Sangean Toughbox TB-100 Bedienungsanleitung

TOUGHBOX

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings

4. Follow all instructions

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with

the instructions.

8. Do not install near any heat sources such as radiators,

heat registers, stoves or other apparatus ( including amplifiers )

that produce heat.

9. Do not defect the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades with one

wider than the other. A grounding type plug has two blades and

a third grounding prong. The wide blade or the third prong are

provided for your safety. If the provided plug does not fit into

your outlet, consult an electrician for replacement of the obsolete

outlet – USA version only.

10. Protect the power cord from being walked on or pinched

particularly at plug, convenience receptacles, and the point

where they exit from the apparatus.

11. Only use attachments/accessories specified by

the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified

by the manufacturer, or sold with the apparatus. When a cart

is used, use caution when moving the cart/apparatus

combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused

for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not

operate normally, or has been dropped.

15. To reduce the risk of fire or electric shock, Do not expose this

appliance to Rain or Moisture.

16. The Shock Hazard Marking and Associated Graphical Symbol is

provided on the bottom panel of unit.

17. Apparatus shall not be exposed to dripping or splashing and no

objects filled with liquids, shall be placed on the apparatus.

18. For outdoors use, to avoid electric shock, use battery only

during a raining day or the weather is wet.

Controls

Volume Control

Tuning Control

FM antenna

LCD display

Power On/Off

Band Selection

Preset Stations

Speaker

Battery Compartment

AC power cord storage

Charge LED indicator

Aux In socket

Rechargeable battery ( Charger ) /

Normal battery ( Batteries ) Switch

LCD Display

Band Indicator

Frequency

Preset Stations

Low Battery Indicator

DGB

Power the radio

1. Installing the batteries, first turn battery cover fixture

anti-clockwise to loosen and pull down the battery cover.

Note:

Before you insert the batteries, if you use non-rechargeable

batteries, make sure the Charger/Batteries switch which located

inside the battery compartment is switched to Batteries position.

If you use rechargeable batteries, make sure to switch

Charger/Batteries switch to Charger position.

2. Insert 4 X C size ( UM-2 ) battery into the compartment.

Ensure the battery is inserted in accordance with the

diagram shown.

Close the battery cover and fasten the fixture by turning clockwise.

If the radio is not to be used for any extended period of time,

it is recommended that the battery is removed from the radio.

Reduced power, distortion and a “ stuttering sound “ or low battery

sign is flashing on the display are all signs that the batteries

need replacing or recharged. ( see below charge the batteries )

3. AC Operation

Before plug the AC power cord into the AC socket, be sure the

voltage is correct. If you have batteries in the radio and connect the

AC power cord into the AC socket, the batteries will automatically

be disconnected.

AC power cord storage is designed to store the cord when the

radio is not in use.

Charge the batteries

Reduced power, distortion and a “ stuttering sound “ or low battery

sign is flashing on the display are all signs that the batteries

need recharged if you use rechargeable batteries to power

the radio.

Note:

The radio can be charged only when the radio is off.

Connect the AC power cord into the AC socket to charge the

batteries, be sure the battery type switch is set to Charge position.

When radio is charged, the CHARGE LED will be flashing and stop

flashing ( the LED is on ) when the radio is fully charged.

Charging time takes approx. 4-5 hours depending on capacity of the

rechargeable batteries in use.

Manual Tuning

1. Press the Power button to turn on the radio.

2. Select the required waveband by pressing the Band button.

3. Be sure to screw in the rubber FM antenna properly to get

best reception. For AM ( MW ) band, rotate the radio to get

best signal.

4. Rotate the Tuning Control knob will change the frequency in the

following increments

FM: 50 or 100 kHz

AM ( MW ): 9 or 10 kHz

5. Rotate the Volume Control knob to get required sound level.

6. To turn off the radio, press the Power button.

Display will show OFF.

Memory presets stations

Storing stations in preset memories, please follow below step.

There are 5 memory presets for each waveband.

1. Press the Power button to turn on the radio.

2. Tune to required station pressing Band button and

Tuning Control.

3. Press and hold down the required preset until the radio beeps.

The preset number will appear in the display and the station will

be stored under chosen preset button.

