RAB EM Bedienungsanleitung

EM EMERGENCY LIGHTING

MI PORTANT

CAREFULLY BEFORE INSTALLING FIXTURE. R TAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.READ E

IMPORTANT SAFEGUARDS:

When using electrical equipment, basic safety precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Do not use outdoors.

2. Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized personnel.

3. Do not mount near gas or electric heaters.

4. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

5. Do not use this equipment for anything other than its intended use.

6. Servicing of this equipment should be performed by qualiﬁed personnel.

7. Disconnect AC power before servicing.

RAB ﬁxtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is

required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

J-BOX MOUNTING INSTALLATION

1. Feed ﬁxture leads through the back plate and connect to AC power

supply (Fig. 1). For 120V use black and white wires and for 277V, use

red and white wires.

2. Attach back plate to J-Box and secure with screws.

3. Complete the battery connection. (Fig. 2)

4. Align snaps and push housing directly onto the back plate (Fig. 3).

Apply continuous AC power and press "TEST" button to check light.

CONDUIT INSTALLATION

1. Secure back plate to wall surface . Route wires through hole in

conduit ﬂange and make conduit connection. For 120V, use black

and white wires and for 277V, use red and white wires.

2. Complete the battery connection (Fig. B).

3. Align snaps and push housing directly onto the back plate (Fig. C).

Apply continuous AC power and press "TEST" button to check light.

LED

POWERED!

IMPORTANT:

Let the battery charge up for at least 24 hours.Then normal operation of this unit should take eﬀect. To check, press the " TEST "

button. The LED lamps on the unit should turn ON. During an electrical power failure, the led lamps will automatically come on

for a minimum of 90 minutes. In accordance with NFPA 101, your emergency lighting system must be tested monthly for a

minimum of 30 seconds and annually for 90 minutes. Refer to your local codes for any additional requirements that may apply.

J-Box

BATTERY CONNECTOR

PLUG IN

WARNING:

Unused wires must be capped using enclosed wire nuts.

Fig: 1 Fig: 2 Fig: 3

EM EMERGENCY LIGHTING

OPERATION

Easy Answers

EML-IN-0123

Cranbury, New Jersey 08512 USA

2023

NOTE: Use 18-22 AWG stranded wire to connect remote lamp heads.

NOTE: Unused input lead must be properly insulated with wire nut or other approved method.

1. During an electrical power failure, the LED lamps will automatically come on for a minimum of 90 minutes.

2. To test, depress the "TEST" switch. The emergency LED lamps will illuminate. When the switch is released, the lamps will go oﬀ.

REGULARREMOTE CAPABLE

BLUE(-)

YELLOW(+)

BLUE(-)

YELLOW(+)

LAMP

YELLOW(+)

LAMP

READY

TEST

BATTERY

RED

BLACK

RED

BLACK

WHITE

277V

120V

RED

BLACK

WHITE

277V

120V

CHARGER

BOARD

LAMP

READY

TEST

BATTERY

RED

BLACK

LAMP

AC INPUT CONNECTOR

(MOUNTING PLATE)

AC INPUT CONNECTOR

(MOUNTING PLATE)

TO REMOTE

CHARGER

BOARD

BLUE(-)

YELLOW(+)

BLUE(-)

YELLOW(+)

WIRING DIAGRAMS

Inhaltsverzeichnis

Andere RAB Beleuchtungsausrüstung Handbücher

RAB

RAB T5HE-10-24P-8-EXT Series Bedienungsanleitung

RAB

RAB GT500R/L Bedienungsanleitung

RAB

RAB SHARK - 8FT Bedienungsanleitung

RAB

RAB EM-2H2RNY Bedienungsanleitung

RAB

RAB DRI-21-EMGR-DC-D10 Bedienungsanleitung

RAB

RAB LESLIE Bedienungsanleitung

RAB

RAB FFLEDXS Bedienungsanleitung

RAB

RAB PLL-14-8 DIR Series Bedienungsanleitung

RAB

RAB GUS- 2FT Bedienungsanleitung

RAB

RAB STL200H/L Bedienungsanleitung

RAB

RAB ECOMBO34 Bedienungsanleitung

RAB

RAB X17 XFU 60W Bedienungsanleitung

RAB

RAB FIELD-ADJUSTABLE TOMO-2 Bedienungsanleitung

RAB

RAB PLC-9-V-8XX-BYP Bedienungsanleitung

RAB

RAB STL360HB/L Bedienungsanleitung

RAB

RAB SMSLES2X13 Bedienungsanleitung

RAB

RAB SWISHFA -2X2 Bedienungsanleitung

RAB

RAB Lightcloud Controller Mini Bedienungsanleitung

RAB

RAB GOTCHA PLUS GT500 Bedienungsanleitung

RAB

RAB T8 Bedienungsanleitung

RAB

RAB STEALTH 360 Bedienungsanleitung

RAB

RAB X34 Bedienungsanleitung

RAB

RAB STRING-50 Bedienungsanleitung

RAB

RAB EXIT34-RG Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung