Radio Shack Digital Answering System with Big Button Trim... Bedienungsanleitung
Owner’s Manual
Please read before using this equipment.
Digital Answering System
with Big Button Trim Phone
43-3804.fm Page 1 Thursday, July 6, 2000 2:35 PM
2
Your system is ETL listed to UL standards and meets all appli-
cable FCC standards.
WARNING: To reduce the risk of fire or
shock hazard, do not expose this product to rain
or moisture.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
This symbol is intended to alert
you to the presence of uninsu-
lated dangerous voltage within
the product’s enclosure that might
be of sufficient magnitude to con-
stitute a risk of electric shock. Do
not open the product’s case.
This symbol is intended to inform
you that important operating and
maintenance instructions are
included in the literature accom-
panying this product.
!
!
©2000 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
43-3804.fm Page 2 Thursday, July 6, 2000 2:35 PM
3
Contents
ˆ
Contents
Features ................................................................................. 5
Read This Before Installation .......................................... 7
FCC Statement ................................................................ 8
Installation ............................................................................. 9
Selecting a Location ........................................................ 9
Connecting Power ........................................................... 9
Installing the Backup Battery ......................................... 11
Mounting the System ..................................................... 12
On a Desktop ......................................................... 12
Directly on the Wall ................................................. 13
On the Wall Plate .................................................... 14
Connecting the Handset ................................................ 14
A Quick Look ....................................................................... 15
Telephone Operation .......................................................... 18
Setting the PULSE/TONE Switch .................................. 18
Setting the Ringer .......................................................... 18
Using REDIAL ............................................................... 19
Using RESET ................................................................ 19
Using FLASH ................................................................. 19
Volume Control .............................................................. 19
Using Tone Services on a Pulse Line ............................ 20
Using Memory Dialing ................................................... 20
Storing a Number in Memory ................................. 20
Dialing a Stored Number ........................................ 21
Testing Stored Emergency Numbers ...................... 21
Chain-Dialing Special Service Numbers ................ 21
43-3804.fm Page 3 Thursday, July 6, 2000 2:35 PM
4Contents
Answering System .............................................................. 22
Preparation .................................................................... 22
Turning the Answering System On/Off ................... 22
Adjusting the Volume .............................................. 23
Setting the Day and Time ....................................... 23
Setting the Number of Rings .................................. 24
Recording Outgoing Messages (OGM) .................. 25
Operation ....................................................................... 26
Setting the Answering System to Answer Calls ..... 26
Using the Announce-Only Feature ......................... 27
Screening Calls ...................................................... 28
Playing Incoming Messages ................................... 29
Deleting Messages ................................................. 30
Remote Operation ............................................................... 30
Remote Operation Security Code .................................. 31
Operating the Answering System
from a Remote Location ................................................ 31
Remote Commands ............................................... 32
Troubleshooting .................................................................. 33
Care ...................................................................................... 34
The FCC Wants You to Know ........................................ 35
Lightning ........................................................................ 35
43-3804.fm Page 4 Thursday, July 6, 2000 2:35 PM
5
Features
ˆ
Features
Your Digital Answering System is a sophisticated fully-digital
message center that combines a telephone and an answering
machine in one convenient package.
Fully-digital means the answering system stores all messages
on a computer chip. This gives you advanced capabilities over
tape-based answering machines. For example, you can delete
an individual message while saving the rest. And, of course,
there are no tape mechanisms to wear out and no tapes to
bother with.
The system’s features include:
ANSWERING SYSTEM
Call Screening — lets you listen as a caller leaves a message
so you can decide whether or not to answer a call.
Voice Day/Time Stamp — records the day and time each in-
coming message was recorded.
Message Indicator — flashes to let you know you have new
messages.
Remote Operation — lets you use a touch-tone phone (or rota-
ry phone and pocket tone dialer) to operate the telephone an-
swering system while you are away from your home or office.
Remote Answer-On — lets you call the system from a remote
location and set it to answer calls.
43-3804.fm Page 5 Thursday, July 6, 2000 2:35 PM
6Features
Adjustable Ring Number — lets you set the system to answer
after two, four, or seven rings.
Toll-Saver — lets you avoid unnecessary toll charges when
you call long-distance to check your messages.
Announce-Only — lets you set the system to play an an-
nouncement or memo for the caller, then automatically hang up
without letting the caller leave a message.
Outgoing Message Capacity — lets you set the system to play
an outgoing message and record the caller’s message.
Selectable Incoming Message Length — lets you set the
maximum length of a caller’s message to 1 or 5 minutes.
High Capacity — lets you record up to 10 minutes of incoming/
outgoing messages and memos.
Phone Pickup Detection — stops recording when you pick up
any phone on the same line as the system, and resets to an-
swer the next call.
Built-In Announcement — lets you immediately begin using
the system to answer calls and record messages.
Volume Control — lets you adjust the speaker’s volume during
message playback.
Memory Full Warning — beeps twice and announces “Sorry,
memory is full.”
