REDCON R720X MINI DSM2/DSMXReceiver
Receiver Specifications:
Name: R720X
Modulation: DSM2/DSMX
Band: 2.4GHz
Range: 1000M
Dimensions (W x Lx H): 29x 15x2 mm
Weight: 1.3g
Voltage Range: 3.3V
Antenna Length Main RX: 15CM, 9CM, 6CM 3 kinds of antenna
Expected Range: 100m (tested with JR DSX9)
Features
3dbi Antenna, long range
Preset failsafe system
Quick Connect
Compatibility (Spectrum and JR DSM2 /DSMX): DX6I,DX7,DX8, DSX7,DSX9 DSX11
Working Voltage: 3.3V
Compatible Controllers:
NAZA32
CC3D
KK2
F3
F4
Mulitiwii-APM
V-BAR-5.3
Binding Procedure
I. Press bind-button connect power to receiver(you could bind it with REDCON CM703,
CM651), please make sure radio in binding process. Receiver LED quick flash then
green LED off it means bind is accomplished. Restart the receiver it works and LED
keep lit.
II. Please make sure the transmitter in binding process.
III. To set fail-safe throttle and control surface positions, (minimum throttle and all
control surfaces set to neutral is suggested). Press and hold the bind button of transmitter
(LED will illuminate), Turn on the transmitter.
IV. Receiver LED will change from rapid flashing to slow flashing and a few seconds
later when bind is accomplished the LED of receiver will illuminate solid. Failsafe should
be programmed correctly .
V. Please use 3.3V power to receiver during binding, DSMX mode is recommended ,
cause DSMX is new.
Notes: Only one time bind procedure is required on a new receiver. Repetitive binding
provides no extra security. Always remember to remove the binding harness after
successful bind is completed.
Package including: R720X Receiver *1 pc
