HALOGEN HAND LAMP 300W SKY
EN - 1
+ movement sensor
PLI-172
We thank you for the purchase of this Profile product.
Note: It is important that you read this manual
carefully before using the product And be sure to save
this manual for possible use later.
Note
Check if building regulations apply to your area
hereby you must have the halogen hand lamp
installed by an accredited electrician. An electrician
can give you information about correct iring. Never
install the fitting outside in rainy eather.
SWITCH OFF THE POWER BEFORE YOU INSTALL
THE HALOGEN HAND LAMP.
orrect installation
With installation outside preferably choose a place
under a roof.
Do not place the sensor head in direct or reflected
sunlight. The halogen hand lamp may then s itch
on hen not required. The sensor orks best ith
movement “cross ise” through the sensor's
detection field.
Connect the halogen hand lamp to a circuit ith all
s itch.
Unscre the stainless steel bolts on the side to take
the holder from the fitting.
Fix the holder to the all ith 2 scre s. Do not fix
the holder to a highly flammable surface. Leave a
distance of at least 1 m bet een the halogen hand
lamp and the object to be illuminated. (see fig. 2)
Install the halogen hand lamp at least 2.5 m above
the ground. (see fig.1)
Fig. 1 Fig. 2
CAUTION: There is an “UP” arro on the inside of
the holder. The arro must point up ards hen you
mark the position of the holes.
Fig. 3
Pull the po er supply ires through the opening
ith the rubber packing.
Connect the electric iring according to figures 4
and 5.
The halogen hand lamp must be connected to
mains voltage of 230V, max. fusing 16A.
Fig. 4
Fig. 5
Scre the cable connection cover tight again.
Al ays respect the instructions on the identification
label of the connected po er cables.
Other uses than described above can cause
damage to the product and increase the risk of
short-circuit, fire, electric shocks, etc.
The product may not be adapted as a hole. The
safety instructions must be strictly observed.
Safety instructions
The importer accepts no responsibility for damage
claims ith respect to objects or persons that result
from incorrect use or non-compliance ith the
safety instructions. Any damage claims in such
cases ill be declared null and void.
When replacing the halogen bulb the lamp must
first have cooled before the bulb is replaced. Also
disconnect the po er supply. Do not exceed the
maximum attage of 300W.
CAUTION: Never touch the bulb ith your fingers.
Touching the bulb ith your fingers can reduce the
life of the bulb.
Al ays replace cracked or broken glass by glass
ith the same properties as the original glass.
Technical information
Working voltage: 230V AC (50/60 Hz)
Maximum lamp po er: 300W.
Maximum current strength: 10/16A.
Dustproof and splash proof: IP44.
Passive infrared sensor (PIR).
Sensor angle: 120°.
* L = phase
* = earthing
* N = neutral
