Rocktron CLASSIC WAH PEDAL Bedienungsanleitung

Your Classic Wah

pedal has been tested and complies with the following

Standards and Directives as set forth by the European Union:

Council Directive(s):

89/336/EEC Electromagnetic Compatibility

Standard(s):

EN55013, EN50082-1

This means that this product has been designed to meet stringent guide-

lines on how much RF energy it can emit, and that it should be immune

from other sources of interference when properly used. Improper use of this

equipment could result in increased RF emissions, which may or may not

interfere with other electronic products.

To insure against this possibility, always use good shielded cables for all

audio input and output connections. This will help insure compliance with

the Directive(s).

For more information about other Rocktron products, please see your local

dealer or one of our importers closest to you (listed on the Rocktron website

- www.rocktron.com).

Precautions

Read all instructions contained in this manual.

Keep these instructions

Heed all warnings

Follow all instructions.

Do not use this apparatus near water.

Clean with dry cloth

Do not block any ventilation openings (if applicable). Install in accordance

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers,

stoves or other apparatus (including ampliﬁ ers) that produce heat.

This product is not equipped with a plug or cable. This pedal runs on a

9 Volt Battery, if a 9-Volt DC adapter is the used please follow adapter

manufacturer’s operation instructions.

Only used attachments/acces

sories speciﬁ ed by the manufacturer.

Do not use this product with any case, stand tripod, bracket or table that

is not speciﬁ ed by the manufacturer. Insure that the case, stand, tripod,

bracket etc. is properly adjusted and setup (follow all instructions). Extra

care and caution should be taken to avoid tip over and injury.

Unplug this apparatus during lightening storms or when unused during long

periods of time.

Refer all service to qualiﬁ ed service personnel. Servicing is required when

the apparatus has been damaged in any way, such as power supply or plug

is damaged, liquid has been spilled or objects have fallen into the apparatus

or if the apparatus has been exposed to rain or moisture, does not operate

normally or has been dropped.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. QUALIFIED PER-

SONNEL SHOULD SERVICE THIS EQUIPMENT ONLY. DO NOT MAKE

ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT

AT ANY TIME OR TAMPER WITH INTERNAL ELECTRONIC COMPO-

NENTS AT ANY TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS

MAY VOID THE WARRANTY OF THIS EQUIPMENT AS WELL AS CAUS-

ING A SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat. This unit is designed to oper-

ate between 32° F and 104° F (

and 40° C). This unit may not function

properly under extreme temperatures.

Precautions Continued....

Introduction

Congratulations on your purchase of the Rocktron

Classic Wah.

The Rocktron Classic Wah is a vintage style wah

with classic tone. Solid construction makes the

Classic Wah stage ready.

The easy access battery compartment will make

changing batteries during a gig a breeze. And, we

have incorporated an adjustable rocker tension

screw that will allow you to adjust the pedal action

for a lighter or heavier “touch”.

Connection

Connection when using with other

stomp boxes or effects:

Controls and Descriptions:

ROCK

ER FOOTPEDAL

- Place your foot on the rocker foot-

pedal and rock it up and down (toe to heel - heel to toe) to work

the “ wah” effect.

Wah ON/OFF Switch

- is located under the toe of the rocker

footpedal. To activate the “wah” press down slightly harder on

the toe of the rocker pedal until the switch is activated. The

same process is to be applied to turn off the wah effect. The

wah effect will be on when the red LED is lit (see point 7).

INPUT Jack

- using a standard guitar cable - plug your guitar

INPUT Jack - using a standard guitar cable - plug your guitar INPUT Jack

into this jack.

PEDAL ROCKER TENSION ADJUSTMENT

- This screw will

allow you to adjust the “action” of the pedal to suit your taste

with the included allen wrench. If you would like a tighter or

heavier movement of the pedal using an allen wrench turn the

screw clockwise. This will increase the torque and tension on

the rocker pedal. If you would like a smoother or softer pedal

movement turn the allen screw counter-clockwise. This will

loosen the tension on the pedal pivot point.

9-VOLT ADAPTER INPUT

- This receptacle requires a 9V DC

adapter (not included) with a 2.1mm coax plug to provide pow-

er to the unit. Please consider using the Rocktron DC OnTap

adapter (sold separately) available from your Rocktron dealer.

Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V DC

ﬁ ltered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm Coax

jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear on the

bottom of the Classic Wah.

Controls and Function Descriptions

Speciﬁ cations

Maximum Input

Input Impedance

Output Impedance

Wah frequency Range

Current Consumption

Power Requirements

+10dBu

1M ohm

1K ohm

400Hz (Heel Down) to 2KHz (Toe

Down)

20ma or greater

9VDC >=100ma

Controls and Function Descriptions - Cont.

OUTPUT Jack

- using a standard guitar cable, plug this out-

OUTPUT Jack - using a standard guitar cable, plug this out-OUTPUT Jack

put into the next effect in your effect chain or directly into the

input of your guitar ampliﬁ er.

WAH ON LED

- The red LED will be lit when the “wah” effect

is activated. To activate the wah - see point 2. The red LED

will not be lit when the wah is bypassed.

9-VOLT BATTERY COMPARTMENT

- to access pull on

small tab labeled “OPEN”. Replace with a new 9-Volt battery.

Always remember to unplug your guitar cords from the pedal

to conserve battery life. Some battery drain may take place

when unit is plugged in (even if the unit is bypassed).

The Classic Wah (as with all Wah Wah pedals) are normally put in

the beginning of your signal chain. Although, you may place your

wah at any place in your signal chain, it usually sounds best at the

beginning - directly from your guitar (or bass).

Hints and Tips

Inhaltsverzeichnis

Andere Rocktron Musikpedal Handbücher

Rocktron

Rocktron XCHANGE Bedienungsanleitung

Rocktron

Rocktron RAMPAGE Bedienungsanleitung

Rocktron

Rocktron DEEP BLUE Bedienungsanleitung

Rocktron

Rocktron MULTVALVE Bedienungsanleitung

Rocktron

Rocktron TRUE BYPASS Tru-Loop Bedienungsanleitung

Rocktron

Rocktron O.D.B. Bedienungsanleitung

Rocktron

Rocktron Reaction Octaver Bedienungsanleitung

Rocktron

Rocktron Celestial Delay Bedienungsanleitung

Rocktron

Rocktron ZOMBIE Bedienungsanleitung

Rocktron

Rocktron Reaction Tremolo Bedienungsanleitung

Rocktron

Rocktron Sweet Spot Bedienungsanleitung

Rocktron

Rocktron Mega Booster Bedienungsanleitung

Rocktron

Rocktron HUSH Bedienungsanleitung

Rocktron

Rocktron HUSH 2X Bedienungsanleitung

Rocktron

Rocktron VII Deadly Sins Bedienungsanleitung

Rocktron

Rocktron Reaction Distortion 1 Bedienungsanleitung

Rocktron

Rocktron Reaction Compressor Bedienungsanleitung

Rocktron

Rocktron Cyborg Bedienungsanleitung

Rocktron

Rocktron UTOPIA G100 Bedienungsanleitung

Rocktron

Rocktron Reaction Phaser Bedienungsanleitung

Rocktron

Rocktron SONIC GLORY Bedienungsanleitung

Rocktron

Rocktron Third Angel Distortion Bedienungsanleitung

Rocktron

Rocktron Reaction Digital Delay Bedienungsanleitung

Rocktron

Rocktron BLACK MOAN CAT Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung