Prorack Q19 Bedienungsanleitung

Q19

Track System

EN Fitting Instructions for Basic Carrier

x 2 x 2 x 2 x 4

x 1 x 1 x 1 x 1

x 18 x 18 x 18

Revision No: 1A 1

Track System EN

Q19

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●Front end plug.

Track System EN

Q19

●Rear end plug.

●Assemble front and rear plugs to tracks.

Note: Rear plug shown in picture.

●NOTE: There is a left hand track and right

hand track. The end plugs should be fitted

accordingly.

Track System EN

Q19

●Carefully select position on vehicle roof

making sure that your crossbar lengths will

match selected positions for the tracks.

●Apply long lengths of masking tape to

vehicle roof in both positions.

●Repeat for all four positions.

●Make sure there is no interference between

what you intend to carry with aerials,

sunroof or tailgate.

●Tracks can be fitted either parallel or

tapered to match vehicle roof shape.

●Parallel Tracks:

A1 & A2 are equal

B1 & B2 are equal

C1 & C2 are equal

D1 & D2 are equal

●Tapered Tracks:

A1 & A2 are different

B1 & B2 are equal

C1 & С2 are equal

D1 & D2 are equal

●With help from another person, carefully lay

tracks over the masking tape and mark

hole positions with a pencil or pen.

●Take care not to move the tracks until the

holes are marked out.

Track System EN

Q19

●Use drill bit supplied, to drill holes in

marked positions.

●Remove masking tape and apply non-

acetic silicon sealant around drilled holes.

●Sit tracks on roof and line up tracks with

drilled holes.

●Insert all cap screws through the drilled

holes.

●With assistance, fit washer and nut loosely

onto each of the cap screws from inside the

canopy.

●Use a spanner to tighten the nuts onto the

cap screws to 3Nm (2.2 ft lb) using the

provided 3mm provided hex key.

Track System EN

Q19

●If the position of the roof racks need to be

adjusted along the tracks, use the 3mm

(1/8") hex key to hold the T-bolt stationary,

and using the 10mm (3/8") spanner

supplied loosen both of the nuts slightly on

all the mounting points to be adjusted.

●Adjust the position of the mounting points

along the tracks as required.

●Use the 3mm (1/8") Hex Key to hold the T-

bolt in a stationary position and ensure the

T-bolt has correct engagement.

●Using the 10mm (3/8") spanner supplied,

tighten the nut to 5Nm (3.7 ft lb).

●Use keys to remove covers.

Track System EN

Q19

●Remove plastic clamp block by gripping bar

leg with fingers and push firmly with

thumbs until clamp block drops out behind

leg.

●Remove both pins from each leg. Use

tapered end of spanner located inside left

hand cover to assist.

●Detach foot from leg. Store loose parts in a

safe place.

●Repeat for all legs.

Track System EN

Q19

●Assemble foot from kit into leg.

●Insert pins through foot into leg.

●Repeat for all legs.

●Select plastic internal block (from fitting kit)

and insert into foot.

Track System EN

Q19

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

●Set bars to length so that the mounting

holes will line up (refer to the crossbar

instructions for crossbar adjustment).

Track System EN

Q19

●Place crossbars over mounting assembly

on tracks.

●Tighten the plastic knob.

●Ensure the plastic knob is in the position

shown when fully tightened.

●Repeat for all four positions.

Inhaltsverzeichnis

Andere Prorack Autozubehör Handbücher

Prorack

Prorack K389 Bedienungsanleitung

Prorack

Prorack K426 Bedienungsanleitung

Prorack

Prorack K432 Bedienungsanleitung

Prorack

Prorack K401 Bedienungsanleitung

Prorack

Prorack K1020 Bedienungsanleitung

Prorack

Prorack PR3074 Bedienungsanleitung

Prorack

Prorack K1215 Bedienungsanleitung

Prorack

Prorack K536 Bedienungsanleitung

Prorack

Prorack K578 Bedienungsanleitung

Prorack

Prorack K853 Bedienungs- und Installationshandbuch

Prorack

Prorack K340 Bedienungsanleitung

Prorack

Prorack K820 Bedienungsanleitung

Prorack

Prorack K391 Bedienungsanleitung

Prorack

Prorack K682 Bedienungsanleitung

Prorack

Prorack K027 Bedienungs- und Installationshandbuch

Prorack

Prorack K568 Bedienungsanleitung

Prorack

Prorack K1004 Bedienungsanleitung

Prorack

Prorack K173 Bedienungsanleitung

Prorack

Prorack PR3104 Bedienungsanleitung

Prorack

Prorack K607 Bedienungsanleitung

Prorack

Prorack K958 Bedienungsanleitung

Prorack

Prorack K619 Bedienungsanleitung

Prorack

Prorack K328 Bedienungsanleitung

Prorack

Prorack K824W Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung