Prorack K671 Bedienungsanleitung

K671

Fitting Kit

EN Fitting Instructions for Basic Carrier CAUTION: Professional

installation recommended

x 4 x 4 x 1 x 4

x 8 x 8 x 4 x 4

Revision No: 6D 1

Fitting Kit K671

x 4 x 4 x 4 x 4

x 4

Fitting Kit K671

MAX kgs (lbs)

W/P WHD

Chevrolet

Colorado Crew Cab LT/LTZ, 4dr Truck 13-+ US 75 kgs (165 lbs) 100 kgs (220 lbs)

Colorado Crew Cab LT/LTZ, 4dr Ute 13-+ EU 75 kgs (165 lbs) 100 kgs (220 lbs)

Holden

Colorado Crew Cab LT/LTZ, 4dr Ute 12-+ NZ 75 kgs (165 lbs) 100 kgs (220 lbs)

Colorado Crew Cab LT/LTZ, 4dr Ute 12-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)

Isuzu

D Max LS Double Cab, 4dr Ute 12-+ NZ 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max Eiger, 4dr Ute 12-+ EU 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max Yukon, 4dr Ute 12-+ EU 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max LX Double Cab, 4dr Ute 13-+ ZA 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max LS Crew Cab, 4dr Ute Jul 12-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max LS-U Crew Cab, 4dr Ute Jul 12-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)

D Max LS-M Crew Cab, 4dr Ute Jul 12-+ AU 75 kgs (165 lbs) 100 kgs (220 lbs)

Fitting Kit EN

K671

CAUTION:

●Professional installation recommended.

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

●This kit fits type A, B, C and D.

Fitting Kit EN

K671

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K671

●Attaches to factory-fitted mounting points

●Please check the rear of this manual for

information relating specifically to your

vehicle.

●Adjust crossbar in or out to suit vehicle.

Refer to the crossbar instructions for

crossbar adjustment.

●Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight.

●Remove plastic clamp block by gripping bar

leg with fingers and push firmly with

thumbs until clamp block drops out behind

leg.

Fitting Kit EN

K671

●Select plastic internal block (from fitting kit)

and insert into foot.

●Repeat for all legs.

Fitment

●There are 4 concealed mounting points

hidden by the vehicles rubber insert on the

roof.

●Measure from the front of the rubber insert

and make a mark at 355mm and 1245mm.

●From these 2 marks measure 25mm

forward and 25mm back and mark a line

across the rubber insert.

●Carefully lift the rubber insert by hand to

reveal the mounting points as shown, only

lift the minimum amount required to reveal

the mounting point.

●Note: Do not use sharp objects or tools to

lift the rubber moulding.

●Note: Take care when lifting the rubber

insert not to kink or bend it.

●Note: The mounting points are covered

with sealant.

Fitting Kit EN

K671

●Now cut the rubber insert at the 2 lines you

marked in the earlier instruction. Once cut

you should end up with 4 x 50mm pieces of

the rubber insert.

●Note: Be careful of sharp edges after

cutting the rubber insert.

●Remove one side of adhesive tape

backing. Apply to underside of rubber

insert as shown. Remove second backing,

then apply downward pressure onto

vehicle.

●To reveal the screw thread in the mounting

points, remove the sealant covering them

with a sharp tool.

Fitting Kit EN

K671

●Remove sealant as shown.

●Apply protective strip as shown.

Trim if required.

●Assemble as shown.

●A = 8mm bolt

B = Spring washer

C = Flat washer

D = Rubber seal

E = Protective strip

●Place rubber seal over bolt thread as

shown.

●Place the clamps into position as pictured

at the 4 points, ensure the clamp is

orientated the right way in the vehicle

channel.

●Using 5mm hex key supplied with this kit,

fully tighten the M8 dome head bolt and

washer supplied to 5Nm (3.7 ft lb) hand

tight.

Fitting Kit EN

K671

●Select coach bolt and insert through metal

clamp slot.

●Using the 10mm (3/8") spanner supplied

with the crossbars, tighten the nut to 5Nm

(3.7 ft lb) hand tight.

●A = Coach bolt

B = Washer

C = Nut

●Assemble as shown.

●Refer to the underside of the pad for the

part number.

●Fit rubber pads (supplied with fitting kit) to

foot. Pad may vary in shape to that shown.

Inhaltsverzeichnis

Andere Prorack Autozubehör Handbücher

Prorack

Prorack K916 Bedienungsanleitung

Prorack

Prorack K375 Bedienungsanleitung

Prorack

Prorack K174 Bedienungsanleitung

Prorack

Prorack K1007 Bedienungsanleitung

Prorack

Prorack K1074 Bedienungsanleitung

Prorack

Prorack K1208 Bedienungsanleitung

Prorack

Prorack K1221 Bedienungsanleitung

Prorack

Prorack K162 Bedienungsanleitung

Prorack

Prorack PR3213 Bedienungsanleitung

Prorack

Prorack K053 Bedienungsanleitung

Prorack

Prorack K652 Bedienungsanleitung

Prorack

Prorack K674 Bedienungsanleitung

Prorack

Prorack K124 Bedienungsanleitung

Prorack

Prorack K869 Bedienungsanleitung

Prorack

Prorack K931 Bedienungsanleitung

Prorack

Prorack K692 Bedienungsanleitung

Prorack

Prorack K324 Bedienungsanleitung

Prorack

Prorack K726 Bedienungsanleitung

Prorack

Prorack K389 Bedienungsanleitung

Prorack

Prorack K319 Bedienungsanleitung

Prorack

Prorack K120 Bedienungsanleitung

Prorack

Prorack K797 Bedienungsanleitung

Prorack

Prorack K474 Bedienungsanleitung

Prorack

Prorack K838 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung