Samsung Bixolon SRP-500 Bedienungsanleitung

POS Ink-jet printer SRP-500

◈Check that all Items are Present

The following items are packed in the box. If any items appear to have

shipping damage or are missing, please contact your dealer.

POS Inkjet Printer SRP-500•

•

Ink Cartridges

Paper Roll

AC Adapter & Power Cord

Operator’s Manual & Quick Reference Sheet

Cable Cover

◈Startup Information

•

Connecting the Cables

1. Connect Interface Cable

Depending on the Interface your system uses, connect the

serial, parallel or USB communication cable to the

connector on the back of the printer.

2. Connect the AC adapter cable to the power connector of

the printer.

Installing New Ink Cartridges

1. Turn the printer on.

2. Remove new ink cartridge from pouch and peel off mylar. Do not touch

cartridge’s metallic connector area with your fingers. Touching this surface

contaminates the connector.

3. Open front cover of printer and pull down cartridge latch(es).

4. Take out old ink cartridge(s).

Place new cartridge(s) into carriage. Hold round tab to ensure clean

installation.

Black cartridges go into left carriage.

Color cartridges go into right carriage.

(Tab faces front of printer.)

5. Close latch(es) and front cover.

Notice

The ink drop counter is automatically reset when the ink-cartridge is

installed.

Loading New Paper Roll (refer to label on inside of cabinetry)

1. Turn the printer on and open the rear cover by pressing open button.

2. Insert new paper roll.

Be sure to note the correct direction of the paper roll.

3. Pull out a small amount of paper, then close the cover and tear off the extra

paper by pulling it toward the front of the printer.

◈Keypad Controls and Indicator Lights

Most of the functions of this printer are governed by software, but

you can monitor the printer’s status by looking at the lights on the

control panel and for some procedures you will use the buttons.

•

Keypad Controls

Clean Button

The Clean button is used to clean the printer head.

(Refer to operator’s manual)

Feed Button

The feed button is used to feed paper or to start self test and for

hexadecimal dump mode.

(Refer of operator’s manual)

Keypad Indicator Lights

Power Indicator

Light

This indicator light is on when the power is turned on. It blinks when the printer is in the

self-test printing standby state. Always wait until this indicator light stops blinking before

you start using the printer and before you turn it off.

Error Indicator

Light

When this indicator light is on (but not blinking), it means that the printer is out of paper or

almost out of paper or the printer covers are open. When this light is blinking, there is an

error. If you see this light blinking, turn off the printer for a few seconds and then turn it

back on. If the light is still blinking, call your supervisor or a service person.

Cartridge Indicator

Light (LH/RH)

The right indicator is for the right cartridge and the left indicator for the left cartridge.

If the printer is a single color printer, the left cartridge indicator will be used.

In most cases, the left cartridge is black, and the right is a color.

This indicator light (LH/RH) blinks when the cartridge is almost out of ink and stays on

when the cartridge(s) is removed.

◈Printer Self Testing

• Self test

The self test lets you know if your printer is operating properly. It checks the control circuits,

printer mechanisms, print quality, ROM version, and DIP switch settings.

The test is independent of any other equipment or software, so it is a good idea to run it when you first set up the

printer or if you have any trouble. If the self test works correctly, the problem is in the other equipment or the

software, not the printer.

Running the self test

1) Make sure the printer is turned off and the printer cover is closed properly.

2) While holding down the Feed button, turn on the printer and continue to hold until the paper begins to feed.

The self test prints the printer settings and cuts the paper and pauses. (The power light blinks.)

3) Press the Feed button to continue printing the rolling ASCII pattern. Repeat for the nozzle pattern, receipt pattern

and NV bit image(s).

4) The self test mode terminates after printing NV bit image(s) automatically.

Andere Handbücher für Bixolon SRP-500

Inhaltsverzeichnis

Andere Samsung Drucker Handbücher

Samsung

Samsung 2 COLOR THERMAL PRINTER SRP-275 Bedienungsanleitung

Samsung

Samsung Xpress M2020W Bedienungsanleitung

Samsung

Samsung ML-4500/XAA Bedienungsanleitung

Samsung

Samsung SL-C460FW Bedienungsanleitung

Samsung

Samsung ML-7300 Series Bedienungsanleitung

Samsung

Samsung Multifunction Xpress M207 Series Bedienungsanleitung

Samsung

Samsung 2 COLOR THERMAL PRINTER SRP-275 Bedienungsanleitung

Samsung

Samsung Multifunction ProXpress C267 Series Bedienungsanleitung

Samsung

Samsung CLP-315 - CLP 315 Color Laser Printer Benutzerhandbuch

Samsung

Samsung SCX-4720F Bedienungsanleitung

Samsung

Samsung ML-6060 Betriebsanleitung

Samsung

Samsung CLX-3160 Series Bedienungsanleitung

Samsung

Samsung CLP CLP-550 Bedienungsanleitung

Samsung

Samsung ML-6060 Bedienungsanleitung

Samsung

Samsung SL-M3820DW/XAA Bedienungsanleitung

Samsung

Samsung CLP-310 Benutzerhandbuch

Samsung

Samsung MFP SCX-6345N Bedienungsanleitung

Samsung

Samsung ML 2510 - B/W Laser Printer Bedienungsanleitung

Samsung

Samsung SRP - 770 Bedienungsanleitung

Samsung

Samsung ML-1440 Bedienungsanleitung

Samsung

Samsung ML-2010 - B/W Laser Printer Bedienungsanleitung

Samsung

Samsung ML-166 Series Bedienungsanleitung

Samsung

Samsung ML-2150 Bedienungsanleitung

Samsung

Samsung ML-1610 - B/W Laser Printer Bedienungsanleitung

Beliebte Drucker Handbücher anderer Marken

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Brother

Brother 1440 - HL B/W Laser Printer Kurzanleitung

Fuji Xerox

Fuji Xerox DocuPrint P375 dw Bedienungsanleitung

WOOSIM

WOOSIM PORTI-S30 Bedienungsanleitung

Olivetti

Olivetti PG L2140 Bedienungsanleitung

Konica Minolta

Konica Minolta bizhub 224e Bedienungsanleitung

Canon

Canon LBP113w Bedienungsanleitung

Xerox

Xerox DocuColor 5000 Bedienungsanleitung

Canon

Canon PRO-500 Series Einrichtungshandbuch

Epson

Epson ET-7750 Betriebsanleitung

Lexmark

Lexmark Infoprint 1332 Bedienungsanleitung