Radio Shack Racing Battery Pack AC/DC Charger Bedienungsanleitung

Cat. No. 23-411

OWNER’S MANUAL

Please read before using this equipment.

Racing Battery Pack AC/DC Charger

for 4.8V/6V/7.2V/9.6V Ni-Cd Battery Packs

23-411.fm Page 1 Friday, August 6, 1999 3:00 PM

FEATURES

Your RadioShack Racing Battery Pack

AC/DC Charger is perfect for charging

your radio-controlled racing cars’ battery

packs. It connects to standard AC power

or your vehicle’s cigarette-lighter socket,

and can fully charge 4.8V, 6V, 7.2V and

9.6V nickel-cadmium Racing Battery

Packs in as little as 15 minutes! (High-

capacity 7.2V, 1700 mAh and 9.6V, 900

mAh battery packs require more time to

fully charge.)

Your charger also includes these fea-

tures:

DC Reverse-Polarit

Input Protection

— prevents damage to the charger, the

battery pack, and your vehicle’s electri-

cal system.

Char

Indicator — lights when the

battery pack is charging and automati-

cally turns off when charging is finished.

Two Char

Power Sources — lets

you use your vehicle’s battery or stan-

dard AC power to charge a battery pack.

Start Button — makes battery-pack

charging simple.

Thermal Sensor — stops charging au-

tomatically if the battery becomes too

hot.

This symbol is intended to alert you to

the presence of uninsulated danger-

ous voltage within the product’s enclo-

sure that might be of sufficient

magnitude to constitute a risk of elec-

tric shock. Do not open the product’s

case.

This symbol is intended to inform you

that important operating and mainte-

nance instructions are included in the

literature accompanying this product.

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

CAUTION: TO REDUCE THE RISK OF

ELECTRIC SHOCK, DO NOT REMOVE

COVER OR BACK. NO USER-SERVICE-

ABLE PARTS INSIDE. REFER SERVIC-

ING TO QUALIFIED PERSONNEL.

WARNING: To reduce the risk of

fire or shock hazard, do not ex-

pose this product to rain or mois-

ture.

RadioShack is a registered trademark used by Tandy Corporation.

23-411.fm Page 2 Friday, August 6, 1999 3:00 PM

IMPORTANT SAFETY INSTRUCTIONS

1. SAVE THESE INSTRUCTIONS —

This manual contains important

safety instructions for battery

charger Cat. No. 23-411.

2. Before using the battery charger,

read all instructions and cautionary

markings on the battery charger, the

battery, and the product using the

battery.

3. CAUTION — To reduce risk of

injury, charge only Ni-Cd type

rechargeable batteries. Other types

of batteries may burst, causing per-

sonal injury and damage.

4. Charge only one battery pack at a

time.

5. Be sure that the battery pack is

rated at 4.8, 6, 7.2, or 9.6 volts.

6. Avoid charging fully-charged bat-

tery packs. Doing so can damage

the battery pack or cause it to lose

some of its storage capacity.

7. Charge battery packs only at room

temperature (65–80°F). Charging a

battery pack in a hot area can per-

manently reduce the battery pack’s

power capacity.

8. Do not expose the charger to rain or

excessive moisture.

23-411.fm Page 3 Friday, August 6, 1999 3:00 PM

OPERATION

This table shows the estimated typical

fast-charging time for battery packs of

different capacities:

Note: If you are charging

high-capacity

7.2-volt, 1700 mAh, and 9.6-volt, 900

mAh battery packs, you must run them

for two charging cycles to fully charge

them.

Before you charge a battery pack, use it

until it no longer provides the necessary

power.

Warnin

• To reduce the risk of injury, charge

only rechargeable nickel-cadmium

battery packs with this charger. Try-

ing to charge other types of battery

packs could cause the packs to leak

or become very hot and explode,

causing injury to bystanders or dam-

age to your charger.

• Do not charge a battery pack that is

damaged or leaking.

• Do not cover the vents on the top

and back of the charger while charg-

ing a battery pack.

CONNECTING TO AC

POWER

Plug the charger’s power cord into a

standard AC outlet. The POWER indica-

tor lights.

