Rane SIXTY-TWO Bedienungsanleitung

VirtualDJ 8 –Rane Sixty-Two

Table of Contents

Installation................................................................................................................................3

Connections ...........................................................................................................................3

Drivers....................................................................................................................................4

VirtualDJ 8 Setup ...................................................................................................................4

Advanced Setup.....................................................................................................................5

VirtualDJ & Hardware Functionality ......................................................................................6

A. Volume Mixer..................................................................................................................7

B. HotCues & Sampler........................................................................................................7

C. Effects.............................................................................................................................8

D. Equalizer, Filter & Effects...............................................................................................9

E. Microphone & Video Software Controls .......................................................................10

F. Master & Booth.............................................................................................................11

G. Loop, Browser & Other Controls..................................................................................11

H. Auxiliary/Sampler..........................................................................................................12

I. Headphones..................................................................................................................13

J. Front panel....................................................................................................................13

K. Rear Panel....................................................................................................................14

Advanced Audio Setups .......................................................................................................15

Timecode (DVS)...................................................................................................................15

Sampler Output....................................................................................................................16

Back to back.........................................................................................................................17

Recording.............................................................................................................................17

VirtualDJ 8 –Rane Sixty-Two

Installation

Connections

Connect your computer to USB A (or B) port at the rear panel of Rane Sixty-Two.

Connect your Left deck’s RCA cables to ANALOG INPUT 1.

If it’s a CD player, select CD with the switch above the input jacks.

If it’s a turntable, select PH (Phono) with the switch above the input jacks. Secure the

ground wire to a Phono Ground terminal.

Connect your Right deck’s RCA cables to ANALOG INPUT 3.

If it’s a CD player, select CD with the switch above the input jacks.

If it’s a turntable, select PH (Phono) with the switch above the input jacks. Secure the

ground wire to a Phono Ground terminal

Set the SOURCE selector for DECK 1 to A (or B if the USB B port is used).

Set the SOURCE selector for DECK 2 to A (or B if the USB B port is used).

Connect the Rane Sixty-Two with AC power using the provided cable and power on

the unit

VirtualDJ 8 –Rane Sixty-Two

Drivers

Windows: Download and install the necessary ASIO drivers from

http://dj.rane.com/products/sixty-two (Downloads tab)

Mac OSX: Download and install the necessary CoreAudio drivers from

http://dj.rane.com/products/sixty-two (Downloads tab)

VirtualDJ 8 Setup

Download and install VirtualDJ 8 from

http://www.virtualdj.com/download/index.html

(in case you have not done already)

Once VirtualDJ 8 is launched, a Login Window

will appear. Login with your virtualdj.com

account credentials.

A Pro Infinity, a PLUS* or a Pro

Subscription License is required to use the

Rane Sixty-Two. Without any of the above

Licenses, the controller will operate for 10

minutes each time you restart VirtualDJ.

http://www.virtualdj.com/buy/index.html

*For DVS Support an additional Timecode Plus

license is required if the Rane 62 Plus license is

purchased.

A window will appear next, to verify the

proper detection.

Click on the “Use Soundcard” button and

VirtualDJ will automatically create and apply

the pre-defined audio configuration using the

built-in audio interface of the Rane Sixty-

Two.

Click to OK.

The unit is now ready to operate with VirtualDJ.

VirtualDJ 8 –Rane Sixty-Two

Advanced Setup

MIDI Operation

The unit should be visible* in the

CONTROLLERS tab of Config and the

“factory default” available/selected from the

Mappings drop-down list.

The factory default Mapping offers the

functions described in this Manual, however

those can be adjusted to your needs via VDJ

Script actions.

Find more details at

http://www.virtualdj.com/wiki/VDJscript.html

AUDIO Setup

The unit has a pre-defined Audio setup and

a special button in the AUDIO tab of Config

to provide that. Alternative setups can be

applied in the same window.

Timecode (DVS)* configuration is pre-

configured (see DVS Support for more

details).

*requires Pro Infinity or Timecode License

http://www.virtualdj.com/buy/index.html

For further software settings please refer to the User Guides of VirtualDJ 8.

http://www.virtualdj.com/wiki/PDFManuals.html

VirtualDJ 8 –Rane Sixty-Two

VirtualDJ & Hardware Functionality

VirtualDJ 8 –Rane Sixty-Two

S. SHIFT. Press and hold this button down to access secondary software or hardware

functions (mostly in gray lettering) of other controls on the Rane Sixty-Two

A. Volume Mixer

1. CROSSFADER. Blends audio

between the left and right

channels/decks.

2. VOLUME. Use these faders to

adjust the Output Volume of each

mixer channel.

