbücher anderer Marken

Gemini

Gemini CDT-05 MKII Bedienungsanleitung

Rotel

Rotel RP-820 Bedienungsanleitung

Shuman

Shuman MC-250BT Bedienungsanleitung

Stanton

Stanton STR8-150 Bedienungsanleitung

Audio Technica

Audio Technica AT-LPW40WN Bedienungsanleitung

Crosley

Crosley McQueen CR7011-GY Bedienungsanleitung

Reloop

Reloop SMP-1 Bedienungsanleitung

auna

auna TT-Classic Plus Bedienungsanleitung

COMO AUDIO

COMO AUDIO Turntable Analog Bedienungsanleitung

Dual

Dual 1009 F Bedienungsanleitung

REED

REED Muse3C Bedienungsanleitung

AXIOMTEK

AXIOMTEK OPS883-H Series Bedienungsanleitung

Pioneer

Pioneer PL-71 Bedienungsanleitung

Vestax

Vestax PDX-a1 Bedienungsanleitung

Denon

Denon DP-400 Bedienungsanleitung

Dual

Dual 504 Bedienungsanleitung

Audio-Techica

Audio-Techica AT-LP60XBT Bedienungsanleitung

Goldring

Goldring G99 Bedienungsanleitung