Sangean PR-D8 Bedienungsanleitung

Controls

Stereo Built-in Microphone (Left Channel)

LCDDisplay

Stereo Built-in Microphone (Right channel)

Power/Auto Shut Off

TuningDown

Band Selection and Tuning Step

Alarm (Buzzer)

Station Presets

LCDIllumination

Recording

Play Modes

Stop/Folder down

Play/Pause

Volume Control

Timer Recorder Switch (On and Off)

Music/Normal/News Tone Control

Lock Switch

TelescopicAerialAntenna

SD Card Slot

Line-Out Jack

DC-In Jack

Alkaline/Rechargeable Batteries (NiMH/NiCad) Switch

Reset Button

Push to Replace Batteries

LCDDisplay

TuningUp

Time Set and Station Scan

Alarm (Radio)

Timer Recording

Skip/Fast Forward

Menu Button

File Browse

Skip/Fast Rewind

Repeat A–B/Folder Up

Rear Stand

Battery Compartment

Headphone Jack

Aux-In Jack

LCD Display for Radio and Clock

Stereo

Frequency

Sleep and Snooze

AM/PM

Timer Recording (On & Off)

Time Recording (On & Off)

Clock

AlarmBuzzer

Alarm Radio

Time Set

Unit

Battery Power Indicator

Station Presets

Key Lock

FM/AM/MW Band

LCD Symbol for MP3 player

Status

File Format

Play Mode

Play

Pause

Stop

Fast Forward

Fast Rewind

Record

MP3 file

WMA file

Filename

Folder name

Repeat one

Repeat Folder

Repeat All

Random play

Repeat A-B

Volume label or Disk S/N

Folder(File browse)

File(File browse)

Battery Operation using Alkaline Batteries

1. Remove the battery cover on the back of the unit by sliding the

cover to the OPEN direction.

2. Insert 4 x UM-2 (C size) alkaline batteries into the

battery compartment. Make sure the batteries are inserted with

correct polarity as shown inside the battery compartment.

3. Slide the battery switch to theAlkaline position and then replace

the battery cover.

Important:

When using alkaline batteries, the battery switch must be placed in

the alkaline position. Failure to do so could result serious damage

to the batteries or radio.

4. Decreased of power, distortion and “stuttering sound” are signs

that the batteries may need to be replaced.

5. If the radio is not to be used for any extended period of time,

it is recommended that the batteries should be removed

from the radio. For extended listening, we recommend to

use the supplied AC power adapter or otherwise the

rechargeable batteries.

Battery Operation using Rechargeable Batteries

1. Remove the battery cover on the back of the unit by sliding the

cover to the OPEN direction.

2. Insert 4 x UM-2 (C size) rechargeable batteries into the

battery compartment. Make sure all batteries are inserted with

correct polarity as shown inside the battery compartment.

The radio is designed with Nickel-Metal Hydride (NiMH)

rechargeable battery usage.

3. Slide the battery switch to theNiMH/NiCad position and then

replace the battery cover.

4. Insert the suppliedAC power adapter into the DC-In jack on the

left hand side of the radio and plug the adapter into a standard

13A main socket outlet.

5. TheDC jack ring LED flashes indicating that the batteries

are charging. When theDC jack ring stops flashing it should

indicate that the batteries are fully charged.

(Approximate charging time is 8 hours).

Important:

When using rechargeable batteries, the battery switch must be

placed in the NiMH/NiCad position. The radio must be turned off

while charging the batteries. Otherwise, the batteries will not be

charged to its full capacity.

6. Decreased of power, distortion and “stuttering sound” are signs

that the batteries may need to be recharged. Should the battery

power decreases, the low battery power indicator will start

flashing on the LCD display.

7. If the radio is not to be used for any extended period of time,

it is recommended that the batteries are removed from

the radio. For extended listening, we recommend to use

the supplied AC power adapter or otherwise the

rechargeable batteries.

Using the Supplied AC Power Adapter

The supplied AC adapter is 9 Volts DC output 700 mA center

pin positive.

1. Insert theAC power adapter plug into the DC-In jack on the left

hand side of the radio.

2. Plug in the AC power adapter into a standard 13A main

socket outlet.

Whenever the AC power adapter is plugged in to the radio and

to the main AC outlet, the batteries are automatically disabled.

The AC adapter should be disconnected from the main AC outlet,

when the radio is not in used.

Setting the Clock

1. Clock can be set in both ways; radio power must be on or off.

2. The display will show “- : - -“ when the batteries are installed or

when the radio is plugged in to a main AC outlet.

3. Press and hold the time set button until LCD flashes the time

set symbol and also the year digit followed by a beep.

4. Press tuning up/down button to set required year.

5. Follow the above procedure step to set the month, date,

hour and minute.

6. LCD display will stop flashing and will display the real time when

it’s completed.

Operating the Radio

This radio is equipped with three tuning methods- scanning tuning,

manual tuning and preset recall.

Scan Tuning

1. Press the power button to turn the radio on.

2. Select the required waveband by pressing the band button

For FM band fully extend and rotate telescopic aerial antenna to

get the best reception. For AM (MW) band, rotate the radio to

get best signal.

3. Press and release Scan button (press and hold Scan button

more than 2 seconds will activate time setting), the radio will

search up and will stop automatically when it finds a radio

station with good signal. Press the scan button again to pick up

the found station.

The radio will continue to search for the next available stations,

if you do not press scan button again when it finds a

radio station.

4. Rotate the Volume Control to get required sound level.

5. To turn the radio off, press the power button. The display will

show OFF.

Manual Tuning/Station Searching

1. Press the power button to turn the radio on.

2. Select the required waveband by pressing the band button.

Adjust the antenna as described above.

3.A single press on either the tuning up or down button will change

the frequency in the following increments:

FM: 50 or 100 kHz

AM (MW): 9 or 10 kHz

4. Press and hold either the tuning up or down button until the

frequency in the display begins to change rapidly and release

the button. Your radio will search the selected waveband and will

stop automatically when it finds a station with sufficient signal.

5. Rotate the volume control to get the required sound level.

6. To turn the radio off, press the power button. Display will

show OFF.

Storing Stations in Preset Memories

There are 5 memory presets on each waveband.

1. Press the power button to turn the radio on.

2. Tune to a required station using one of the methods

previously described.

3. Press and hold down the required station preset number until the

radio beeps. The preset number will appear in the display and

the station will be stored under chosen preset station.

4. Repeat these procedures for the remaining presets.

5. Stations stored in preset memories can be over written by the

following above procedures.

Recalling Stations from Preset Memories

1. Press the power button to turn on the radio.

2. Select the required waveband.

3. Momentarily press the required preset button, the preset number

and station frequency will appear in the display.

Setting the Radio Alarm

When the radio alarm is selected, the radio will turn on and play the

chosen radio station at the chosen alarm time. The radio alarm will

continue for an hour unless turned off by pressing the power button.

Press the power button while the alarm is activated and will cancel

the alarm for 24 hours.

Radio alarm can be activated only until both radio alarm time and

radio alarm station are set.

Andere Handbücher für PR-D8

Inhaltsverzeichnis

Sprachen:

Andere Sangean Tragbares Radio Handbücher

Sangean

Sangean DT-120CL Bedienungsanleitung

Sangean

Sangean H201 Betriebsanleitung

Sangean

Sangean ATS-505P Bedienungsanleitung

Sangean

Sangean PR-D9W - Bedienungsanleitung

Sangean

Sangean LUNCHBOX Bedienungsanleitung

Sangean

Sangean ATS-606AP Bedienungsanleitung

Sangean

Sangean DPR-32 Bedienungsanleitung

Sangean

Sangean PR-D4VW Bedienungsanleitung

Sangean

Sangean ATS-404 Bedienungsanleitung

Sangean

Sangean PR-D7 Bedienungsanleitung

Sangean

Sangean U4 DBT+ Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean DT-110 Betriebsanleitung

Sangean

Sangean ATS-606A Bedienungsanleitung

Sangean

Sangean ATS-818ACS Bedienungsanleitung

Sangean

Sangean ProTravel PT-50 Bedienungsanleitung

Sangean

Sangean PR-D8 Bedienungsanleitung

Sangean

Sangean ATS-808A Bedienungsanleitung

Sangean

Sangean FATBOX Bedienungsanleitung

Sangean

Sangean TOUGHBOX Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Bedienungsanleitung

Sangean

Sangean DPR-17 Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung