S4A ED100 Bedienungsanleitung
ED100
Intelligent Automatic Flat Door system
Catalog
1. Technical parameter
2. Description of accessories
3. Mechanical installation
3.1 Installation example
3.2 Baseboard installation
3.3 Arm installation
3.4 Push arm installation
3.5 Driver system installation
3.6 Hood installation
3.7 Connection of drive system and pull arm
3.8 Driver system and push arm connection
4. Electrical connection
5. Parameter adjustment
6. Quality Assurance Certificate / Qualification Certificate
1
2
3 - 9
3
4 - 5
6
7 - 8
9
9
10
10
11 - 12
13 - 14
15
Technical parameter
Power supply: 200V~240V
Opening time: 3~7s/90°
Opening and holding time: 1~30s
Temperature: -20°C~55°C
Protection level: IP12D
Product weight: 6.5Kg
Product volume: 515x95x90mm
mm = Door width
kg = Door weight
Optimum scope
Limit range
1200
1000
2000
mm
80 100 140 200
kg
Description of accessories
Power cord hole Sensor equilibrium hole
Floor Hood
Power Connection Seat Motor Microcomputer Controller
Driving Device Output shaft Transformer
Pull arm (and push arm choose one) Push arm (choose one from pull arm)
Mechanical installation
3.1 Installation example
Pull- arm mounting: Suitable for door wing opening inward (drive system inside)
Push Arm Installation: Suitable for door wing opening outward (drive system inside)
Mechanical installation
3.2 Baseboard installation
Pull-arm mounting
Power Supply Line Equivalent Entry
φ20Sensor Line Equivalent Entry
φ20Sensor Line Equivalent Entry
Power Supply Line Equivalent Entry
The floor is fastened to the door
frame with eight countersunk wood
screws according to the size shown
(for steel structure, M6*15 inner
hexagonal countersunk head bolts) The floor is fastened to the door
frame with eight countersunk wood
screws according to the size shown
(for steel structure, M6*15 inner
hexagonal countersunk head bolts)
Installation on the right side of automatic door
Left Installation of Automatic Door
Mechanical installation
3.2 Baseboard installation
Push Arm Installation
Power Supply Line Equivalent Entry
φ20Sensor Line Equivalent Entry
φ20Sensor Line Equivalent Entry
Power Supply Line Equivalent Entry
The floor is fastened to the door
frame with eight countersunk wood
screws according to the size shown
(for steel structure, M6*15 inner
hexagonal countersunk head bolts)
The floor is fastened to the door
frame with eight countersunk wood
screws according to the size shown
(for steel structure, M6*15 inner
hexagonal countersunk head bolts)
Installation on the right side of automatic door
Left Installation of Automatic Door
3.3 Pull-arm mounting
The fixed seat of the pull
arm is fastened to the door
wing as shown.
Move the limit block to
adjust the opening angle
(the left time limit block is
on the left side)
Installation on the right side of automatic door
Mechanical installation
3.4 Push Arm Installation
The push arm fixing seat is fastened
to the door wing with two round head
wood screws according to the size shown
(for steel doors, M6*15 cross head screw is used).
According to the different depth L of the door
frame, the length of the push arm can be
adjusted by loosening three clamping bolts,
so that the angle between the push arm and
the door body is 90 degrees as shown in the figure.
Installation on the right
side of automatic door
Mechanical installation
Mechanical installation
3.4 Push Arm Installation
Limited block
Adjust limit block to graphic position in U-shaped hole
Inhaltsverzeichnis
Andere S4A Türöffnungssystem Handbücher
