Ruijie RG-IF2920U-12GT1XS-DC Series Installations- und Betriebsanleitung

RG-IF2920U-12GT1XS-DC

Series Switch

Hardware Installation and Reference Guide

Document version: V1.2

Date: 2023-05-24

All rights are reserved in this document and this statement.

Any reproduction, excerption, backup, modification, transmission, translation or commercial use of this

document or any portion of this document, in any form or by any means, without the prior written consent of

Ruijie Networks is prohibited.

Trademark and are owned by Ruijie Networks.

All other trademarks or registered trademarks mentioned in this document are owned by their respective

owners.

Disclaimer

The products, services, or features you purchase are subject to commercial contracts and terms, and some or

all of the products, services, or features described in this document may not be available for you to purchase or

use. Except for the agreement in the contract, Ruijie Networks makes no explicit or implicit statements or

warranties with respect to the content of this document.

Due to product version upgrades or other reasons, the content of this document will be updated from time to

time. Ruijie Networks reserves the right to modify the content of the document without any notice or prompt.

This manual is for reference only. Ruijie Networks endeavors to ensure content accuracy and will not shoulder

any responsibility for losses and damages caused due to content omissions, inaccuracies or errors.

Preface

Intended Audience

This document is intended for:

Network engineers

Technical support and servicing engineers

Network administrators

Technical Support

Ruijie Networks website: https://www.ruijienetworks.com/

Technical support website: https://ruijienetworks.com/support

Case portal: https://caseportal.ruijienetworks.com

Community: https://community.ruijienetworks.com

Technical support email: [email protected]

Live chat: https://www.ruijienetworks.com/rita

Conventions

1. Signs

The signs used in this document are described as follows:

Warning

An alert that calls attention to important rules and information that if not understood or followed can result in

data loss or equipment damage.

Caution

An alert that calls attention to essential information that if not understood or followed can result in function

failure or performance degradation.

Note

An alert that contains additional or supplementary information that if not understood or followed will not lead to

serious consequences.

Specification

An alert that contains a description of product or version support.

2. Note

The manual offers configuration information (including model, port type and command line interface) for indicative

purpose only. In case of any discrepancy or inconsistency between the manual and the actual version, the actual

version prevails.

Hardware Installation and Reference Guide Product Description

1 Product Description

The RG-IF2920U-12GT1XS-DC is the simplified optical Ethernet (SOE) switch released by Ruijie Networks for

all-optical network scenarios. It uses the new hardware architecture, and silent and energy-saving design. It

can be flexibly installed and suitable for indoor scenarios. With Ruijie's modular OS, the

RG-IF2920U-12GT1XS-DC is fit for the SOE solution, and implements lifecycle management, security control,

plug and play, and intelligent O&M through software-defined networking (SDN).

Table 1-1 Ports of the RG-IF2920U-12GT1XS-DC

Model

10/100/1000M

Base-T Ethernet

Electrical Port

2.5G/1G

BASE-T

Ethernet

Electrical

Port

SFP

Port

2.5G SFP

Port

SFP+

Port

Console

Port

RG-IF2920U-12G

T1XS-DC

N/A

Note

SFP+ ports are downward compatible with 1000Base-X ports.

1000Base-T ports are downward compatible with 100Base-T and 10Base-T ports.

1.2 RG-IF2920U-12GT1XS-DC

1.2.1 Technical Specifications

Table 1-2 Technical Specifications of the RG-IF2920U-12GT1XS-DC

Model

RG-IF2920U-12GT1XS-DC

Supported Optical

Module

See Appendix B.

The supported optical module types may update without prior notification. Please

contact Ruijie Networks for any updates.

SFP+ Port

10GBase-X and 1000Base-X

Hardware Installation and Reference Guide Product Description

Power Supply

PoE power supply (DC):

Rated voltage range: 44 V to 57 V

Rated current: 0.4 A

Adapter power supply:

Power adapter input

○Rated voltage range: 100 V to 240 V

○Maximum voltage range: 90 V to 264 V

○Rated frequency: 50/60 Hz

Power adapter output (DC)

○Rated voltage: 12 V

○Rated current: 1.0 A

The power adapter used must comply with usage standards or has passed CCC

certification.

Energy Efficient

Ethernet (EEE)

Supported

Maximum Power

Consumption

10 W

Operating

Temperature

0ºC to 45ºC (32°F to 113°F) at the altitude between 0 m to 1,800 m (0 ft. to

5905.51 ft.)

At the altitude between 1,800 m (5905.51 ft.) and 5,000 m (16404.2 ft.), every time

the altitude increases by 220 m (721.79 ft.), the maximum temperature decreases

by 1°C (1.8°F).

Storage Temperature

–40°C to +70°C (–40°F to +158°F)

Operating Humidity

10% to 90% RH (non-condensing)

Storage Humidity

5% to 95% RH (non-condensing)

Fan Module

Natural heat dissipation for fanless design

Intelligent

Temperature Control

Temperature alarm and overheat protection

EMC Standard

GB/T 9254.1

Safety Standard

GB 4943.1

Dimensions (W x D x

270 mm x 135 mm x 44.5 mm (10.63 in. x 5.31 in. x 1.76 in.)

Weight

1.2 kg (2.65 lbs) (including the package)

Warning

The RG-IF2920U-12GT1XS-DC is a Class A product. In a domestic environment, this product may cause radio

interference in which case the user may be required to take adequate measures.

