Rivtec W-6A Bedienungsanleitung
OPERATING MANUAL
W-6A
RIVTEC® PNEUMATIC RIVET NUT TOOL
(Please read this manual before using this tool)
The W-6A is a professional and highly efficient pneumatic rivet nut tool.
The W6A is capable of setting different size rivet nuts by changing the
mandrel to correspond with the rivet nut. Control the clamping force by
adjusting the stroke accordingly.
Under normal conditions of use, the daily capacity of the W6A is about 6000
rivet nuts.
SPECIFICATIONS:
Model W6A
Weight 1.8KG
Stroke Up to 5mm
Working pressure: 5~7KG
Capacity M4,M5,M6, (M8 Aluminium)
PACKING CHECK LIST:
!1 x Carry case
!1 x W6A
!1 x M3, M4, M6 Mandrel and nose piece
!3 x M3, M4, M6 spare mandrels
!1 x Air inlet lubricating oil
PREPARATION:
1. Adjusting the extended length of the mandrel from the nosepiece. Ensure
that the collar of the nut is facing towards the nosepiece and the mandrel is
protruding 1 or 2 threads through the rivet nut.
2. Before every shift starts, inject 2 or 3 drops of motor lubricant oil into the
air fitting on the tool. Only use air tool lubricant.
3. This tool is designed to operate on clean, dry, regulated compressed air,
between 75-100psi. It is preferable to include an air filter, pressure regulator,
and automatic oiler within 15 feet of the tool.
!
ADJUSTING THE STROKE
When a smaller size rivet nut is used
such as M3 or M4, the stroke must be
adjusted to prevent damaging the
mandrel and inside thread of rivet nut.
1.
Unscrew the mandrel holder locknut.
2. Turn the locknut anti-clockwise and
turn the outer sleeve clockwise to
shorten the stroke. Then tighten the
locknut.
(Correct adjustment will ensure there is
1 thread of the mandrel exposed when
the rivet nut is engaged.)
SETTING A RIVET NUT
1. Present the rivet nut to the mandrel and start the thread
2. Press on the mandrel and rivet nut will automatically thread on
3. Insert the rivet nut into the prepared hole in the work piece
4. Actuate the trigger, the rivet nut will be set into the work piece.
5. Press the button on the side with your thumb and the mandrel will be
reversed from the work piece.
EXCHANGING A MANDREL
Unlock the locknut and nosepiece and remove.
Push the cover backwards to release the
mandrel. Release the mandrel by turning it
counter-clockwise.
Push the cover backwards and install the
replacement mandrel turning clockwise until it
stops. Release the cover in install the matching
nose piece.
!
Andere Rivtec Werkzeuge Handbücher
