RF SOLUTIONS LoRaLyser Bedienungsanleitung
LORALYSER
Walk / Ping Test Screen To Perform “WALK / PING Test”
1. Place Receiver into “LEARN Mode”
2. Press Start button on app
Analyser will now send “ping” commands,
the response back from receiver will be
displayed
Transmitter ID
Received Signal Strength
From Transmitter
Time from “ping” sent to response
received
Note!: Ping requires an RF Solutions
compatible receiver with “acknowledge”
feature
Phone Compatibility—WARNING!
Before using this product please ensure that your android phone is compatible with external Serial Devic-
es, and can be connected to OTG accessories
The Loralyser uses a standard serial port device which requires the Android phone to be compatible with.
The USB OTG feature is available on almost every Android smartphone, however, some phones lack this
feature. For unlocking the OTG capabilities, you may need to root and install a custom ROM on your
Android device to get compatibility.
LoRaLyser
QS-LORALYSER-1
Sales: +44 (0) 1444 227910 Tech. Support: +44 (0) 1444 227909
RF Packet Analyser for Android
• Plug in USB Dongle
• 868 / 915MHz FM/LORA operation
• RF Signal Data Analysis
• RF Signal / Packets
• Waveform Level
• Decoded Data
• RF Signal Strength (dBm)
• User Selectable Trigger Level
• Walk \ Ping Test
•
u
USB Type B or C Connector
Description
Plug ’n’ play RF Packet Analyser Dongle plugs into a Smartphone providing various graphical dis-
play and information of the RF signals.
In addition LoRaLyser will also show decoded data from RF Solutions Transmitted signals, ie an
RF Solutions Keyfob Serial No, Buttons pressed or released
Compatibility WARNING!
We have successfully tested this product with Samsung, Huawei, LG, so far, Please note that
Sony Smartphones do not have a serial port and are therefore require the user to install a seri-
al driver. we welcome feedback from other makes of Android.
LORALYSER
QS-LORALYSER-1
What’s in the Box?
Getting Started
1. Download “RF Packet Analyser”
2. Plug in the USB Dongle
3. Run LoRaLyser app (if it does not autostart)
4. Press “Connect to Dongle”
1. RF Dongle USB
2.
u
USB Type B Cable
3.
u
USB Type C Cable
4. Antenna (ANT-GHEL2-SMA)
Selected Freq &
Modulation
4 x Quick select
Frequency select
Buttons
To change: Press and
Hold Button
Last Received Packet
Content
Connect/ Disconnect
to Dongle
Trigger Lever for
Scope display, To
change: Press and
hold for 3 secs then
slide
Signal Strength
with Peak Hold
RF Meter Screen
LORALYSER
QS-LORALYSER-1
Scope Screen
RF Signal Trigger Level of Scope trace is set by Slider on
RF Meter Screen
Packet Analyser Page
Swipe L or R to next
page
Serial Number
Decoded TX Command
RSSI Value
Battery Voltage Level
From Transmitter
Packet Analyser Screen
M1, M2: Memory Store
Screen Image
Slide to adjust X
Axis/ Time
Screen can be zoomed or swiped to view more data
Andere RF SOLUTIONS Messgerät Handbücher
