Regency GFi750 Gas Inbuilt Fireplace | 7
requirements
installer's information
Important Message
The Regency Gas Inbuilt must be installed in ac-
cordance with these instructions. Carefully read all
the instructions in this manual rst.
Note: Failure to follow these instructions
could cause a malfunction of the heater
which could result in death, serious
bodily injury, and/or property damage.
Failure to follow these instructions
may also void your re insurance and/
or warranty.
For Your Safety
This appliance requires air for proper combustion.
Always provide adequate combustion and ventila-
tion air. Follow instructions and information in the
current AS/NZS5601 or local codes. Consult the
"authority having jurisdiction" to determine the
need for a permit prior to starting the installation.
Before You Start
Installation is to be carried out ONLY by an
authorised person.
1) The appliance shall be installed in accordance
with the manufacturer's installation instructions,
local gas tting regulations, municipal building
codes, water supply regulations, electrical wiring
regulations, with AS/NZS5601.
2) Installation and repair should be done
ONLY by an authorised person.
3) The appliance should be inspected before use
and at least annually by an authorised service
person. More frequent cleaning may be required
due to excessive lint from carpeting, bedding
material, etc. It is imperative that control
compartments, burners and circulating air
passageways of the appliance be kept clean
and free from excessive lint from carpeting.
4) See general construction and assembly instruc-
tions. This appliance may only be installed in a
ued, non-combustible replace. The appliance
and ue should be enclosed when installed or
passing through a living area, where children
may come in contact with it.
5) Always connect this space heater to a chimney
and ue to the outside of the building envelope.
Never ue to another room. Make sure that the
ue is properly sized and is of adequate height
to provide the proper draft.
6) Inspect the ueing system annually for blockage
and any signs of deterioration.
7) Any safety glass removed for servicing must be
replaced prior to operating the appliance.
8) To prevent injury, do not allow anyone who is
unfamiliar with the operation to use the replace.
9) Only Regency ue kit part # 946-773 can be
used. This ue kit contains all the components
required to safely install this GFi750 gas inbuilt.
Materials Required
A 240 Volt AC power cord is hooked up to the unit.
Plug 3 wire cord into a suitable receptacle. Do not
cut the ground terminal o under any circumstances.
When connected with 240 volts, the appliance
must be electrically grounded in accordance with
local codes.
This unit is polarity sensitive and will not
operate if polarity is incorrect.
WARNING:
Suitable for installation into a
masonry replace only.
NOTE:
TO BE INSTALLED ON A
NON- COMBUSTIBLE FLOOR.
PACKAGING: The unit and its contents are
packaged to prevent damage during trans-
port. After unboxing, remove the card-
board spacers and plastic wrap and recycle
or dispose of them properly. Carefully re-
move the logs from inside the box before
commissioning it; unwrap each log and set
aside. Refer to subsequent instructions on
proper set up and safety check before com-
missioning the unit.
