P
O
W
E
R
S
A
V
E
R
CLEAN
OVERRIDE
HIGH
OVERRIDE
LOW
BACK
POWER
FAULT
+
-
SET
11/11/2011
11:26 AM
SET CLOCK
6. Press + or – to change the Hour. Press → to move to the Minute setting.
7. Press + or – to change the Minute. Press → to move to the AM or PM setting.
8. Press SET when the time is correct.
9. Press SET again if the user needs to make additional changes. The cursor returns
to the Month setting.
10. If date and time are correct, turn the Selector Knob to SET SCHEDULE, STEP 1.
Setting the Clock
1. Turn Selector Knob to SET CLOCK.
2. Adjust the Time and Date.
3. Turn the Selector Knob to SET SCHEDULE (STEP 1, 2, 3)
4. Set the Motor Speed, Start, and Stop times for STEP 1, 2, 3.
5. Turn the Selector Knob to SETUP (Use ← and → to scroll thru SETUP items)
Enable/Disable Freeze Protection
Set Display Screen Contrast
Set External Relay Speed and Time
Set Prime Speed and Duration
Reset Factory Defaults (Will return programmed schedule to Factory
Defaults)
6. Turn Selector Knob to RUN.
7. Press OVERRIDE HIGH button (Not required to run normal schedule)
8. Press SET to change OVERRIDE HIGH speed and duration.
9. Press OVERRIDE LOW button (Not required to run normal schedule)
10. Press SET to change OVERRIDE LOW speed and duration.
Custom Schedule
NOTE: The clock must be set the rst time the
pump is powered-up for proper operation.
1. Turn the Selector Knob to SET CLOCK.
2. At any time, the user can press BACK to
return to the previous screen.
3. Press + or – to change the Month. Press →
to move to the Day setting.
4. Press the + or – to change the Day. Press →
to move to the Year setting.
5. Press + or – to change the Year. Press → to
move to the Hour setting.
Raypak Inc. 2151 Eastman Avenue, Oxnard, CA 93030 (805) 278-5300 FAX (800) 872-9725 www.raypak.com