4. Repeat this procedure for the remaining presets.

5. Stations stored in preset memories can be over written by

following above procedures.

Recall stations from preset memories

1. Press the Power button to turn on the radio.

2. Select the required waveband.

3. Momentarily press the required Preset button, the preset

number and station frequency will appear in the display.

Display backlight

When radio is switched on, press any button except Power button

will illuminate the LCD display for approx. 15 seconds.

Setting tuning step

Tuning step on some countries are different from where you

purchase the radio.

While radio is switched off, long press the Band button for approx.

7 seconds until display flashes current FM tuning step 50 ( kHz ).

Rotate the Tuning Control, you may adjust to 100 ( kHz ).

Press Band button again to confirm the setting.

After FM tuning step is reset, pressing Band button again,

display will show AM and flash 9 ( kHz ). Rotate the Tuning Control,

you may adjust to 10 ( kHz ). Press band button again to confirm

the setting.

Clear the preset stations

Whenever is necessary, you can clear all the preset stations.

When radio is off, press Preset button 1 and Band button at the

same time for more than 2 seconds to clear all the preset stations.

Radio will be reset to original factory set status.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sangean Empfänger Handbücher

Sangean

Sangean HDR-1 Bedienungsanleitung

Sangean

Sangean SR-25 Bedienungsanleitung

Sangean

Sangean WFR-70 Bedienungsanleitung

Sangean

Sangean WR-12 Bedienungsanleitung

Sangean

Sangean U-3 Betriebsanleitung

Sangean

Sangean ProTravel PT10 Bedienungsanleitung

Sangean

Sangean U-1 Bedienungsanleitung

Sangean

Sangean WR-16 Bedienungsanleitung

Sangean

Sangean TRAVELLER 760 DPR-76 Bedienungsanleitung

Sangean

Sangean U-1 Betriebsanleitung

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Bedienungsanleitung

Sangean

Sangean U-3 Bedienungsanleitung

Sangean

Sangean Sangean DT400W Bedienungsanleitung

Sangean

Sangean DT-F1/V Bedienungsanleitung

Sangean

Sangean ProTravel PT-80 Bedienungsanleitung

Sangean

Sangean ATS-909X - WORLD BAND RADIOS Bedienungsanleitung

Sangean

Sangean ATS-405 Bedienungsanleitung

Sangean

Sangean DCR-89+ Bedienungsanleitung

Sangean

Sangean CP-100D Bedienungsanleitung

Sangean

Sangean ATS-818ACS Bedienungsanleitung

Sangean

Sangean WR-1CL Bedienungsanleitung

Sangean

Sangean Sangean DT400W Bedienungsanleitung

Sangean

Sangean DDR-36 Bedienungsanleitung

Sangean

Sangean WFR-32 Bedienungsanleitung

Beliebte Empfänger Handbücher anderer Marken

Garmin

Garmin GA 23 Bedienungsanleitung

Aiphone

Aiphone PS-12F Bedienungsanleitung

IMES

IMES TCS-01CA-PMI Bedienungsanleitung

BWI Eagle

BWI Eagle AIR-EAGLE SR Handbuch

AMIMON

AMIMON AMN12310 WHDI Bedienungsanleitung

Dual

Dual DMCPA79BT Betriebsanleitung

Sound Associates

Sound Associates SA652P Bedienungsanleitung

Sherwood

Sherwood NewCastle R-772 Bedienungsanleitung

Audio

Audio A10-RX Series Bedienungsanleitung

AllSee

AllSee PushShare PSRV1.1 Bedienungsanleitung

DEMAG

DEMAG DRC-DR D2 Bedienungsanleitung

Teleco

Teleco TVRCL868A02 Bedienungsanleitung

Bosch

Bosch RF3222E Bedienungsanleitung

Kramer

Kramer 631R Bedienungsanleitung

Xpress

Xpress xmc10 Bedienungsanleitung

JVC

JVC KD-MR1BTS Bedienungsanleitung

Omega Engineering

Omega Engineering UWTC-REC3 Bedienungsanleitung

e-survey

e-survey E300 Pro Bedienungsanleitung