3. CUE. Press these buttons to send

a channel's (left, right or USB Aux)

pre-fader signal to the Phones

Channel for monitoring. When

engaged, the button will be lit.

By pressing one CUE button at a time, you will cue that channel alone (and

deactivate CUE monitoring for the other channels). To cue to more than 1 channel

simultaneously, press these channels’ CUE buttons at the same time.

Notes

The CUE buttons of the Sixty-Two will not control the PFL buttons of the VirtualDJ GUI

(hardware operation), nor will the PFL buttons will define which channel is sent to the Phones

channel of the Rane Sixty-Two.

The Crossfader and Volume faders will move the relative faders of the VirtualDJ GUI, but not

vice versa (Fake mixer mode)

B. HotCues & Sampler

This section offers HotCues and Sampler functions depending on the selected mode.

4. CUES/SAMPLES. Use this button to toggle between the HotCues (Orange Led) and

the Sampler mode (Red Led)

5. HOTCUES (1-5)/ SAMPLES (1-6).

In HotCues mode, each one of the 5 buttons per side (1-5) assigns a Hot Cue Point

(1 to 5) to the left or right deck if un-assigned or returns the track to that Hot Cue Point if

assigned.

When a Hot Cue Button is unlit, you can assign a Hot Cue Point by pressing it at the desired

point in your track. Once it is assigned, the Hot Cue Button will light up bright amber.

VirtualDJ 8 –Rane Sixty-Two

Hold SHIFT down and then press any of these buttons to delete* its assigned Hot Cue

Point.

In Sampler mode, each one of the 6 buttons (marked as >1 to >6) triggers a sample

(1 to 6) from the selected Sampler Bank of VirtualDJ.

The leds of those buttons will be turned off if the corresponding slot is unloaded, dark green

if loaded and bright green if playing

Use the buttons A and B to select and load the previous and next Sampler Bank

respectively

Use the buttons C and D to select the previous and next Sampler trigger mode

respectively

Sampler Output Channel: By default VirtualDJ will send Sampler to the USB AUX

Channel. Use the AUX LEVEL knob to control the Output Volume, the AUX Filter

knob to apply a Low-High Pass Filter and the AUX FLEX button to apply the selected

Hardware FLEX Effect to the playing samples.

See more Sampler Output options in Sampler Output.

*Note. Due to a firmware miss-behavior, SHIFT+buttons (5) will still delete the assigned HotCues,

even if the Sampler mode is selected.

C. Effects

The Effects section of the Rane Sixty-Two is offering a variety of high-quality effects

that can be applied to either left or right decks or even to the Microphone and USB Aux

input, using the blue FLEXFX buttons

VirtualDJ will send to the Rane Sixty-Two the BPM values of both left and right decks

if the corresponding FLEXFX buttons are engaged, in order the applied Effects to be

synchronized on the selected beat pattern. The LCD display will show a small S (Software)

next to the BPM value when received from the software.

The functionality of this section is briefly described below. Please refer to the Manual

of the Rane Sixty-Two for a detailed description.

VirtualDJ 8 –Rane Sixty-Two

6. EFFECTS. Use these 6 buttons to select one of the available hardware effects.

7. DEPTH. Use this knob to adjust the depth of the applied/selected Effect

8. CUE. If enabled the applied Effects will be also heard to the Prelisten Channel

9. FX ON. Use this button to turn on/off the selected Effect and apply to the selected

deck, microphone or AUX Channel.

10. TAP. Use this button (tap on beat) to manually adjust the tempo that will be used for

the applied Effect.

11. BEAT. Use this joystick to select the Beat pattern that the selected Effect will use.

12. TIME. Use this knob to fine adjust the time (affects the Beat pattern) or other

parameter of the applied Effect.

D. Equalizer, Filter & Effects

13. USB/INPUT SEL. Set this

selector to the appropriate

position to define which Channel

Input will be routed to the 2

Mixer Channel Outputs (DECK 1

and DECK 2).

On USB A or USB B position,

the audio signal from the

computer connected to the USB

A or USB B port (rear panel) will

be routed to the Output of this

Mixer Channel and assign the

MIDI controls for the Left or

Right channels to the same

computer.

On INPUTS 1, 2 (for DECK 1) and 3, 4 (for DECK 2), the audio signal from the Inputs

(1, 2, 3 and 4 at the rear panel) will be routed directly to the Output of this Mixer

Channel. In this case the sound from the computer’s decks will be muted. Use this

position to route external analogue media sources or for Timecode (DVS) use.

14. PAN. Use this knob to control the Pan (Left-Right Balance) of each mixer channel.

15. FILTER. Applies a High-Pass / Low-Pass Filter on each mixer channel.

16. FLEXFX. Use this button to route the applied Hardware Effect on each mixer channel

17. LEVEL. Adjusts the input audio level (gain) up to +15db of the left and right mixer

channel. No boost or cut is at 12 o’clock position.

VirtualDJ 8 –Rane Sixty-Two

18. HIGH. Full-cut isolator to adjust the high (treble) frequencies of each mixer channel.

19. MID. Full-cut isolator to adjust the middle (mid) frequencies of each mixer channel

20. LOW. Full-cut isolator to adjust the low (bass) frequencies of each mixer channel.

E. Microphone & Video Software Controls

21. MIC ON. Use this button to turn on/off the

Microphone Input without ducking other inputs.

22. MIC OVER. Use this button to momentary turn

on the Microphone Input and duck the other

inputs by 10 dB (around 1/3). On release, the

microphone input is turned off.

23. MIC LEVEL. Use this knob to adjust the output

level of the microphone input.

24. MIC HIGH. Full-cut isolator to adjust the high

(treble) frequencies of the microphone input

channel.

25. MIC LOW. Full-cut isolator to adjust the low (bass) frequencies of the microphone

input channel.

26. MIC FLEXFX. Use this button to route the applied FLEXFX effects on the

Microphone Input.

Video mode

The Microphone section of the Rane Sixty-Two is not controlling the Microphone

section of the VirtualDJ GUI (Master panel) and vice versa. However, the entire

Microphone section can be used as MIDI controls. If you do not use the MIC section

you can independently bypass the controls of this section so that they do not affect

audio and only output their MIDI assigned functions.

To toggle MIC bypass mode, hold the SHIFT button and then press the MIC ON

button (21). The led will flash to indicate the MIC bypass mode selection.

Andere Handbücher für SIXTY-TWO

Inhaltsverzeichnis

Andere Rane Musikmixer Handbücher

Rane

Rane MP26 Bedienungsanleitung

Rane

Rane TTM 52I Bedienungsanleitung

Rane

Rane RM6 Bedienungsanleitung

Rane

Rane SM 82 Bedienungsanleitung

Rane

Rane SIXTY-EIGHT Bedienungsanleitung

Rane

Rane TTM 57SL Bedienungsanleitung

Rane

Rane TTM 57SL Bedienungsanleitung

Rane

Rane MP 2S Bedienungsanleitung

Rane

Rane SWISS ARMY SM 26B Bedienungsanleitung

Rane

Rane MLM 103 Bedienungsanleitung

Rane

Rane MLM82S Bedienungsanleitung

Rane

Rane TTM57mkII Bedienungsanleitung

Rane

Rane MP 2016A Bedienungsanleitung

Rane

Rane MP 44 Bedienungsanleitung

Rane

Rane AM1 Bedienungsanleitung

Rane

Rane MP 22 Bedienungsanleitung

Rane

Rane SIXTY-ONE Bedienungsanleitung

Rane

Rane SM 82S Bedienungsanleitung

Rane

Rane MP 44 Bedienungsanleitung

Rane

Rane CM 86 Kurzanleitung

Rane

Rane MP 24 Bedienungsanleitung

Rane

Rane MP2014 Bedienungsanleitung

Rane

Rane FLM 82 Service-Handbuch

Rane

Rane SM 82S Bedienungsanleitung

Beliebte Musikmixer Handbücher anderer Marken

Neve

Neve 8816 Bedienungsanleitung

Mackie

Mackie Onyx Analogue Mixer Bedienungsanleitung

Behringer

Behringer EUROPOWER PMP518M Bedienungsanleitung

Peavey

Peavey S-32 Sanctuary Series Bedienungsanleitung

True

True T9 Touchscreen Console Bedienungsanleitung

Studiomaster

Studiomaster Air Pro 24 Bedienungsanleitung

Pioneer

Pioneer SVM 1000 - Audio/Video Mixer Bedienungsanleitung

Roland

Roland M-160 Bedienungsanleitung

Yamaha

Yamaha MR1642 Bedienungsanleitung

Ecler

Ecler MAC40v Bedienungsanleitung

Pioneer

Pioneer DJM 909 - Battle Mixer W/Effects Bedienungsanleitung

Veeder-Root

Veeder-Root TLS-350 Series Bedienungsanleitung

Alto

Alto APM80.QUAD Bedienungsanleitung

Omnitronic

Omnitronic PM-211 Bedienungsanleitung

SoundCraft

SoundCraft B400 Bedienungsanleitung

Roland

Roland SoundCanvas SC-8820 Bedienungsanleitung

CARVIN

CARVIN RX 1200 Bedienungsanleitung

Roland

Roland M-16E Bedienungsanleitung