Respironics Millennium M10 Bedienungsanleitung

Patient Manual

This oxygen concentrator should be used only under

the supervision of a licensed physician. Please read and

understand this entire manual before using the device.

Symbol Glossary

No Smoking REF Model number

Attention, consult

accompanying documents

SN Serial Number

Class II equipment ON (power)

Drip proof equipment OFF (power)

Type BF applied part

Classification

The Millennium M10 Oxygen Concentrator is classified as:

• IECClassIIEquipment

• TypeBFAppliedPart

• IPX1DripProof

• Notsuitableforuseinthepresenceofaflammableanestheticmixturewithair

or with oxygen or nitrous oxide.

• ContinuousOperation

Intended Use

The Millennium M10 Oxygen Concentrator is intended to provide supplemental

oxygen to persons requiring oxygen therapy. The device is not intended to be life

supporting or life sustaining.

Specifications

Input Voltage: 120 VAC +10%, -10%

Input Frequency: 60 Hz

AveragePowerConsumption: 600W

Oxygen Concentration*: 92±4%@8-10LPM

 94±2%@3-7LPM

92 +4%@1-2LPM

Weight: 24±0.2kg

Storage/transport temperature: -34 to 71°C

Operating temperature: 13 to 32°C

Storage/transport humidity: up to 95%, noncondensing

Operating humidity: up to 95%, noncondensing

Operatingpressure: 69-207kPa

Altitude: 417 m

*DeviceoperationaboveoroutsideoftheVoltage,LPM,Temperature,Humidity

and/or Altitude values specified may decrease oxygen concentration levels.

Electromagnetic Compatibility

The Millennium M10 is designed to meet the current electromagnetic compatibility

requirements. However, if you suspect operation of this device interferes with the

normal operation of your TV, radio or other electronic appliances, try:

1. Relocating the appliance or the device until the interference stops or

2. Pluggingthedeviceintoadifferentpoweroutletcontrolledbyaseparate

circuit breaker or fuse.

Important Safety Requirements

Warnings: A warning represents the possibility of harm to the operator or

patient

1. For proper operation, your oxygen concentrator requires unobstructed

ventilation. The ventilation ports are located at the rear base of the device and

at the side air inlet filter. Always make sure that these areas are not obstructed

by items which may impede ventilation (like blankets, foam, curtains, etc.). Do

not place the concentrator in a small closed space (such as a closet).

2. Do not remove the covers of the oxygen concentrator. Servicing must be

performedbyanauthorizedandtrainedPhilipsRespironicshomecare

provider.

3. In the event of an equipment alarm or if you are experiencing any signs

of discomfort, consult your home care provider and/or your health care

professional immediately.

4. Oxygen generated by this concentrator is supplemental and should not be

considered life supporting or life sustaining. In certain circumstances oxygen

therapy can be hazardous; any user should seek medical advice prior to using

this device.

5. Wheretheprescribinghealthcareprofessionalhasdeterminedthatan

interruption in the supply of oxygen, for any reason, may have serious

consequences to the user, an alternate source of oxygen should be available

for immediate use.

6. Oxygen vigorously accelerates combustion and should be kept away from

heat or open flame. The oxygen concentrator is not suitable for use in the

presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

7. Do not smoke, allow others to smoke or have open flames near the

concentrator when it is in use.

8. Do not use oil or grease on the oxygen concentrator or its components as

these substances, when combined with oxygen, can greatly increase the

potential for a fire hazard and personal injury.

9. Do not use the oxygen concentrator if either the plug or power cord is

damaged. Do not use extension cords or electrical adapters.

10. Do not attempt to clean the oxygen concentrator while it is plugged into an

electrical outlet.

11. OperationoftheoxygenconcentratoraboveoroutsideoftheVoltage,LPM,

Temperature, Humidity and/or Altitude values specified may decrease oxygen

concentration levels.

12. Your home care provider is responsible for performing appropriate preventive

maintenance at the intervals recommended by the device manufacturer.

Cautions: A caution represents the possibility of damage to the equipment.

1. Do not operate the oxygen concentrator without all the filters in place. The

filters must be totally dry before operating the device.

2. Do not place liquids on or near the oxygen concentrator.

3. If liquid is spilled on the oxygen concentrator, turn the power off and unplug

from the electrical outlet before attempting to clean up the spill. Call your

home care provider if the device does not continue to work properly.

Introduction

Your health care professional has determined that supplemental oxygen is of benefit

to you and has prescribed an oxygen concentrator set at a specific flow setting

to meet your needs. DO NOT change the flow settings unless your health care

professional tells you to do so. The Millennium M10 oxygen concentrator is intended

to provide supplemental oxygen to persons requiring oxygen therapy. This device

is not intended to be life supporting or life sustaining. The Millennium produces

concentrated oxygen from room air for delivery to a patient requiring low flow

oxygen therapy. The oxygen from the air is concentrated using a molecular sieve and

a pressure swing absorption process. Your home care provider will show you how to

operate the concentrator and will be available to answer any questions. You should

contact him or her in the future if you have any questions or problems.

Millennium M10 models that are compatible with the UltraFill Oxygen Filling Station

will include an additional connection port for connection to the UltraFill Oxygen

Filling Station. The performance of the Millennium M10 is not affected when the

port is connected to the UltraFill Oxygen Filling Station. The port is for connection

to the UltraFill Oxygen Filling Station only and not for connecting the patient

oxygen cannula. The patient oxygen cannula is connected to the Millennium M10

as described in the Operating Instructionssectioninthismanual.Pleaseseethe

UltraFill manual for connection and operating instructions regarding the UltraFill

Oxygen Filling Station.

Parts of Your Concentrator

Flow Meter

UltraFillPort

Air Filter

On/Off

Switch

Operating

Condition

Indicators

Oxygen

OutletPort

Filter Cap

Operating Instructions

1. Select a location that allows the oxygen concentrator to draw in room air

without being restricted. Make sure that the oxygen concentrator is at least

8 cm away from walls, furniture, and especially curtains that could impede

adequate airflow to the device. Do not place the oxygen concentrator near any

heat source.

2. After reading this entire manual, plug the power cord into an electrical outlet.

WARNING:

DONOTUSEEXTENSION

CORDS OR ELECTRICAL

ADAPTERS.

3. Connect the oxygen tubing (cannula) to the oxygen outlet port.

4. PressthepowerswitchtotheOn[I]position.Initially,alltheindicatorlights

will turn on and the audible alarm will sound for a few seconds. After that time,

only the green indicator light should remain lit.

5. After turning on the oxygen concentrator, allow at least 10 minutes for it to

warm up.

6. Adjust the flow to the prescribed setting by turning the knob on the top of the

flow meter until the ball is centered on the line marking the specific flow rate.

7. Be sure oxygen is flowing through the cannula. If it is not, refer to the

Troubleshooting section.

8. Putthecannulaonasdirectedbyyourhomecareprovider.

9. Whennotusingthedevice,pressthepowerswitchtotheOff[O]position.

Accessory Equipment

UseonlythefollowingPhilipsRespironicsaccessorieswiththeMillenniumM10:

 -PartNumber1014653 CannulaandTubing

Contact your home care provider if you have questions concerning the use of these

accessories.

Maintenance

Warning: It is important to unplug the device before any maintenance or

cleaning is performed.

Cleaning and Changing the Air Inlet Filter

Cleaning the air inlet filter is the most important maintenance activity that you will

perform and should be done at least once a week.

1. Remove the filter cap.

2. Remove the filter from the cabinet.

3. Visually inspect the filter for damage, such as holes or tears.

4. If damaged, replace with a new filter. Contact your health care provider for a

new filter if necessary.

5. Rinse and wash the filter in warm water. A mild detergent may be used if

rinsed thoroughly.

6. Squeeze out the excess water and allow the filter to air dry. The filter should

be completely dry before using again. Excess moisture may impair the proper

operation of the device.

7. Visually inspect the filter after cleaning. Make sure it is not damaged or

clogged.

8. Reinsert the filter on the cabinet.

9. Reinstall the filter cap.

Cleaning the Device

You should also clean the exterior case of the oxygen concentrator. You may use a

damp cloth to wipe down the exterior case. If medical disinfectants are used, be sure

to follow the manufacturer’s instructions.

Andere Handbücher für Millennium M10

Inhaltsverzeichnis

Sprachen:

Andere Respironics Medizinische Geräte Handbücher

Respironics

Respironics Bipap Harmony S/T Bedienungsanleitung

Respironics

Respironics Tranquility Bilevel 1700 Bedienungsanleitung

Respironics

Respironics REMstar Pro Bedienungsanleitung

Respironics

Respironics EverFlo Bedienungsanleitung

Respironics

Respironics M SeRieS Bedienungsanleitung

Respironics

Respironics DreamStation Wi-Fi Accessory Betriebsanleitung

Respironics

Respironics REMstar Pro Bedienungsanleitung

Respironics

Respironics DreamStation Go Bedienungsanleitung

Respironics

Respironics SmartMonitor 2 Bedienungsanleitung

Respironics

Respironics bilichek Bedienungsanleitung

Respironics

Respironics OptiLife Bedienungsanleitung

Respironics

Respironics Millennium M10 Bedienungsanleitung

Respironics

Respironics BiPAP S Bedienungsanleitung

Respironics

Respironics ASSESS Bedienungsanleitung

Respironics

Respironics Millennium H600 Gebrauchs- und Pflegehandbuch

Respironics

Respironics V60 Bedienungsanleitung

Respironics

Respironics BiPAP Focus Bedienungsanleitung

Respironics

Respironics MiniElite Bedienungsanleitung

Respironics

Respironics 920 Fehlerbehebungshandbuch

Respironics

Respironics DreamStation Series Bedienungsanleitung

Respironics

Respironics Wee Sight 1017920 Bedienungsanleitung

Respironics

Respironics System One Heated Humidifier Bedienungsanleitung

Respironics

Respironics 950 Fehlerbehebungshandbuch

Respironics

Respironics BiPAP S/T Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung