Sangean TOUGHBOX Bedienungsanleitung

中文

Version 1

TOUGHBOX

Read these instructions.

Keep these instructions.

Heed all warnings

Follow all instructions

Do not use this apparatus near water.

Clean only with dry cloth.

Do not block any ventilation openings. Install in accordance

with the instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves or other apparatus (including ampliers) that

produce heat.

Do not defect the safety purpose of the polarized or grounding-

type plug. A polarized plug has two blades with one wider than

the other. A grounding type plug has two blades and a third

grounding prong. The wide blade or the third prong are provid-

ed for your safety. If the provided plug does not t into your out-

let, consult an electrician for replacement of the obsolete outlet

– USA version only.

Protect the power cord from being walked on or pinched par-

ticularly at plug, convenience receptacles, and the point where

they exit from the apparatus

Important Safety Instructions

10.

Only use attachments/accessories specified by the manufac-

turer.

Use only with the cart, stand, tripod, bracket, or table specied

by the manufacturer, or sold with the apparatus. When a cart is

used, use caution when moving the cart/apparatus combination

to avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused

for long periods of time.

Refer all servicing to qualied service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate nor-

mally, or has been dropped.

To reduce the risk of re or electric shock, Do not expose this

appliance to Rain or Moisture.

The Shock Hazard Marking and Associated Graphical Symbol

is provided on the bottom panel of unit.

Apparatus shall not be exposed to dripping or splashing and no

objects lled with liquids, shall be placed on the apparatus.

For outdoors use, to avoid electric shock, use battery only dur-

ing a raining day or the weather is wet.

11.

12.

13.

14.

15.

16.

17.

18.

AUX

Controls

Volume Control

Tuning Control

FM antenna

LCD display

Power On/Off

Band Selection

Preset Stations

Speaker

Battery Compartment

AC power cord storage

Charge LED indicator

Aux In socket

Rechargeable battery (Charger)/Normal battery (Batteries)

Switch

LCD Display

Band Indicator

Frequency

Preset Stations

Low Battery Indicator

Power the radio

1. Installing the batteries, rst turn battery cover xture anti-clockwise

to loosen and pull down the battery cover.

Note:

Before you insert the batteries, if you use non-rechargeable batter-

ies, make sure the Charger/Batteries switch which located inside

the battery compartment is switched to Batteries position.

If you use rechargeable batteries, make sure to switch Charger/

Batteries switch to Charger position.

2. Insert 4 X C size (UM-2) battery into the compartment. Ensure

the battery is inserted in accordance with the diagram shown.

Close the battery cover and fasten the xture by turning clockwise.

If the radio is not to be used for any extended period of time, it is

recommended that the battery is removed from the radio.

Reduced power, distortion and a “ stuttering sound “ or low battery

sign is ashing on the display are all signs that the batteries

need replacing or recharged. (see below charge the batteries)

3. AC Operation

Before plug the AC power cord into the AC socket, be sure the

voltage is correct. If you have batteries in the radio and connect

the AC power cord into the AC socket, the batteries will automatically

be disconnected.

AC power cord storage is designed to store the cord when the ra-

dio is not in use.

Charge the batteries

Reduced power, distortion and a “ stuttering sound “ or low battery

sign is ashing on the display are all signs that the batteries

need recharged if you use rechargeable batteries to power the ra-

dio.

Note:

The radio can be charged only when the radio is off.

Connect the AC power cord into the AC socket to charge the bat-

teries, be sure the battery type switch is set to Charge position.

When radio is charged, the CHARGE LED will be ashing and stop

ashing ( the LED is on ) when the radio is fully charged.

Charging time takes approx. 4-5 hours depending on capacity of

the rechargeable batteries in use.

Manual Tuning

1. Press the Power button to turn on the radio.

2. Select the required waveband by pressing the Band button.

3. Be sure to screw in the rubber FM antenna properly to get best

reception. For AM (MW) band, rotate the radio to get best signal.

4. Rotate the Tuning Control knob will change the frequency in the

following increments

FM: 50 or 100 kHz

AM (MW): 9 or 10 kHz

5. Rotate the Volume Control knob to get required sound level.

6. To turn off the radio, press the Power button. Display will show OFF.

Memory presets stations

Storing stations in preset memories, please follow below step.

There are 5 memory presets for each waveband.

1. Press the Power button to turn on the radio.

2. Tune to required station pressing Band button and Tuning Control.

3. Press and hold down the required preset until the radio beeps.

The preset number will appear in the display and the station will

be stored under chosen preset button.

4. Repeat this procedure for the remaining presets.

5. Stations stored in preset memories can be over written by following

above procedures.

Recall stations from preset memories

1. Press the Power button to turn on the radio.

2. Select the required waveband.

3. Momentarily press the required Preset button, the preset number

and station frequency will appear in the display.

Display backlight

When radio is switched on, press any button except Power button

will illuminate the LCD display for approx. 15 seconds.

Setting tuning step

Tuning step on some countries are different from where you pur-

chase the radio.

1. When the radio is switched off, press and hold BAND button 3

seconds until software version 'FXX' shown on the display. Rotate

the tuning control rotary to highlight the desired frequency range,

as the following:

F00: 76 MHz - 90 MHz

F01: 76 MHz - 108 MHz

F02: 87.5 MHz - 108 MHz

F03: 64 MHz - 108 MHz

Press BAND button to conrm the selection.

2. Then rotate the Tuning control rotary to select 50 kHz or 100 kHz

FM step. Press Band button to conrm the selection.

3. Rotate the Tuning control rotary to select 9 kHz or 10 kHz AM step.

Press Band button to conrm the setting. Then the tuning step

setting is completed.

Clear the preset stations

Whenever is necessary, you can clear all the preset stations.

When radio is off, press Preset Button 5 same time for more than 2

seconds to clear all the preset stations. Radio will be reset to origi-

nal factory set status.

Inhaltsverzeichnis

Andere Sangean Tragbares Radio Handbücher

Sangean

Sangean DT-110 Betriebsanleitung

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Bedienungsanleitung

Sangean

Sangean ATS-505P Bedienungsanleitung

Sangean

Sangean ATS-808A Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean DT-210 Bedienungsanleitung

Sangean

Sangean DT-200V Bedienungsanleitung

Sangean

Sangean ATS-606AP Betriebsanleitung

Sangean

Sangean PR-D14USB Bedienungsanleitung

Sangean

Sangean WFR-27C Bedienungsanleitung

Sangean

Sangean MMR-77 Bedienungsanleitung

Sangean

Sangean SR-2 - DATASHEET 2 Bedienungsanleitung

Sangean

Sangean ATS-505P Bedienungsanleitung

Sangean

Sangean WR-1 Bedienungsanleitung

Sangean

Sangean PR-D15 Bedienungsanleitung

Sangean

Sangean ATS-606AP Bedienungsanleitung

Sangean

Sangean PR-D3L Bedienungsanleitung

Sangean

Sangean PR-D4VW Bedienungsanleitung

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Benutzerhandbuch

Sangean

Sangean FATBOX Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean PR-D5CL Bedienungsanleitung

Sangean

Sangean PR-D17 Bedienungsanleitung

Sangean

Sangean PR-D9W - Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung