Remington X3 POWER-X Series Bedienungsanleitung

X3 Power-X Series Hair Clipper

HC3000

I remington-europe.com

Visit uk.remington-europe.com/product-registration

You must register within 28 days of purchase.

Thank you for buying your new Remington® product. Please read these instructions

carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

• This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been supervised/instructed and

understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be done by children unless they are

older than 8 and supervised. Keep the appliance and cable out of reach of

children under 8 years.

• Do not use the product with a damaged cord. A replacement can be obtained

via our International Service Centres.

• WARNING: For recharging the battery, only use the charger supplied with the

appliance - type reference PA-3215U.

• The adaptor contains a transformer. Do not cut o the adaptor to replace it with

another plug, as this causes a hazardous situation.

• Use this appliance only for its intended use as described in this manual. Do not use

attachments not recommended by Remington.

• Do not use this product if it is not working correctly, if it has been dropped or

damaged, or dropped in water.

• This appliance should never be left unattended when plugged into a power outlet,

except when charging.

• Keep the power plug and cord away from heated surfaces.

• Do not plug or unplug the appliance with wet hands.

• Do not twist or kink the cable, or wrap it round the appliance.

• This appliance is not intended for commercial or salon use.

PARTS

1. Blade set

2. On/O Switch

3. Length adjustment dial

4. Length setting window for 14 - 24 mm

comb

5. Length setting window for 3 - 13 mm

comb

6. Charging indicator light

7. Charger connector

8. 14 - 24 mm comb

9. 3 - 13 mm comb

Not Shown:

• Adaptor

• Cleaning brush

• Oil bottle

GETTING STARTED

CHARGING YOUR APPLIANCE

• Before using your hairclipper for the rst time, charge for 14-16 hours.

• Ensure the product is switched o.

• Connect the charging adaptor to the product and then to the mains.

• When charging, the charge indicator light will light up.

• If the product is not going to be used for an extended period of time (2 – 3 months),

unplug it from the mains and store.

• Fully recharge your hairclipper when you would like to use it again.

• Allow 14-16 hours for a complete charge.

• Note: To preserve the life of your batteries, let them run out every 6 months then fully

charge.

CHARGING VIA STANDARD ELECTRICAL SOCKET

• Ensure the product is switched o.

• Connect the charging adaptor to the product and then to the mains.

USB

• Connect Micro USB to the appliance, and the USB connector to any standard USB port

or charger

• Product will only charge through USB and will not run in corded mode.

CORDED USE

• Connect the charging adaptor to the product then to the mains.

CAUTION Extended mains only use will result in the reduction of the battery life.

CORDLESS USE

• When the product is switched on and fully charged it can be used in cordless mode for

up to 45 minutes.

INSTRUCTIONS FOR USE

BEFORE STARTING THE CUT

• Inspect the clipper making sure that it is free from hair and dirt.

• Seat the person so that their head is approximately at your eye level.

• Before cutting, always comb the hair so it is tangle free and dry.

TO ATTACH A COMB

• Hold the comb with its teeth upward.

• Align the legs of the comb with the holes in the top of the clipper on each side of the

blade and slide the legs into the trimmer until they click (Fig A).

• To remove, rmly pull the comb straight up away from the clipper.

SETTING THE LENGTH OF CUT

• Your clipper comes with two adjustable combs 3 to 13 mm and 14 to 24 mm.

• These provide a length of cut that can be adjusted between 3 and 24 mm in

increments of 1 mm.

1. Select the comb that ts the range of cut you want to achieve.

2. Fit the comb then rotate the length adjustment dial until the length you want appears

in the length selection window for that comb.

3. The length setting colour on the wheel matches the length marker colour on the

comb.

4. For example, if you want a cut length of 20 mm, t the 14 to 24 mm comb then turn the

dial until 20 appears in the length setting window for the 14 - 24 mm comb.

5. Use the clipper without any xed combs for trimming hair close to the skin.

6. This will trim hair to 1mm, holding the clipper so the blades are perpendicular to the

skin will trim hair to 0.5mm.