Hardware Installation and Reference Guide Product Description

1.2.2 Product Appearance

The RG-IF2920U-12GT1XS-DC provides 12 x 10/100/1000M Base-T Ethernet electrical ports and 1 x 10G

SFP+ port.

Figure 1-2 Appearance of the RG-IF2920U-12GT1XS-DC

1. Front Panel

Figure 1-3 Front Panel of the RG-IF2920U-12GT1XS-DC

Hardware Installation and Reference Guide Product Description

2. Middle Frame Panel

Figure 1-4 Middle Frame Panel of the RG-IF2920U-12GT1XS-DC

Table 1-3 Middle Frame Panel

No.

Description

Optical port LED

Switch status LED

PoE power port 48 V/0.4 A

DC power port 12 V/1 A

Reset button

Console port (for commissioning)

10/100/1000Base-T Ethernet port with auto-negotiation

Ethernet port LED

Lock option

Hardware Installation and Reference Guide Product Description

3. Top Cover

Table 1-4 Top Cover

No.

Description

Nameplate

SFP+ port

Tamper-proof label

4. Reset Button

The RG-IF2920U-12GT1XS-DC provides one Reset button. When you press this button for more than 5s, the

device restores to factory defaults and restarts.

5. LEDs

Table 1-5 LEDs

LED

Panel

Identification

Status

Description

Status LED

Status

Off

The switch is not powered on.

Blinking green

The switch is being initialized. If the

LED blinks continuously, a fault occurs.

Solid green

The switch works properly.

Hardware Installation and Reference Guide Product Description

Solid yellow

A switch temperature alarm is

generated. Check the operating

environment of the switch.

Solid red

The switch fails.

Electrical port

LED

1–12

Off

The port is not connected.

Solid green

The port works at the rate of

10/100/1000 Mbps.

Blinking green

The port is sending or receiving data at

the rate of 10/100/1000 Mbps.

Optical port

LED

SFP+

Off

The port is not connected.

Solid green

The port is connected.

Blinking green

The port is sending or receiving data.

Solid red

An error occurs when the optical

module sends signals.

Solid yellow

An error occurs when the optical

module receives signals.

6. Heat Dissipation

The RG-IF2920U-12GT1XS-DC adopts natural heat dissipation to ensure that it works properly in a specified

environment. For the RG-IF2920U-12GT1XS-DC, maintain sufficient clearance on both sides of the chassis

and above the chassis for air circulation. Dust the device every three months to avoid blocking ventilation

openings on the housing.

Hardware Installation and Reference Guide Preparing for Installation

2 Preparing for Installation

2.1 Safety Precautions

Warning

To avoid personal injury and device damage, carefully read the safety precautions before you install the

RG-IF2920U-12GT1XS-DC.

The following safety precautions may not cover all possible dangers.

2.1.1 Mounting

Keep the chassis clean and dust-free.

Do not place the device in a walking area.

During installation and maintenance, do not wear loose clothes, ornaments, or any other things that may be

hooked by the chassis.

Cut off all the power supplies and unplug all power cords before handling the switch.

2.1.2 Handling

Avoid handling the device frequently.

Keep balance and prevent personal injuries when handling the device.

Cut off all the power supplies and unplug all power cords before moving or handling the switch. Avoid scalds

because the housing surface is hot.

2.1.3 Electricity

Observe local regulations and specifications during electric operations. Only qualified personnel can perform

such operations.

Before installing the device, check whether there are hidden risks in the operating environment of the device.

For example, check whether the power socket is grounded and whether the ground is wet.

Determine the location of the indoor emergency power supply switch before installing the device. When an

accident occurs, immediately cut off all power supplies.

Do not maintain the device by yourself when the device is powered on.

Make sure that the device is powered off when you cut off the power supply.

Warning

Improper or incorrect electric operations may cause a fire, electric shock, and other accidents, and lead to

severe and fatal personal injury and device damage.

Direct or indirect contact through wet objects with high voltage or mains power supply may be fatal.

To guarantee personal safety, the rated leakage action current of each leakage protector in the system

must be less than or equal to 30 mA (human body safety current is 30 mA). When twice of the total

leakage current of the system is greater than 30 mA, the system must be equipped with two or more

leakage protectors.

Inhaltsverzeichnis

Andere Ruijie Schalten Handbücher

Ruijie

Ruijie RG-SF2920 Series Installations- und Betriebsanleitung

Ruijie

Ruijie Reyee RG-NBS7006 Installations- und Betriebsanleitung

Ruijie

Ruijie Reyee RG-NIS Series Bedienungsanleitung

Ruijie

Ruijie RG-NIS3100 Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-NBS Series Bedienungsanleitung

Ruijie

Ruijie RG-S2928G-E Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S5000-24GT4MS-E Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S1808 Installations- und Betriebsanleitung

Ruijie

Ruijie Reyee RG-ES206GS-P Series Installations- und Betriebsanleitung

Ruijie

Ruijie RGOS 11.X Bedienungsanleitung

Ruijie

Ruijie RG-S6580-24DC8QC Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6980-64QC Installations- und Betriebsanleitung

Ruijie

Ruijie RG-CS88-08 Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6250-48XS8CQ Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-NBS3200 Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-ES126S-P Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6920-4C Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6920-4C Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-ES200 Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6930-2C Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6220-48XS6QXS-H Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S5760C-X Series Installations- und Betriebsanleitung

Ruijie

Ruijie RG-S6000C-48GT4XS-E-AC DCN Installations- und Betriebsanleitung

Ruijie

Ruijie RG-MF2920U Series Installations- und Betriebsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch

Vimar

Vimar 6592 Montageanleitung