43-3804.fm Page 6 Thursday, July 6, 2000 2:35 PM
7
Features
TELEPHONE
13-Number Memory Dialing — lets you store up to 13 phone
numbers in memory for easy dialing: 3 priority (one-touch) num-
bers and 10 standard numbers.
Volume Control — lets you adjust the handset’s volume.
Ringer Control — lets you set the ringer to a high or low vol-
ume or turn off the ringer.
Redial — lets you quickly dial the last number dialed.
Flash — sends an electronic switchhook signal for use with
special services, such as Call Waiting.
Touch-Tone or Pulse Dialing — lets you use the phone with
either type of service.
Reset — equivalent to pressing and releasing the switchhook
on the phone.
READ THIS BEFORE INSTALLATION
Your system conforms to federal regulations, and you can con-
nect it to most telephone lines. However, each device that you
connect to the phone line draws power from the line. We refer to
this power draw as the device’s ringer equivalence number, or
REN. The REN is on the bottom of the system.
If you are using more than one phone or other device on the
line, add up all the RENs. If the total is more than five (three in
rural areas), your phone might not ring or your answering sys-
tem might not answer. If ringer operation is impaired, remove a
device from the line.
43-3804.fm Page 7 Thursday, July 6, 2000 2:35 PM
8Features
FCC STATEMENT
Your system complies with Part 68 of
FCC Rules
. You must,
upon request, provide the FCC registration number and the
REN to your phone company. Both numbers are on the bottom
of your system.
Note: You must not connect your system to:
• coin-operated systems
• party-line systems
• most electronic key phone systems
Your system complies with the limits for a Class B digital device
as specified in Part 15 of
FCC Rules
. These limits provide rea-
sonable protection against radio and TV interference in a resi-
dential area. However, your system might cause TV or radio
interference even when it is operating properly. To eliminate in-
terference, you can try one or more of the following corrective
measures:
• Reorient or relocate the receiving antenna of the radio or
TV antenna.
• Increase the distance between the system and the radio or
TV.
• Use outlets on different electrical circuits for the system
and the radio or TV.
Consult your local RadioShack store if the problem still exists.
43-3804.fm Page 8 Thursday, July 6, 2000 2:35 PM
9
Installation
ˆ
Installation
SELECTING A LOCATION
Select a location for the system that is near both a modular
phone jack and an AC outlet, and out of the way of normal activ-
ities. You can place the system on a flat surface or mount it on a
wall plate or directly on the wall.
Notes:
• If the phone line jack is not a modular jack, you must
update the wiring. You can convert the wiring yourself,
using jacks and adapters available at any RadioShack
store. Or, you can let the phone company update it for you.
• The USOC number of the jack to be installed is RJ11C for a
standard modular phone jack or RJ11W for a wall-plate jack.
CONNECTING POWER
You can power the system using the supplied 9V, 300-mA AC
adapter.
Cautions:
You must use a Class 2 power source that sup-
plies 9V DC and delivers at least 300 mA. Its cen-
ter tip must be set to positive and its plug must fit
the system’s 9VDC 300 mA jack. The supplied adapter
meets these specifications. Using an adapter that does not
!
43-3804.fm Page 9 Thursday, July 6, 2000 2:35 PM
10 Installation
meet these specifications could damage the system or the
adapter.
• Always connect the AC adapter to the system before you
connect it to AC power. When you finish, disconnect the
adapter from AC power before you disconnect it from the
system.
Follow these steps to connect the AC adapter.
1. Insert the barrel plug of the supplied AC adapter into the
9VDC 300 mA jack.
2. Plug the other end of the adapter into a standard AC outlet.
The system beeps twice and the MESSAGE indicator lights, fol-
lowed by 4 tones. The LOW BATT indicator blinks. After running
a self test, the system sets all internal default values.
Notes:
• Do not press any of the answering system’s buttons while
you are plugging the adapter into the AC outlet. If you acci-
43-3804.fm Page 10 Thursday, July 6, 2000 2:35 PM
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Radio Shack Anrufbeantworter Handbücher
Radio Shack
Radio Shack TAD 3809 Bedienungsanleitung
Radio Shack
Radio Shack TAD-704 Bedienungsanleitung
Radio Shack
Radio Shack 43-3808 Bedienungsanleitung
Radio Shack
Radio Shack 900MHz Bedienungsanleitung
Radio Shack
Radio Shack 43-3803 Bedienungsanleitung
Radio Shack
Radio Shack 43-3822 Bedienungsanleitung
Radio Shack
Radio Shack 43-3808A Bedienungsanleitung
Radio Shack
Radio Shack TAD-716 Bedienungsanleitung
Radio Shack
Radio Shack TAD-277 Bedienungsanleitung
Radio Shack
Radio Shack TAD-723 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1006 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1029 Bedienungsanleitung
Radio Shack
Radio Shack TAD-798 Bedienungsanleitung
Radio Shack
Radio Shack 14 Minute Bedienungsanleitung
Radio Shack
Radio Shack TAD-799 Bedienungsanleitung
Radio Shack
Radio Shack TAD-716 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1027 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1026 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1009 Bedienungsanleitung
Radio Shack
Radio Shack TAD-1007 Bedienungsanleitung
