ProFlow PFEOS-OB2020 Bedienungsanleitung
1
INSTALLATION MANUAL
Low Profile Oil Filter Sandwich Adaptor
PFEOS-OB2020
WARNING: PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. PROFLOW WILL NOT BE
RESPONSIBLE FOR ANY DAMAGE AS A RESULT OF THE INCORRECT INSTALLATION OF THIS
PRODUCT. IT IS RECOMMENDED THAT A QUALIFIED AUTOMOTIVE TECHNICIAN PERFORMS THIS
INSTALLATION.
This product is designed to sit in between the standard oil filter and the engine block. Both
inlet/outlets are plumbed for AN10 ORB connections and there are 2x 1/8” NPT ports for
accessories for reading oil pressure, etc. This adaptor is required when installing an
engine oil cooler to provide oil flow to the cooler core. This is a universal product with a
variety of inserts provided to fit both imperial and metric oil filters.
TYPICAL INSTALLATION
1. Drain engine oil from vehicle following the factory service manual of the vehicle.
2. Ensure to clean out the billet remote oil block for any debris from the machining
process.
3. Remove the vehicles factory oil filter by unscrewing it from the block.
4. Insert the correct thread needed for your vehicle into the sandwich plate adaptor.
Screw this assembly onto the engines original oil filter nipple on the block. Ensure
all o-rings are securely in their grooves and lubricated.
5. Torque the threaded insert using the hex to approximately 25 Nm.
6. Install the oil filter of your choice by screwing it into the male nipple now coming
out of the block adaptor.
7. Begin plumbing the block adaptor using the appropriate hose and fittings and
connecting them to an external oil cooler. The block adaptor is labelled with
inlet/outlets for your convenience.
8. If only 1 or none of the 1/8” NPT ports are being used, block off with thread sealant.
Included Items
QTY
Oil Filter Sandwich Adaptor AN10 Ports
1
3/4”-16 Thread Insert
1
13/16”-16 Thread Insert
1
M18x1.5mm Thread Insert
1
M20x1.5mm Thread Insert
1
M22x1.5mm Thread Insert
1
2
PROFLOW LIMITED WARRANTY
This product is warranted to be free from defects in materials and
workmanship for a period of one year from the original date of purchase.
EMAIL: sales@proflow.com.au PHONE: 1300 879 879
9. Add new engine oil to the vehicle and start the engine to check for correct oil
pressure via a gauge.
WARNING: If no oil pressure is built-up within 5 seconds, turn the engine off
completely to avoid any internal component damage.
10.Let the engine idle for 5-10 minutes once oil pressure is established and check all
connections and components for oil leaks.
11.Turn the engine off and check the oil level dipstick. The dipstick may read low as
the new hose connections are filled up with oil. Add aditional fluid to the vehicle
as required.
Inhaltsverzeichnis
Andere ProFlow Empfänger Handbücher