Capacity Charging

Current

(mA)

Charging

Time

(minutes)

4.8V/6V

(600 mAh) 2500 15

7.2V

(1200 mAh) 4500 16

7.2V

(1700 mAh) 4500 23

9.6V

(600 mAh) 2500 15

9.6V

(900 mAh) 2500 22

ILLUSTRATION

of power cord

w/AC outlet

23-411.fm Page 4 Friday, August 6, 1999 3:00 PM

CONNECTING TO A

VEHICLE’S CIGARETTE-

LIGHTER SOCKET

Plug the DC cord into your vehicle’s cig-

arette-lighter socket.

Note: If the charger does not operate

when it is connected to the cigarette-

lighter socket, remove the DC adapter

from the cigarette-lighter socket and

check the socket for debris. Also check

the fuse in the adapter and your vehi-

cle’s fuse block.

CHARGING BATTERY

PACKS

1. To charge a 6V battery pack, simply

insert it into the compartment on the

charger, then skip to Step 3.

To charge a 7.2V or 9.6V battery

pack, slide its connector into the

CHARGING JACK socket. If the con-

nector does not fit, turn it over and

try again. Do not force it.

To charge a 4.8V battery pack, plug

the small end of the supplied

adapter cord fully into the battery

pack’s connector. Then plug the

adapter cord’s large end fully into

the

CHARGING JACK socket.

ILLUSTRATION

of DC cord

connection ILLUSTRATION

of 6V battery

connection

ILLUSTRATION

of 7.2 V battery pack

connection

23-411.fm Page 5 Friday, August 6, 1999 3:00 PM

2. Insert the battery pack into the com-

partment on the battery charger.

3. Insert THERMAL SENSOR into SEN-

SOR HOLDER.

4. Press START to start charging. The

CHARGE indicator lights.

Notes:

• If the battery pack becomes too

hot, the thermal sensor makes

charging stop automatically.

• If the charging time and battery

pack’s life are both very short, the

battery pack might be damaged.

5. When charging is complete, the

charger and indicator automatically

turn off. Disconnect and remove the

battery pack from the charger, then

unplug the charger’s power cord.

ILLUSTRATION

of 4.8 V battery

pack connection

ILLUSTRATION

of THERMAL SENSOR

in sensor socket

23-411.fm Page 6 Friday, August 6, 1999 3:00 PM

REPLACING THE FUSE

The charger’s fuse blows if you connect

the DC cord’s clamps to the wrong bat-

tery terminals. This protects the charger,

the battery pack, and your vehicle’s

electrical system. We recommend that

you keep some spare 5-amp, 11/4-inch

slow blow fuses (such as Cat. No. 270-

1027) with your charger, in case the

fuse blows.

Caution: Do not use a fuse with ratings

other than those specified here. Doing

so might damage your charger.

If the CHARGE indicator does not light

or the charger does not operate when

you turn it on, follow these steps to

check and replace the fuse.

1. Disconnect and remove the battery

pack from the charger.

2. Unplug the AC power cord or

remove the DC power cord from

your vehicle’s cigarette-lighter

socket.

3. Twist off the fuse holder’s black cap

and carefully remove the inner tip,

the spring, and the outer tip. If the

fuse is blown, replace it with an

identically rated 5-amp fuse.

Note: Blown fuses usually are dis-

colored or have a broken center

wire.

4. Replace the outer tip, the spring, the

inner tip, and the black cap. Tighten

the cap securely.

ILLUSTRATION

of battery pack

disconnection

ILLUSTRATION

of open fuse holder

w/fuse

23-411.fm Page 7 Friday, August 6, 1999 3:00 PM

CARE AND MAINTENANCE

Your Racing Battery Pack AC/DC Charger for 4.8V/6V/7.2V/9.6V Ni-Cd Battery

Packs is an example of superior design and craftsmanship. The following sugges-

tions will help you care for your charger so you can enjoy it for years.

Keep the charger dry. If it gets wet, wipe it dry immediately. Liquids can

contain minerals that corrode electronic circuits.

Use and store the charger only in normal temperature environments.

Temperature extremes can shorten the life of electronic devices, dam-

age batteries, and distort or melt plastic parts.

Handle the charger gently and carefully. Dropping it can damage circuit

boards and cases and can cause the charger to work improperly.

Keep the charger away from dust and dirt, which can cause premature

wear of parts.

Wipe the charger with a damp cloth occasionally to keep it looking new.

Do not use harsh chemicals, cleaning solvents, or strong detergents to

clean your charger.

Modifying or tampering with the charger’s internal components can cause a malfunc-

tion and invalidate your charger’s warranty. If your charger is not performing as it

should, take it to your local RadioShack store for assistance.

23-411.fm Page 8 Friday, August 6, 1999 3:00 PM

SPECIFICATIONS

Charging Current .......................................... 2.5 Amps for 4.8V, 6V and 9.6V battery

4.5 Amps for 7.2 battery

AC Supply Voltage ............................................................................. AC 120V 60 Hz

DC Supply Voltage .................................................................................... DC 11–16V

Charging Times: (Fully Discharged Battery Pack)

Minimum Charging Time ............................................................................ 15 Minutes

Maximum Charging Time ........................................................................... 23 Minutes

Average Charging Time ............................................................................. 18 Minutes

Specifications are typical; individual units might vary. Specifications are subject to

change and improvement without notice.

23-411.fm Page 9 Friday, August 6, 1999 3:00 PM

NOTES

23-411.fm Page 10 Friday, August 6, 1999 3:00 PM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Radio Shack Akkuladegerät Handbücher

Radio Shack

Radio Shack 23-348 Bedienungsanleitung

Radio Shack

Radio Shack Universal Battery Pack Conditioner/Charger Bedienungsanleitung

Radio Shack

Radio Shack 23-422 Bedienungsanleitung

Radio Shack

Radio Shack RC Car Battery Universal Fast Charger Bedienungsanleitung

Radio Shack

Radio Shack 23-437 Bedienungsanleitung

Radio Shack

Radio Shack 23-322 Bedienungs- und Wartungsanleitung

Radio Shack

Radio Shack 23-428 Bedienungsanleitung

Radio Shack

Radio Shack 23-226 Bedienungsanleitung

Radio Shack

Radio Shack Battery Charger Bedienungsanleitung

Radio Shack

Radio Shack 5-Hour AA & AAA Ni-Cd/Ni-MH Battery Charger Bedienungsanleitung

Radio Shack

Radio Shack AA Travel Charger Pack Bedienungsanleitung

Radio Shack

Radio Shack 23-436 Bedienungsanleitung

Radio Shack

Radio Shack 23-416 Bedienungsanleitung

Radio Shack

Radio Shack Ni-Cd/Ni-MH Universal Battery Charger Bedienungsanleitung

Radio Shack

Radio Shack 5-Hour Bedienungsanleitung

Radio Shack

Radio Shack 21-1930 Bedienungsanleitung

Radio Shack

Radio Shack 23-419 Bedienungsanleitung

Radio Shack

Radio Shack 20 Hour 9.6 V Ni-Cd/NI-MH Battery Pack... Bedienungsanleitung

Radio Shack

Radio Shack 23-401 Bedienungsanleitung

Radio Shack

Radio Shack 23-418 Bedienungsanleitung

Radio Shack

Radio Shack 0904-211-18801 Bedienungsanleitung

Radio Shack

Radio Shack Twin RC Bedienungsanleitung

Radio Shack

Radio Shack 23-410 Bedienungsanleitung

Radio Shack

Radio Shack Ni-Cd Bedienungsanleitung

Beliebte Akkuladegerät Handbücher anderer Marken

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Bedienungsanleitung

Enelion

Enelion Vertica Bedienungsanleitung

RCA

RCA CHU6 Bedienungsanleitung

ANSMANN

ANSMANN ALCT 6/24-10 Bedienungsanleitung

Hitachi

Hitachi UC 18YRSL Fehlerbehebungshandbuch

Olympus

Olympus B-20 LPC Bedienungsanleitung

Exibel

Exibel ZH1708143 Bedienungsanleitung

Lenmar

Lenmar Mach 1 Bedienungsanleitung

CTEK

CTEK MXS 5.0 Bedienungsanleitung

ABB

ABB HT842379 Bedienungsanleitung

Nitecore

Nitecore Superb Charger SC4 Bedienungsanleitung

Renogy

Renogy RBC2125DS-21W Bedienungsanleitung

Braun

Braun BWC02M Bedienungsanleitung

CTEK

CTEK MXS 3.6 Bedienungsanleitung

Black & Decker

Black & Decker BDV090 Bedienungsanleitung

Trinity

Trinity DPD Bedienungsanleitung

Hulkman

Hulkman Sigma 1 Bedienungsanleitung

IKEA

IKEA koppla Bedienungsanleitung