INSTRUCTIONS FOR CUTTING HAIR

• Turn the product on using the on/o switch.

• For even cutting, allow the comb attachment/blade to cut its way through the hair. Do

not force it through quickly. If you are cutting for the rst time, start with the maximum

comb attachment.

STEP 1 – NAPE OF THE NECK

• Set the comb to 3 mm or 6 mm.

• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of

the head at the base of the neck.

• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a

little at a time.

STEP 2 – BACK OF THE HEAD

• With the comb set at 12 mm or 18 mm, cut the hair at the back of the head.

STEP 3 – SIDE OF THE HEAD

• With the comb set at 3 mm or 6 mm, trim sideburns. Then change to the longer 9 mm

guide comb and continue to cut the top of the head.

STEP 4 – TOP OF THE HEAD

• Use the longer length comb attachment and set it to 24 mm then cut hair on top of the

head against the direction in which the hair normally grows.

• Always work from the back of the head.

STEP 5 – THE FINISHING TOUCHES

• Use the clipper without an attachment comb for close trimming around the base and

sides of the neck.

• To produce a clean straight line at the sideburns, reverse the hair clipper.

• Place the reversed clipper at right angles to the head, tips of the blades lightly

touching the skin and then work downwards.

CARE FOR YOUR HAIRCLIPPER

• Your clipper is tted with high quality blades.

• To ensure long lasting performance of your clipper, clean the blades and unit regularly.

• Always keep the attachment guide comb on the trimmer blade.

AFTER EACH USE

• Ensure the appliance is switched o and unplugged from the charging adapter before

cleaning.

• Brush the accumulated hair from the blades and body of the clipper. Do not submerge

the clipper in water.

• To clean unit, wipe with a damp cloth and dry immediately.

• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.

WASHABLE BLADE CLEANING

• The blades are washable under a running tap but must be removed before they are

cleaned in this way. Keep the body of the device dry at all times.

• Take out the hex screws and disassemble the blade set. Brush and clean out

accumulated hair. Oil the contact surfaces of the blades and then reassemble.

CLEANING CAUTIONS

• Do not use harsh or corrosive cleaners on the units or their blades.

• Ensure the appliance is switched o and unplug from the main outlet before cleaning.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the

shaver case, and tools have sharp edges and may cause injury if not handled correctly.

• The rechargeable battery must be removed from the appliance before it is scrapped.

• Disconnect the charging adapter before removing the battery.

1. Ensure that the battery is fully discharged. To do this, operate the device until it stops.

2. Pry o and remove the top housing.

3. Unscrew the 3 screws from the inner bracket.

4. Take out the battery bracket assembly.

5. Cut o the battery tabs and wires and remove the battery from bracket.

• The battery must be disposed of at an appropriate ocial recycling/collection point.

• Do not attempt to operate the trimmer once you have opened it.

ADAPTER SPECIFICATIONS

Manufacturer address and

registration number

Spectrum Brands (UK) Limited, Regent Mill, Fir Street,

Failsworth, Manchester M35 0HS

Company number: 02394603

Adapter model number PA-3215U

Input voltage 100 - 240 V~

Input AC Frequency 50/60Hz

Output voltage 3.2 V

Output current 1.5 A

Output power 4.8 W

Average active eciency ≥73.31%

Eciency at 10% -

No load power consumption ≤0.1W

RECYCLING

WTo avoid environmental and health problems due to hazardous

substances, appliances and rechargeable and non-rechargeable

batteries marked with one of these symbols must not be disposed of

with unsorted municipal waste. Always dispose of electrical and

electronic products and, where applicable, rechargeable and

non-rechargeable batteries, at an appropriate ocial recycling/

collection point.

SERVICE AND GUARANTEE

Defects aecting product functionality appearing within the guarantee

period will be corrected by replacement or repair at our option

provided the product is used and maintained in accordance with the

instructions. Your statutory rights are not aected.

To claim an extra 1 year guarantee, register your product online within

28 days of purchase.

This warranty shall not be valid where it is contrary to U.S. and other applicable laws, or

where the warranty would be prohibited under any economic sanctions, export control

laws, embargos, or other restrictive trade measures enforced by the United States or other

applicable jurisdictions. This includes, without limitation, any warranty claims implicating

parties from, or otherwise located in, Cuba, Iran, North Korea, Syria and the Crimea region.

Consumables are guaranteed only for their recommended lifecycle. Replacement/spare

parts* are excluded and are only covered by a 1 year warranty.

*Examples include, but are not limited to, adaptors, haircare attachments, grooming accessories, etc.

SERVICE CENTRE

UNITED KINGDOM

0800 212 438 (free call mainland UK)

Spectrum Brands (UK) Ltd

Fir Street, Failsworth, Manchester

M35 0HS, UK

www.remington.co.uk

Product support:

productsupport@remington.co.uk

IRELAND

142 951 40

Remington Consumer Products,

Unit B12, Ballymount Corporate Park,

Ballymount, Dublin 12

https://ie.remington-europe.com

Product support:

productsupport@remington.co.uk

Andere Handbücher für X3 POWER-X Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Remington Haarschneider Handbücher

Remington

Remington HC-5030 Bedienungsanleitung

Remington

Remington HC5356 Bedienungsanleitung

Remington

Remington HC-5350 Bedienungsanleitung

Remington

Remington Heritage HC9100 Bedienungsanleitung

Remington

Remington HC4110 Bedienungsanleitung

Remington

Remington HC9105 Bedienungsanleitung

Remington

Remington HKVAC2000 Bedienungsanleitung

Remington

Remington HC6525 Bedienungsanleitung

Remington

Remington ProPower HC7151 Bedienungsanleitung

Remington

Remington PRECISION PERFORMER HC2000AU Bedienungsanleitung

Remington

Remington HC5811 Bedienungsanleitung

Remington

Remington NE100C Bedienungsanleitung

Remington

Remington HC5350/5550/5750 Bedienungsanleitung

Remington

Remington Easy Fade Bedienungsanleitung

Remington

Remington Pro Power Alpha HC5156 Bedienungsanleitung

Remington

Remington X4 Power-X Series Bedienungsanleitung

Remington

Remington HC366AU Bedienungsanleitung

Remington

Remington HC-60 Bedienungsanleitung

Remington

Remington X4 Power-X Series Bedienungsanleitung

Remington

Remington HC5900 Bedienungsanleitung

Remington

Remington ProPower HC7130 Bedienungsanleitung

Remington

Remington Classic HC450 Bedienungsanleitung

Remington

Remington HC331 Bedienungsanleitung

Remington

Remington HC5780 Bedienungsanleitung

Beliebte Haarschneider Handbücher anderer Marken

Clatronic

Clatronic HSM 800 Bedienungsanleitung

Mellerware

Mellerware MACRO ALDANY MA20001 Bedienungsanleitung

VALERA

VALERA X-Master 652 Bedienungsanleitung

Wahl

Wahl 1870Li Bedienungsanleitung

Lister

Lister Legend Bedienungsanleitung

Philips

Philips HC5440/80 Bedienungsanleitung

Andis

Andis MBA 23125 Bedienungsanleitung

Philips

Philips Philishave HQC488/61 Bedienungsanleitung

Shear Magic

Shear Magic Nifty 1800 Bedienungsanleitung

Philips

Philips QC5390 Bedienungsanleitung

Andis

Andis US-1 Kurzanleitung

Panasonic

Panasonic EH-KA81 Bedienungsanleitung

Philips

Philips HC5450 Bedienungsanleitung

Andis

Andis US-1 Montageanleitung

Andis

Andis ML Montageanleitung

O'Barber

O'Barber MINI SLIDE Bedienungsanleitung

Oster

Oster 76110 Bedienungsanleitung

Hyundai

Hyundai HC 420 Bedienungsanleitung